The DOI matches its Crossref record; 18 of the 18 references it cites were found in a registry or an index.
Pozzolanic reactivity of low grade kaolinitic clays: Influence of calcination temperature and impact of calcination products on OPC hydration
Open accessAbstract
The influence of thermal activation temperature in the pozzolanic reactivity of low grade kaolinitic clay and the impact of calcination products in OPC hydration are assessed in this paper. The raw material, with approximately 40% kaolinite and 40% of 2:1 clay minerals, was calcined to temperatures ranging between 500 and 1000 degrees C. The clay and its calcined products were characterized by XRD, XRF, FTIR, TGA-DTA, Al-27 NMR, PSD and BET. The pozzolanic reactivity of the calcined products and its impact on hydration of blended systems was assessed by compressive strength in mortars with 30% substitution of OPC and heat output from lime-pozzolan pastes. The influence of calcined clays on OPC hydration was characterized by XRD, Al-27 NMR and Si-29 NMR, and Isothermal Calorimetry. The increase of pozzolanic reactivity with the increase of activation temperature is limited not only by recrystallization above 900 degrees C, but also by the decrease of the specific surface that occurs between 800 and 900 degrees C. Highest pozzolanic reactivity is reached when calcined at 800 degrees C, a temperature representing the best compromise between structural disorder of the clay fraction and its specific surface. The impact of calcined clays on the hydration of blended systems is a combination of a filler effect at early ages and the pozzolanic reaction. Calcined clays favor the formation of AFm-type phases and C-A-S-H with longer chains, in which Al is substituting for Si. The experimental results indicate that clays with moderate contents of kaolinite constitute a potential source of high reactivity pozzolanic materials. (C) 2015 Elsevier B.V. All rights reserved.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Supplementary cementitious materials
Lothenbach, B., Scrivener, K., & Hooton, R. D. (2011) · Cement and Concrete Research · doi:10.1016/j.cemconres.2010.12.001 · Cited by 3,406
Self-citationFTIR techniques in clay mineral studies
Madejová, J. (2003) · Vibrational Spectroscopy · doi:10.1016/s0924-2031(02)00065-6 · Cited by 1,992
Sustainable cement production—present and future
Schneider, M., Romer, M., Tschudin, M., & Bolio, H. (2011) · Cement and Concrete Research · doi:10.1016/j.cemconres.2011.03.019 · Cited by 1,643
Traditional and new applications for kaolin, smectite, and palygorskite: a general overview
Murray, H. H. (2000) · Applied Clay Science · doi:10.1016/s0169-1317(00)00016-8 · Cited by 1,396
Fernandez, R., Martirena, F., & Scrivener, K. L. (2011) · Cement and Concrete Research · doi:10.1016/j.cemconres.2010.09.013 · Cited by 1,180
Self-citationHydration of cementitious materials, present and future
Scrivener, K. L., & Nonat, A. (2011) · Cement and Concrete Research · doi:10.1016/j.cemconres.2011.03.026 · Cited by 976
Self-citationHe, C., Osbaeck, B., & Makovicky, E. (1995) · Cement and Concrete Research · doi:10.1016/0008-8846(95)00165-4 · Cited by 503
Instrumental characterization of clay by XRF, XRD and FTIR
Nayak, P. S., & Singh, B. K. (2007) · Bulletin of Materials Science · doi:10.1007/s12034-007-0042-5 · Cited by 490
Andersen, M. D., Jakobsen, H. J., & Skibsted, J. (2003) · Inorganic Chemistry · doi:10.1021/ic020607b · Cited by 434
Cyr, M., Lawrence, P., & Ringot, E. (2006) · Cement and Concrete Research · doi:10.1016/j.cemconres.2005.07.001 · Cited by 364
Aluminum Incorporation in Calcium Silicate Hydrates (C−S−H) Depending on Their Ca/Si Ratio
Faucon, P., Delagrave, A., J. C. Petit, Richet, C., Marchand, J. M., & Zanni, H. (1999) · The Journal of Physical Chemistry B · doi:10.1021/jp990609q · Cited by 258
29Si and 27Al magic-angle-spinning NMR studies of the thermal transformation of kaolinite
Rocha, J., & Klinowski, J. (1990) · Physics and Chemistry of Minerals · doi:10.1007/bf00199671 · Cited by 225
Importance of using the natural pozzolans on concrete durability
Rodriguez-Camacho, R. E., & Uribe-Afif, R. (2002) · Cement and Concrete Research · doi:10.1016/s0008-8846(01)00714-1 · Cited by 190
Todor, D. N. (1976) · Medical Entomology and Zoology · Cited by 175
Maienthal, M. (1977) · Journal of AOAC INTERNATIONAL · doi:10.1093/jaoac/60.6.1442a · Cited by 137
Sintering effects on the development of mechanical properties of fired clay ceramics
Lee, V.-G., & Yeh, T.-H. (2007) · Materials Science and Engineering A · doi:10.1016/j.msea.2007.07.068 · Cited by 107
Maia, A. Á. B., Angélica, R. S., Neves, R. D. F., Pöllmann, H., Straub, C. C., & Saalwächter, K. (2013) · Applied Clay Science · doi:10.1016/j.clay.2013.10.028 · Cited by 85
The United States Bureau of Education
Brown, E. E. (1909) · Science · doi:10.1126/science.30.764.235 · Cited by 21
Cited by
Calcined clay limestone cements (LC3)
Scrivener, K., Martirena, F., Bishnoi, S., & Maity, S. (2018) · Cement and Concrete Research · doi:10.1016/j.cemconres.2017.08.017 · Cited by 1,763
Self-citationEnvironmental impacts and decarbonization strategies in the cement and concrete industries
Habert, G., Miller, S. A., John, V. M., Provis, J. L., Favier, A., Horvath, A., & Scrivener, K. L. (2020) · Nature Reviews Earth & Environment · doi:10.1038/s43017-020-0093-3 · Cited by 1,572
Self-citationSupplementary cementitious materials: New sources, characterization, and performance insights
Juenger, M. C. G., Snellings, R., & Bernal, S. A. (2019) · Cement and Concrete Research · doi:10.1016/j.cemconres.2019.05.008 · Cited by 1,260
Reactivity of supplementary cementitious materials (SCMs) in cement blends
Skibsted, J., & Snellings, R. (2019) · Cement and Concrete Research · doi:10.1016/j.cemconres.2019.105799 · Cited by 984
Avet, F., & Scrivener, K. (2018) · Cement and Concrete Research · doi:10.1016/j.cemconres.2018.02.016 · Cited by 864
Self-citation
Metadata
- Authors
- Alujas, A., Fernández, R., Quintana, R., Scrivener, K. L., & Martirena, F.
- Venue
- Applied Clay Science
- Publisher
- Elsevier BV
- Published
- 2015-05
- Volume
- 108
- Pages
- 94-101
- ISSN
- 0169-1317 (ISSN-L)
- OpenAlex
- W2051725722
- Cited by
- 539
- References
- 18
- FWCI
- 28.62
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.