The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Carbonation activated binders from pure calcium silicates: Reaction kinetics and performance controlling factors
Abstract
This paper presents a study on the carbonation activated binders prepared from pure calcium silicate phases, which included tricalcium silicate (3CaO.SiO2, [C3S]), β-dicalcium silicate (β-2CaO.SiO2, [β-C2S]), γ-dicalcium silicate (γ-2CaO.SiO2, [γ-C2S]), tricalcium disilicate (rankinite, 3CaO.2SiO2, [C3S2]), and monocalcium silicate (wollastonite, CaO.SiO2, [CS]). The overall study consisted of three experimental parts, with individual focus on the following issues: (i) reaction kinetics, (ii) mechanical performance at the microscale, and (iii) mechanical performance at the macroscale. Carbonation of calcium silicate phases was found to occur in two distinct stages, namely: phase boundary controlled stage and product layer diffusion controlled stage. Theoretical solid-state reaction approach, including contracting volume model and Jander's equations were used to determine the carbonation rate constants for the calcium silicate phases. Phase boundary controlled stage was found to be dominantly dependent on the type of the starting calcium silicate phases. On the other hand, during the diffusion controlled stage the reaction rate constants were found to depend on the type of carbonation products (in this case Ca-modified silica gel and calcium carbonate). The mechanical properties of the individual microscopic phases were evaluated using nanoindentation test whereas the overall strength of the carbonated paste was evaluated using macroscale three-point bending test. Correlations between the mechanical performances and microstructural characteristics revealed the performance controlling factors of the carbonation activated binders. The higher bound water contents of the carbonated matrix tend to increase the short-term (up to 3 h) creep deformation of the matrix when subjected to constant stress. The presence of a higher proportion of poorly-crystalline forms of calcium carbonates (i.e., vaterite and amorphous calcium carbonate) were observed to increase the flexural strength but decrease the elastic modulus of the carbonated matrix.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Magnesia-based cements: a journey of 150 years, and cements for the future?
Walling, S. A., & Provis, J. L. (2016) · Chemical Reviews · doi:10.1021/acs.chemrev.5b00463 · Cited by 984
Mineral CO 2 Sequestration by Steel Slag Carbonation
Huijgen, W. J. J., Witkamp, G.-J., & Comans, R. N. J. (2005) · Environmental Science & Technology · doi:10.1021/es050795f · Cited by 858
Carbonation of cement-based materials: Challenges and opportunities
Ashraf, W. (2016) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2016.05.080 · Cited by 657
Self-citationFundamental Modeling and Experimental Investigation of Concrete Carbonation
(1991) · ACI Materials Journal · doi:10.14359/1863 · Cited by 598
Carbonation of C–S–H and C–A–S–H samples studied by 13C, 27Al and 29Si MAS NMR spectroscopy
Sevelsted, T. F., & Skibsted, J. (2015) · Cement and Concrete Research · doi:10.1016/j.cemconres.2015.01.019 · Cited by 558
Elucidating the accelerated carbonation products of calcium silicates using multi-technique approach
Ashraf, W., & Olek, J. (2018) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2017.11.003 · Cited by 224
Self-citationCalcium silicate carbonation products
Goto, S., Suenaga, K., Kado, T., & Fukuhara, M. (1995) · Journal of the American Ceramic Society · doi:10.1111/j.1151-2916.1995.tb09057.x · Cited by 217
Stabilization of amorphous calcium carbonate in inorganic silica-rich environments
Kellermeier, M., Melero-García, E., Glaab, F., Klein, R., Drechsler, M., Rachel, R., García-Ruiz, J. M., & Kunz, W. (2010) · Journal of the American Chemical Society · doi:10.1021/ja106959p · Cited by 158
Sun, J., Bertos, M. F., & Simons, S. J. R. (2008) · Energy & Environmental Science · doi:10.1039/b804165m · Cited by 104
Cited by
Recent progress in low-carbon binders
Shi, C., Qu, B., & Provis, J. L. (2019) · Cement and Concrete Research · doi:10.1016/j.cemconres.2019.05.009 · Cited by 714
Effect of temperature on CO2 curing, compressive strength and microstructure of cement paste
Lu, B., Drissi, S., Liu, J., Hu, X., Song, B., & Shi, C. (2022) · Cement and Concrete Research · doi:10.1016/j.cemconres.2022.106827 · Cited by 289
Total recycling of concrete waste using accelerated carbonation: A review
Poon, C. S., Shen, P., Jiang, Y., Ma, Z., & Xuan, D. (2023) · Cement and Concrete Research · doi:10.1016/j.cemconres.2023.107284 · Cited by 271
Mechanisms of carbonation hydration hardening in Portland cements
Zajac, M., Irbe, L., Bullerjahn, F., Hilbig, H., & Ben Haha, M. (2022) · Cement and Concrete Research · doi:10.1016/j.cemconres.2021.106687 · Cited by 262
Li, Y., Liu, W., Xing, F., Wang, S., Tang, L., Lin, S., & Dong, Z. (2020) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2019.10.001 · Cited by 192
Liu, W., Li, Y.-Q., Tang, L.-P., & Dong, Z.-J. (2019) · Materials Today Communications · doi:10.1016/j.mtcomm.2019.05.007 · Cited by 137
Carbonate binders: Historic developments and perspectives
Hu, X., He, P., & Shi, C. (2024) · Cement and Concrete Research · doi:10.1016/j.cemconres.2023.107352 · Cited by 109
Saeki, N., Kurihara, R., Ohkubo, T., Teramoto, A., Suda, Y., Kitagaki, R., & Maruyama, I. (2025) · Cement and Concrete Research · doi:10.1016/j.cemconres.2024.107777 · Cited by 48
Metadata
- Authors
- Ashraf, W., & Olek, J.
- Venue
- Cement and Concrete Composites
- Publisher
- Elsevier BV
- Published
- 2018-10
- Volume
- 93
- Pages
- 85-98
- ISSN
- 0958-9465 (ISSN-L)
- OpenAlex
- W2815271249
- Cited by
- 196
- References
- 9
- FWCI
- 7.86
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.