The DOI matches its Crossref record; 37 of the 37 references it cites were found in a registry or an index.
Review of extractive distillation. Process design, operation, optimization and control
Open accessAbstract
Extractive distillation processes enable the separation of non-ideal mixtures, including minimum or maximum boiling azeotropes and low relative volatility mixtures. Unlike azeotropic distillation, the entrainer fed at another location than the main mixture induces an extractive section within the column. A general feasibility criterion shows that intermediate and light entrainers and heterogeneous entrainers are suitable along common heavy entrainers. Entrainer selection rules rely upon selectivity ratios and residue curve map (rcm) topology including univolatility curves. For each type of entrainer, we define extractive separation classes that summarize feasibility regions, achievable products and entrainer – feed flow rate ratio limits. Case studies are listed as supplementary materials. Depending on the separation class, a direct or an indirect split column configuration will allow to obtain a distillate product or a bottom product, which is usually a saddle point of rcm. Batch and continuous process operations differ mainly by the feasible ranges for the entrainer – feed flow rate ratio and reflux ratio. The batch process is feasible under total reflux and can orient the still path by changing the reflux policy. Optimisation of the extractive process must systematically consider the extractive column along with the entrainer regeneration column that requires energy and may limit the product purity in the extractive column through recycle. For the sake of reducing the energy cost and the total cost, pressure change can be beneficial as it affects volatility, or new process structures can be devised, namely heat integrated extractive distillation, extractive divided wall column or processes with preconcentrator.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Perry's chemical engineers' handbook
(1998) · Choice Reviews Online · doi:10.5860/choice.35-3079 · Cited by 5,897
Conceptual design of distillation systems
Doherty, M. F., & Malone, M. F. (2001) · Cited by 592
Ionic liquids in separations of azeotropic systems – A review
Pereiro, A. B., Araújo, J. M. M., Esperança, J. M. S. S., Marrucho, I. M., & Rebelo, L. P. N. (2012) · The Journal of Chemical Thermodynamics · doi:10.1016/j.jct.2011.05.026 · Cited by 464
Extractive Distillation: A Review
Lei, Z., Li, C., & Chen, B. (2003) · Separation & Purification Reviews · doi:10.1081/spm-120026627 · Cited by 449
Dividing wall columns in chemical process industry: A review on current activities
Yildirim, Ö., Kiss, A. A., & Kenig, E. Y. (2011) · Separation and Purification Technology · doi:10.1016/j.seppur.2011.05.009 · Cited by 420
Enhanced bioethanol dehydration by extractive and azeotropic distillation in dividing-wall columns
Kiss, A. A., & Suszwalak, D. J. P. C. (2012) · Separation and Purification Technology · doi:10.1016/j.seppur.2011.10.022 · Cited by 396
Extractive distillation with ionic liquids: A review
Lei, Z., Dai, C., Zhu, J., & Chen, B. (2014) · AIChE Journal · doi:10.1002/aic.14537 · Cited by 346
Practical Distillation Control
(1992) · Springer eBooks · doi:10.1007/978-1-4757-0277-4 · Cited by 323
Design and Control of Distillation Systems for Separating Azeotropes
Luyben, W. L., & Chien, I. (2010) · Wiley eBooks · doi:10.1002/9780470575802 · Cited by 309
Distillation: Principles and Practices
Stichlmair, J., & Fair, J. R. (1998) · Medical Entomology and Zoology · Cited by 285
Cited by
Detection and Classification of Anomalies in WSN-Enabled Cyber-Physical Systems
Gutierrez-Rojas, D., Kalalas, C., Christou, I., Almeida, G., Eldeeb, E., Bakri, S., Marchetti, N., Sant'Ana, J. M. S., Alcaraz López, O. L., Alves, H., et al. (2025) · IEEE Sensors Journal · doi:10.1109/jsen.2024.3520507 · Cited by 7
Metadata
- Authors
- Gerbaud, V., Rodriguez-Donis, I., Hegely, L., Lang, P., Denes, F., & You, X.
- Venue
- Chemical Engineering Research and Design
- Publisher
- Elsevier BV
- Published
- 2019-01
- Volume
- 141
- Pages
- 229-271
- ISSN
- 0263-8762 (ISSN-L)
- OpenAlex
- W2891167399
- Cited by
- 294
- References
- 37
- FWCI
- 11.95
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Review of extractive distillation. Process design, operation, optimization and control. https://app.cochat.ai/papers/10.1016/j.cherd.2018.09.020
- The paper
- Gerbaud, V., Rodriguez-Donis, I., Hegely, L., Lang, P., Denes, F., & You, X. (2019). Review of extractive distillation. Process design, operation, optimization and control. Chemical Engineering Research and Design. https://doi.org/10.1016/j.cherd.2018.09.020
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.