The DOI matches its Crossref record.
Use of waste plastic materials for road construction in Ghana
Open accessAbstract
This paper forms part of research to solve two main problems in Ghana: firstly, the management of municipal solid waste (MSW), particularly with regards to used plastics which have overwhelmed major cities and towns; secondly, the formation of potholes onroads due to excessive traffic and axle weight. This study examines the effect of blending waste thermoplastic polymers, namely High density polyethylene (HDPE) and Polypropylene (PP) in Conventional AC-20 graded bitumen, at various plastic compositions. The plastics were shredded and blended with the bitumen ‘in-situ’, with a shear mixer at a temperature range of 160 °C–170 °C. Basic rheological parameters such as penetration, ring & ball softening point and viscosity tests were employed to determine the resulting changes from base bitumen.FTIR spectroscopy was also employed to study the chemical functionalities present in the bitumen composite. The properties of the unmodified bitumen were found to be enhanced with the changes recorded in the rheological properties of the polymer modified bitumen (PMB). It was observed that polypropylene polymer, showed profound effect on homogeneity and compatibility with slight linear increment in the viscosity, softening and penetration values as against relatively high changes for HDPE modified bitumen.The viscosity of unmodified bitumen was enhanced with the addition of the polymers and thixotropic effect was observed for both HDPE and PP at 60 °C. For all modified binders prepared, the penetration values decrease as polymer-bitumen ratio increases whiles softening temperature generally increases as polymer ratio increases. The most compatible and incompatible blends for HDPE were respectively observed at 2% and 3% polymer loading. The most enhanced, homogenous blend is achieved with PP at 3% polymer loading. Three prominent peaks were identified in the spectrum of the unmodified bitumen, occurring at the 3000–2850 cm −1 IR frequency range, typical of aliphatic C H symmetrical and asymmetrical stretches in alkanes. CH 2 and CH 3 bends were also observed at the characteristic frequencies of 1465 cm −1 and 1375 cm −1 respectively. A low intensity peak was observed within the 2400 cm −1 –2100 cm −1 range, indicating the presence of a very weak −C C- or −C N group with an absorbance of precisely 0.12.The use of waste commodity plastics in binder modification carries the advantage of a cheap and effective means of enhancing conventional bitumen binder performance characteristics and is an alternative way to utilise plastic waste.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Kumar, R., Verma, A., Shome, A., Sinha, R., Sinha, S., Jha, P. K., Kumar, R., Kumar, P., Shubham, Das, S., et al. (2021) · Sustainability · doi:10.3390/su13179963 · Cited by 1,111
Selvaranjan, K., Navaratnam, S., Rajeev, P., & Ravintherakumaran, N. (2021) · Environmental Challenges · doi:10.1016/j.envc.2021.100039 · Cited by 379
Current approaches to waste polymer utilization and minimization: a review
Okan, M., Aydin, H. M., & Barsbay, M. (2019) · Journal of Chemical Technology & Biotechnology · doi:10.1002/jctb.5778 · Cited by 263
Exploiting recycled plastic waste as an alternative binder for paving blocks production
Agyeman, S., Obeng-Ahenkora, N. K., Assiamah, S., & Twumasi, G. (2019) · Case Studies in Construction Materials · doi:10.1016/j.cscm.2019.e00246 · Cited by 161
Plastic roads: Not all they’re paved up to be
Conlon, K. (2022) · International Journal of Sustainable Development & World Ecology · doi:10.1080/13504509.2021.1915406 · Cited by 22
Metadata
- Authors
- Appiah, J. K., Berko-Boateng, V. N., & Tagbor, T. A.
- Venue
- Case Studies in Construction Materials
- Publisher
- Elsevier BV
- Published
- 2017-06
- Volume
- 6
- Pages
- 1-7
- ISSN
- 2214-5095 (ISSN-L)
- OpenAlex
- W2551931197
- Cited by
- 221
- References
- 0
- FWCI
- 13.59
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Use of waste plastic materials for road construction in Ghana. https://app.cochat.ai/papers/10.1016/j.cscm.2016.11.001
- The paper
- Appiah, J. K., Berko-Boateng, V. N., & Tagbor, T. A. (2017). Use of waste plastic materials for road construction in Ghana. Case Studies in Construction Materials. https://doi.org/10.1016/j.cscm.2016.11.001
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.