Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat

The DOI matches its Crossref record; 89 of the 89 references it cites were found in a registry or an index; none of the 41 sources its claims cite is checked for support yet.

Assessing road-watercourse crossing overtopping potential using GIS and remote sensing: a large-scale screening approach

Open access
Amaddii, Michele, Castelli, Fabio, Arrighi, Chiara · 2026 · Natural Hazards

Abstract

Road-watercourse crossings (RWCs), such as bridges, are critical components of transport networks. Flooding poses a major threat to these structures, with overtopping leading to safety hazards and traffic disruptions. This study presents a large-scale screening method using GIS techniques and remotely sensed data to assess the overtopping potential of RWCs. The approach integrates road and hydrographic networks with high-resolution LiDAR-derived DEMs of bare terrain (DTM) and surface (DSM). RWCs create a constriction of the river runoff cross-section, acting as bottlenecks. The method assumes that RWCs with a height difference between the road level (DSM) and river thalweg (DTM) lower than the corresponding cross-section height are more prone to overtopping. RWCs were identified, and their remotely sensed height was calculated by extracting elevation differences (DSM-DTM). Field measurements were conducted to validate the remotely sensed values. A terrain ruggedness index was used to filter noise in the DSM, assuming roads are the smoothest surfaces. Riverbanks were identified using the raster-based Unsupervised approach, and their height from the thalweg was assessed. The method is applied to the Magra River Basin in Italy (970 km²), a flood-prone area. Results showed that for watercourses with Strahler order < 4, the median error between remotely sensed and field measurements height was high (1.2 m, 35%), while for those with a higher order the error was significantly lower (0.5 m, 8%). Among 230 identified bridges, ~ 25% exhibited a high overtopping potential. This approach enables the prioritization of bridges for further hydrologic-hydraulic and traffic disruption modeling, enhancing infrastructure resilience and flood risk management.

Overview

CoChat Summary

TL;DR

The paper develops a GIS/remote-sensing screening method to assess road-watercourse crossing (RWC) overtopping potential at large catchment scale, using LiDAR DTM/DSM and road-network data to compare crossing height with riverbank height. Applied to the 970 km² Magra River Basin in Italy, it identifies 230 bridges for screening and classifies about 25% as having high overtopping potential.

Key findings

  • A total of 2,307 RWCs were identified, with 33 crossings (1.4%) not covered by LiDAR; the overtopping analysis focused on 230 RWCs with Strahler order >3 and TRI <0.5 m.
  • Among these 230 RWCs, 24% had high overtopping potential, 49% medium, and 27% low; most high-potential crossings were on residential roads (47%), while motorways generally showed low overtopping potential.
  • For Strahler order >3, the error between remotely sensed and field-measured crossing height was acceptable (MAE ≈0.5 m, MAPE ≈8%); for Strahler order 2–3, the error was high (MEA ≈1.2 m; MAPE reported as 35% in the abstract/conclusion and ≈26% in the results text).
  • Validation against four bridges from an Italian bridge-damage database was consistent: one low-OP bridge had no reported overtopping, while two medium-OP bridges were overtopped in the 2011 flood; one medium-OP bridge collapsed by lateral erosion without overtopping.

Methods

  • The method uses LiDAR-derived DTM and DSM at 1 m resolution, a DTM-derived hydrographic network (Strahler order ≥2), and OpenStreetMap roads; the case study is the Magra River Basin in northwestern Tuscany, Italy (970 km²).
  • RWCs are identified by intersecting roads and the hydrographic network; remotely sensed crossing height (H_ir) is calculated as DSM–DTM within a buffer, filtered by H_ir <0.3 m and topographic ruggedness index (TRI) thresholds, and validated against field measurements (93 H_if measurements plus 43 false crossings, totaling 136 surveyed for comparison).
  • Riverbanks are identified with a raster-based Unsupervised classification using Profile Curvature and Max Difference from Mean; bank height (H_s) is derived from transects and median bank elevations. Overtopping potential is RWC OP = H_ir − H_s, classified as high, medium, or low using the MAE threshold of ±0.5 m.

Limitations

  • The paper states the approach relies only on height differences between crossing and riverbank, neglecting main channel area, floodplain area and width, channel width, bridge opening width, clogging, upstream flow regulators, and piers; it is not intended to replace hydrodynamic assessment.
  • The paper states the method is unsuitable for minor stream crossings and culverts, and that automatic riverbank detection remains challenging; validation with hydrological-hydraulic data and field bank measurements is left for future work.
  • Evident from the text: LiDAR covered 94% of the basin, 55 RWCs with S >3 were excluded because TRI >0.5 m, 20% of screened RWCs were not classified as bridges in OSM, no field measurements were taken for S8, and LiDAR sheets were from 2008 and 2010.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1007/s11069-025-07907-8

Cites

89 of 89 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Image 1
CC-BY-NC-ND · From the PDF
Image 2
CC-BY-NC-ND · From the PDF
Fig. 3 RWCs obtained intersecting Flow Accumulation (FA) with OSM roads; and field-surveyed RWCs
Fig. 3 RWCs obtained intersecting Flow Accumulation (FA) with OSM roads; and field-surveyed RWCsCC-BY-NC-ND · From the PDF
Image 4
CC-BY-NC-ND · From the PDF
Fig. 5 a Scatter plot of the measured (H if ) and remotely sensed height (H ir ) of RWCs, and related bias and standard deviation (considering the 75th percentile DSM-DTM difference); b Number (%) of RWCs with H ir <0.3 m detected by DSM-DTM difference compared with those detected in the field. c1-h1 and c2-h2 Error trend (m and %, respectively) between H if and H ir for various S. The colour of the lines represents S, while their style (continuous or dashed) represents the difference between H if and H ir obtained by calculating mean, median, and 75th, 90th, and 95th percentiles
Fig. 5 a Scatter plot of the measured (H if ) and remotely sensed height (H ir ) of RWCs, and related bias and standard deviation (considering the 75th percentile DSM-DTM difference); b Number (%) of RWCs with H ir <0.3 m detected by DSM-DTM difference compared with those detected in the field. c1-h1 and c2-h2 Error trend (m and %, respectively) between H if and H ir for various S. The colour of the lines represents S, while their style (continuous or dashed) represents the difference between H if and H ir obtained by calculating mean, median, and 75th, 90th, and 95th percentilesCC-BY-NC-ND · From the PDF
Image 6
CC-BY-NC-ND · From the PDF
Fig. 7 Variation in bank height (H s ) as S changes (coloured boxes) and as the bank considered changes: a Lower height; b Average height; c Higher height. d Watercourses width variation as S changes
Fig. 7 Variation in bank height (H s ) as S changes (coloured boxes) and as the bank considered changes: a Lower height; b Average height; c Higher height. d Watercourses width variation as S changesCC-BY-NC-ND · From the PDF
Image 8
CC-BY-NC-ND · From the PDF
Image 9
CC-BY-NC-ND · From the PDF

Verification

Claims the paper makes

0 Valid · 7 Not valid · 29 Not checked · 119 Own results and interpretations

63 more claims

Create a free account to see all 155 claims and to verify the 37 references still open.

See all claims — free account
  • Probably not a substantial claim. 35
  • It may state two separate claims as one. 65

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

2 of 2

Citations

Cites

Show all 89 references

Research works printed but not linked: 4

  1. Bala SK, Hoque MM, Ahmed SMU (2005) Failure of Bridge due to flood in Bangladesh- a case study. UAP J Civil Environ Eng 1(1):38–44
  2. Ball GH, Hall DJ (1965) ISODATA: A novel method of data analysis and pattern classification. Stanford Research Institute, Menlo Park
  3. Khattak N, Afzal S, Azmat S, Shah A, Shabab ME, Ahmad N (2013) Hydrological and Hydraulic Study of Bridges/Culverts. In International Journal of Advanced Structures and Geotechnical Engineering (Vol. 02, Issue 03)
  4. Riley SJ, DeGloria SD, Elliot R (1999) Index that quantifies topographic heterogeneity. Intermt J Sci 5:23–27

Cited by

See all 3

Metadata

Authors
Amaddii, M., Castelli, F., & Arrighi, C.
Affiliations
University of Florence (IT)
Corresponding author
Amaddii, Michele
Venue
Natural Hazards
Published
2026-02
Volume
122
Issue
3
ISSN
  • 0921-030X (ISSN-L)
  • 1573-0840
OpenAlex
W7127643352
Cited by
3
References
89
Citations by year
2026: 3
FWCI
4.22
Type
journal article
Language
en
Open access
Licence
Locations
  • Natural Hazards (publishedVersion, cc-by-nc-nd)
  • Florence Research (University of Florence) (submittedVersion)
Funders
Ministero dell'Università e della Ricerca (B53D23006770006)
Topics
  • Physical Sciences › Environmental Science › Global and Planetary Change › Flood Risk Assessment and Management
  • Physical Sciences › Earth and Planetary Sciences › Earth-Surface Processes › Hydrology and Sediment Transport Processes
  • Physical Sciences › Environmental Science › Management, Monitoring, Policy and Law › Landslides and related hazards
Keywords
flood risk, LiDAR DEM, thalweg, terrain ruggedness index, Strahler order, infrastructure resilience, flood risk management

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

A language model drew the claims from the paper on 2026-11-19, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-11-19 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Assessing road-watercourse crossing overtopping potential using GIS and remote sensing: a large-scale screening approach. https://app.cochat.ai/papers/10.1007/s11069-025-07907-8
The paper
Amaddii, M., Castelli, F., & Arrighi, C. (2026). Assessing road-watercourse crossing overtopping potential using GIS and remote sensing: a large-scale screening approach. Natural Hazards. https://doi.org/10.1007/s11069-025-07907-8

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.