The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Breakthrough adsorption study of a commercial activated carbon for pre-combustion CO2 capture
Open accessAbstract
In this study a commercial activated carbon (Norit R2030CO2) was assessed as a solid sorbent for precombustion CO2 capture. This technology involves the removal of CO2 from the shifted-syngas prior to the generation of electricity and the production of high-purity clean H2. The CO2 equilibrium adsorption capacity and breakthrough time were evaluated in a flow-through system where the adsorbent was subjected to four consecutive adsorption–desorption cycles. A CO2/H2/N2 gas mixture (20/70/10 vol.% at normal conditions) was employed as the influent gas stream. Response surface methodology (RSM) was used to assess the combined effect of the adsorption CO2 partial pressure and temperature (independent variables) on CO2 capture capacity and breakthrough time (response variables) for the activated carbon. The CO2 partial pressure ranged from 1 to 3 bar within a total pressure range of 5–15 bar and a temperature range of 25–65 °C. No interaction effect between the two independent variables on the responses was found. The CO2 partial pressure was observed to be the most influential variable, with high values leading to an increase in both the CO2 capture capacity and the breakthrough time. However, an increase in the temperature led to a decrease in both response variables. The maximum values of the response variables within the experimental region studied were obtained at 25 °C and under a CO2 partial pressure of 3 bar (15 bar total pressure).
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Advances in CO2 capture technology—The U.S. Department of Energy's Carbon Sequestration Program
Figueroa, J. D., Fout, T., Plasynski, S., McIlvried, H., & Srivastava, R. D. (2008) · International Journal of Greenhouse Gas Control · doi:10.1016/s1750-5836(07)00094-1 · Cited by 2,281
Research works printed but not linked: 28
- Chalmers, 2010, Flexible operation of coal-fired power plant with CO2 capture, IEA—Clean Coal Centre, 49
- Yong, 2002, Adsorption of carbon dioxide at high temperature—a review, Separation and Purification Technology, 26, 195, 10.1016/S1383-5866(01)00165-4 · DOI · Paper page
- Choi, 2009, Adsorbent materials for carbon dioxide capture from large anthropogenic point sources, ChemSusChem, 2, 796, 10.1002/cssc.200900036 · DOI · Paper page
- Ebner, 2009, State-of-the-art adsorption and membrane separation processes for carbon dioxide production from carbon dioxide emitting industries, Separation Science and Technology, 44, 1273, 10.1080/01496390902733314 · DOI · Paper page
- Plaza, 2008, Application of thermogravimetric analysis to the evaluation of aminated solid sorbents for CO2 capture, Journal of Thermal Analysis and Calorimetry, 92, 601, 10.1007/s10973-007-8493-x · DOI · Paper page
- Sjostrom, 2010, Evaluation of solid sorbents as a retrofit technology for CO2 capture, Fuel, 89, 1298, 10.1016/j.fuel.2009.11.019 · DOI · Paper page
- Yang, 2008, Progress in carbon dioxide separation and capture: a review, Journal of Environmental Sciences, 20, 14, 10.1016/S1001-0742(08)60002-9 · DOI · Paper page
- Plaza, 2007, CO2 capture by adsorption with nitrogen enriched carbons, Fuel, 86, 2204, 10.1016/j.fuel.2007.06.001 · DOI · Paper page
- Martin, 2011, Hypercrosslinked organic polymer networks as potential adsorbents for pre-combustion CO2 capture, Journal of Materials Chemistry, 03534c
- Siriwardane, 2001, Adsorption of CO2 on molecular sieves and activated carbon, Energy & Fuels, 15, 279, 10.1021/ef000241s · DOI · Paper page
- Maroto-Valer, 2005, CO2 capture by activated and impregnated anthracites, Fuel Processing Technology, 86, 1487, 10.1016/j.fuproc.2005.01.003 · DOI · Paper page
- Plaza, 2009, Development of low-cost biomass-based adsorbents for postcombustion CO2 capture, Fuel, 88, 2442, 10.1016/j.fuel.2009.02.025 · DOI · Paper page
- Plaza, 2009, Different approaches for the development of low-cost CO2 adsorbents, Journal of Environmental Engineering—ASCE, 135, 426, 10.1061/(ASCE)EE.1943-7870.0000009 · DOI
- Plaza, 2010, Post-combustion CO2 capture with a commercial activated carbon: comparison of different regeneration strategies, Chemical Engineering Journal, 163, 41, 10.1016/j.cej.2010.07.030 · DOI · Paper page
- Pevida, 2009, Templated polymeric materials as adsorbents for the postcombustion capture of CO2, Energy Procedia, 1, 869, 10.1016/j.egypro.2009.01.115 · doi:10.1016/j.egypro.2009.01.115
- Jadhav, 2007, CO2 emission and its mitigation by adsorption on zeolites and activated carbon, Current Science, 92, 724
- Drage, 2009, Development of adsorbent technologies for post-combustion CO2 capture, Energy Procedia, 1, 881, 10.1016/j.egypro.2009.01.117 · DOI
- Drage, 2009, Developing activated carbon adsorbents for pre-combustion CO2 capture, Energy Procedia, 1, 599, 10.1016/j.egypro.2009.01.079 · DOI
- Schell, 2009, Pre-combustion CO2 capture for IGCC plants by an adsorption process, Energy Procedia, 1, 655, 10.1016/j.egypro.2009.01.086 · DOI
- Martín, 2011, Microporous phenol-formaldehyde resin-based adsorbents for pre-combustion CO2 capture, Fuel, 10.1016/j.fuel.2011.01.019 · DOI
- Drage, 2009, Evaluation of activated carbon adsorbents for CO2 capture in gasification, Energy & Fuels, 23, 2790, 10.1021/ef8010614 · DOI · Paper page
- Bezerra, 2008, Response surface methodology (RSM) as a tool for optimization in analytical chemistry, Talanta, 76, 965, 10.1016/j.talanta.2008.05.019 · DOI · Paper page
- Serna-Guerrero, 2010, Influence of regeneration conditions on the cyclic performance of amine-grafted mesoporous silica for CO2 capture: An experimental and statistical study, Chemical Engineering Science, 65, 4166, 10.1016/j.ces.2010.04.029 · DOI
- Mulgundmath, 2010, Optimisation of carbon dioxide recovery from flue gas in a TPSA system, Adsorption, 16, 587, 10.1007/s10450-010-9255-9 · DOI
- Pevida, 2008, Surface modification of activated carbons for CO2 capture, Applied Surface Science, 254, 7165, 10.1016/j.apsusc.2008.05.239 · DOI · Paper page
- Konduru, 2007, Curbing the greenhouse effect by carbon dioxide adsorption with zeolite 13X, AIChE Journal, 53, 3137, 10.1002/aic.11318 · DOI
- Bas, 2007, Modeling and optimization I: usability of response surface methodology, Journal of Food Engineering, 78, 836, 10.1016/j.jfoodeng.2005.11.024 · DOI · Paper page
- Collins, 1967, The LUB/Equilibrium section concept for fixed-bed adsorption, Chemical Engineering Progress Symposium Series, 63, 31
Cited by
Data-driven design of metal–organic frameworks for wet flue gas CO2 capture
Boyd, P. G., Chidambaram, A., García-Díez, E., Ireland, C. P., Daff, T. D., Bounds, R., Gładysiak, A., Schouwink, P., Moosavi, S. M., Maroto-Valer, M. M., et al. (2019) · Nature · doi:10.1038/s41586-019-1798-7 · Cited by 885
Review of recent advances in carbon dioxide separation and capture
Kenarsari, S. D., Yang, D., Jiang, G., Zhang, S., Wang, J., Russell, A. G., Wei, Q., & Fan, M. (2013) · RSC Advances · doi:10.1039/c3ra43965h · Cited by 784
Mohamad Nor, N., Lau, L. C., Lee, K. T., & Mohamed, A. R. (2013) · Journal of Environmental Chemical Engineering · doi:10.1016/j.jece.2013.09.017 · Cited by 478
Review of pre-combustion capture and ionic liquid in carbon capture and storage
Theo, W. L., Lim, J. S., Hashim, H., Mustaffa, A. A., & Ho, W. S. (2016) · Applied Energy · doi:10.1016/j.apenergy.2016.09.103 · Cited by 396
Zhang, X., Zhang, S., Yang, H., Feng, Y., Chen, Y., Wang, X., & Chen, H. (2014) · Chemical Engineering Journal · doi:10.1016/j.cej.2014.07.024 · Cited by 285
Metadata
- Authors
- García, S., Gil, M. V., Martín, C. F., Pis, J. J., Rubiera, F., & Pevida, C.
- Venue
- Chemical Engineering Journal
- Publisher
- Elsevier BV
- Published
- 2011-07
- Volume
- 171
- Issue
- 2
- Pages
- 549-556
- ISSN
- 1385-8947 (ISSN-L)
- OpenAlex
- W2016170823
- Cited by
- 166
- References
- 1
- FWCI
- 17.07
- Type
- journal article
- Language
- en
- Open access
- green
- Licence
- www.elsevier.com/tdm/userlicense/1.0/ (tdm)
- www.elsevier.com/legal/tdmrep-license (tdm)
- Funders
- European Social Fund
- Comisión Sectorial de Investigación Científica
- Ministerio de Ciencia e Innovación (ENE2008-05087)
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Breakthrough adsorption study of a commercial activated carbon for pre-combustion CO2 capture. https://app.cochat.ai/papers/10.1016/j.cej.2011.04.027
- The paper
- García, S., Gil, M. V., Martín, C. F., Pis, J. J., Rubiera, F., & Pevida, C. (2011). Breakthrough adsorption study of a commercial activated carbon for pre-combustion CO2 capture. Chemical Engineering Journal. https://doi.org/10.1016/j.cej.2011.04.027
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.