Alternative regeneration of chemicals employed in mineral carbonation towards technology cost reduction
Open accessThe DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Abstract
Mineral carbonation (MC) using recyclable ammonium salts pH swing processes is considered among the most promising MC techniques to store CO2 permanently. However, the main key challenge to use this process at large scale is related to the energy consumption associated to the regeneration of the employed additives and in particular to the separation of the salt to be regenerated from the water solution. This work investigates the feasibility of a liquid-liquid extraction technique to replace the energy intensive salts/water separation step. Also, the CO2-balance of a 500 MW coal-fired based power plant with an integrated pH swing MC facility was investigated. Different operating conditions were investigated, including temperature, reaction time, pressure, solid to liquid ratio (S/L), reagents concentration and stirring rate. An ammonium sulphate/water separation higher than 90% was achieved at 25 °C, 10 min, 1 bar, 200 g/l S/L ratio, 70% methanol and, 350 rpm. The associated energy consumption was calculated, resulting in an energy saving of 35% in comparison to water evaporation. The process resulted carbon negative when water evaporation was replaced by extraction technique, with 33% of CO2 sequestered by using a S/L ratios of 300 g/l.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A review of mineral carbonation technologies to sequester CO 2
Sanna, A., Uibu, M., Caramanna, G., Kuusik, R., & Maroto-Valer, M. M. (2014) · Chem. Soc. Rev. · doi:10.1039/c4cs00035h · Cited by 1,258
Self-citationPrecipitation in the Mg-carbonate system—effects of temperature and CO2 pressure
Hänchen, M., Prigiobbe, V., Baciocchi, R., & Mazzotti, M. (2008) · Chemical Engineering Science · doi:10.1016/j.ces.2007.09.052 · Cited by 545
Sustainable biomass-based carbon adsorbents for post-combustion CO2 capture
González, A. S., Plaza, M. G., Rubiera, F., & Pevida, C. (2013) · Chemical Engineering Journal · doi:10.1016/j.cej.2013.06.118 · Cited by 280 · cited 1×
“A series of different technologies such as liquid solvents and solid sorbents have been proposed to capture CO2 for geological storage [3,4,5].”
BackgroundEnhancing Mg extraction from lizardite-rich serpentine for CO2 mineral sequestration
Sanna, A., Wang, X., Lacinska, A., Styles, M., Paulson, T., & Maroto-Valer, M. M. (2013) · Minerals Engineering · doi:10.1016/j.mineng.2013.05.018 · Cited by 104 · cited 2×
“Table 10: CO2 experimental capacity according to S/L ratio [9,11] .”
BackgroundSelf-citation
Cited by
Integrated Mineral Carbonation of Ultramafic Mine Deposits—A Review
Li, J., Hitch, M., Power, I., & Pan, Y. (2018) · Minerals · doi:10.3390/min8040147 · Cited by 114
“Pre-treatment can be conducted by thermal [30,31], chemical [32,33], or mechanical means [34–36].”
BackgroundTowards a business case for CO2 mineralisation in the cement industry
Strunge, T., Renforth, P., & Van der Spek, M. (2022) · Communications Earth & Environment · doi:10.1038/s43247-022-00390-0 · Cited by 109
Serpentinite Carbonation Process Routes using Ammonium Sulfate and Integration in Industry
Zevenhoven, R., Slotte, M., Koivisto, E., & Erlund, R. (2017) · Energy Technology · doi:10.1002/ente.201600702 · Cited by 50
Ncongwane, M. S., Broadhurst, J. L., & Petersen, J. (2018) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2018.07.019 · Cited by 47
Sanna, A., Steel, L., & Maroto-Valer, M. M. (2017) · Journal of Environmental Management · doi:10.1016/j.jenvman.2016.12.029 · Cited by 26
Self-citationKoivisto, E., & Zevenhoven, R. (2019) · Entropy · doi:10.3390/e21040395 · Cited by 10
Metadata
- Authors
- Sanna, A., Gaubert, J., & Maroto-Valer, M. M.
- Venue
- Chemical Engineering Journal
- Publisher
- Elsevier BV
- Published
- 2016-12
- Volume
- 306
- Pages
- 1049-1057
- ISSN
- 1385-8947 (ISSN-L)
- OpenAlex
- W2492553032
- Cited by
- 43
- References
- 4
- FWCI
- 3.27
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.