The DOI matches its Crossref record; 31 of the 31 references it cites were found in a registry or an index.
The Effects of KCl, K2SO4 and K2CO3 on the High Temperature Corrosion of a 304-Type Austenitic Stainless Steel
Open accessAbstract
The oxidation of 304-type (Fe18Cr10Ni) austenitic stainless steel was investigated at 500 and 600 °C in 5% O 2 + 40% H 2 O. Prior to exposure the samples were sprayed with KCl, K 2 CO 3 or K 2 SO 4 , the amount of salt corresponding to 1.35 μmol K + /cm 2 . For reference, salt-free samples were exposed in 5% O 2 + 40% H 2 O and in 5% O 2 (N 2 was used as carrier gas). The oxidized samples were analyzed with SEM/EDX, XRD, IC and FIB. KCl and K 2 CO 3 strongly accelerate the corrosion of 304L while K 2 SO 4 has little influence on the corrosion rate and on the morphology of the corroded surface. KCl and K 2 CO 3 react with the chromium-rich oxide on the sample surface, forming K 2 CrO 4 . The resulting chromium depletion of the protective oxide causes rapid oxidation and the formation of a thick duplex scale consisting of an outer hematite layer and a inner layer made up of FeCrNi spinel-type oxide. The differences in the corrosivity of the three salts are directly connected to their ability to form chromate on the surface and, hence, to the relative stability of the corresponding leaving groups (HCl, CO 2 and SO 3 ).
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Figures







Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“For example, potassium sulphate (K2SO4) and sodium sulphate (Na2SO4) have been reported to cause insignificant damage after high temperature corrosion exposure if the protective oxidation scale of boiler steel remains intact and protective [18, 19].”
From High Temperature Corrosion Resistant and Anti-slagging Coatings for Boilers: A Review (2024) · cites this paper as [18]
Experimental — accuracy not yet measuredThe cited source says what the claim attributes to it.
In the citing paper
“The corrosiveness of the potassium ion was attributed to the formation of potassium chromate(VI) by reaction with the oxide scale.”
From Alkali Induced High Temperature Corrosion of Stainless Steel: The Influence of NaCl, KCl and CaCl2 (2012) · cites this paper as [17]
The cited source says what the claim attributes to it.
In the citing paper
“The reaction depletes the oxide in chromium and destroys its protective properties [17].”
From Alkali Induced High Temperature Corrosion of Stainless Steel: The Influence of NaCl, KCl and CaCl2 (2012) · cites this paper as [17]
The cited source says what the claim attributes to it.
In the citing paper
“Thus, it was shown that K 2 CO 3 is equally corrosive as KCl towards stainless steel 304L at 600 °C.”
From Alkali Induced High Temperature Corrosion of Stainless Steel: The Influence of NaCl, KCl and CaCl2 (2012) · cites this paper as [17]
The cited source says what the claim attributes to it.
In the citing paper
“K 2 CO 3 (s) has previously been shown to induce breakaway corrosion by Cr-depletion of the primarily formed Cr-rich oxide scales [18].”
From The influence of Nickel on the corrosion protection of FeCrNi alloys after breakaway corrosion at 600 °C (2024) · cites this paper as [18]
2 more claims about this paper
Create a free account to see every claim other papers make about this one.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Thermochemical Data of Pure Substances
Barin, I. (1995) · doi:10.1002/9783527619825 · Cited by 4,241
Combustion properties of biomass
Jenkins, B. M., Baxter, L. L., Miles, T. R., & Miles, T. R. (1998) · Fuel Processing Technology · doi:10.1016/s0378-3820(97)00059-3 · Cited by 1,938
The implications of chlorine-associated corrosion on the operation of biomass-fired boilers
Nielsen, H. P., Frandsen, F. J., Dam-Johansen, K., & Baxter, L. L. (2000) · Progress in Energy and Combustion Science · doi:10.1016/s0360-1285(00)00003-4 · Cited by 785
Grabke, H. J., Reese, E., & Spiegel, M. (1995) · Corrosion Science · doi:10.1016/0010-938x(95)00011-8 · Cited by 537
Boiler deposits from firing biomass fuels
Miles, T. R., Miles, T. R., Baxter, L. L., Bryers, R. W., Jenkins, B. M., & Oden, L. L. (1996) · Biomass and Bioenergy · doi:10.1016/0961-9534(95)00067-4 · Cited by 420
Asteman, H., Svensson, J.-E., Norell, M., & Johansson, L.-G. (2000) · Oxidation of Metals · doi:10.1023/a:1004642310974 · Cited by 325
Self-citationAsteman, H., Svensson, J.-E., Johansson, L.-G., & Norell, M. (1999) · Oxidation of Metals · doi:10.1023/a:1018875024306 · Cited by 304
Self-citationAsteman, H., Svensson, J.-E., & Johansson, L.-G. (2002) · Oxidation of Metals · doi:10.1023/a:1014877600235 · Cited by 218
Self-citationKCl Induced Corrosion of a 304-type Austenitic Stainless Steel at 600°C; The Role of Potassium
Pettersson, J., Asteman, H., Svensson, J. E., & Johansson, L. G. (2005) · Oxidation of Metals · doi:10.1007/s11085-005-5704-3 · Cited by 182
Self-citationSulfation of corrosive alkali chlorides by ammonium sulfate in a biomass fired CFB boiler
Broström, M., Kassman, H., Helgesson, A., Berg, M., Andersson, C., Backman, R., & Nordin, A. (2007) · Fuel Processing Technology · doi:10.1016/j.fuproc.2007.06.023 · Cited by 173
Cited by
Ma, W., Wenga, T., Frandsen, F. J., Yan, B., & Chen, G. (2020) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2019.100789 · Cited by 275
Biomass combustion technology development – It is all about chemical details
Hupa, M., Karlström, O., & Vainio, E. (2017) · Proceedings of the Combustion Institute · doi:10.1016/j.proci.2016.06.152 · Cited by 251
Alkali metals association in biomass and their impact on ash melting behaviour
Mlonka-Mędrala, A., Magdziarz, A., Gajek, M., Nowińska, K., & Nowak, W. (2020) · Fuel · doi:10.1016/j.fuel.2019.116421 · Cited by 216
Ash-Related Issues in Fluidized-Bed Combustion of Biomasses: Recent Research Highlights
Hupa, M. (2012) · Energy & Fuels · doi:10.1021/ef201169k · Cited by 195
Antunes, R. A., & de Oliveira, M. C. L. (2013) · Corrosion Science · doi:10.1016/j.corsci.2013.07.013 · Cited by 184
Metadata
- Authors
- Pettersson, J., Folkeson, N., Johansson, L.-G., & Svensson, J.-E.
- Affiliations
- Chalmers University of Technology (SE)
- ORCID
- Svensson, Jan-Erik
- Venue
- Oxidation of Metals
- Published
- 2011-03-11
- Volume
- 76
- Issue
- 1-2
- Pages
- 93-109
- ISSN
- 0030-770X (ISSN-L)
- 1573-4889
- OpenAlex
- W1985276013
- Cited by
- 117
- References
- 30
- Citations by year
- 2026: 3 · 2025: 6 · 2024: 7 · 2023: 12 · 2022: 16 · 2021: 10 · 2020: 4 · 2019: 10 · 2018: 10 · 2017: 5 · 2016: 8 · 2015: 11 · 2014: 8 · 2013: 3 · 2012: 2
- FWCI
- 8.62
- Type
- journal article
- Language
- en
- Open access
- hybrid
- doi.org
- Licence
- cc-by-nc
- Locations
- Oxidation of Metals (publishedVersion, cc-by-nc)
- Chalmers Research (Chalmers University of Technology) (submittedVersion)
- Funders
- Chalmers Tekniska Högskola
- Topics
- Physical Sciences › Materials Science › Surfaces, Coatings and Films › High-Temperature Coating Behaviors
- Physical Sciences › Materials Science › Metals and Alloys › Hydrogen embrittlement and corrosion behaviors in metals
- Physical Sciences › Materials Science › Materials Chemistry › Corrosion Behavior and Inhibition
- Keywords
- high-temperature corrosion, 304L stainless steel, potassium chloride, potassium sulfate, potassium carbonate, chromate formation, chromium depletion, protective oxide scale, hematite
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: The Effects of KCl, K2SO4 and K2CO3 on the High Temperature Corrosion of a 304-Type Austenitic Stainless Steel. https://app.cochat.ai/papers/10.1007/s11085-011-9240-z
- The paper
- Pettersson, J., Folkeson, N., Johansson, L.-G., & Svensson, J.-E. (2011). The Effects of KCl, K2SO4 and K2CO3 on the High Temperature Corrosion of a 304-Type Austenitic Stainless Steel. Oxidation of Metals. https://doi.org/10.1007/s11085-011-9240-z
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.