The DOI matches its Crossref record.
Potential use of activated carbon derived from Persea species under alkaline conditions for removing cationic dye from wastewaters
Abstract
The use of Persea americana has been studied as an alternative source of activated carbon for the removal of dyes from wastewater. Chemical activation using phosphoric acid was employed for the preparation of the activated carbon (C-PAN). The BET surface area and the total pore volumes were found to be 1593 m2/g and 1.053 cm3/g, respectively. This study investigates the effect of some parameters like, dye concentration, adsorbent dose, contact time and pH for the best comprehension of the adsorption manner. Adsorption kinetic follows pseudo-second order kinetic model. Langmuir and Freundlich isotherms models were used to analyze the adsorption equilibrium data and the best fits to the experimental data were provided by Langmuir model. Maximum adsorption capacity is equal to 400 mg/g of Basic Yellow 28 onto the activated carbon derived from Persea americana. Thermodynamic parameters, such as standard Gibbs free energy (ΔG0), standard enthalpy (ΔH0) and standard entropy (ΔS0) has been calculated. The adsorption process was found to be spontaneous and exothermic process.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
Activated carbon from Persea Americana achieved 98% removal of basic yellow dye from wastewater and can substitute commercially available adsorbents.
“Activated carbon provided from Persea Americana was suggested for basic yellow dye removal from wastewater with 98% removal.This activated carbon can substitute the commercially available adsorbents (Regti et al., 2017).”
From Biomass-Based Adsorbents for Removal of Dyes From Wastewater: A Review (2021) · cites this paper as Regti et al., 2017
Citations
Cites
No references could be resolved yet.
Research works printed but not linked: 61
- Abbasi M., 2008, J. Hazard. Mater., 153, 942, 10.1016/j.jhazmat.2007.09.045 · DOI
- Albero A.S., 2009, Microporous Mesoporous Mater., 120, 62, 10.1016/j.micromeso.2008.10.012 · DOI
- Alipanahpour Dil E., 2017, Ultrason. Sonochem., 34, 677, 10.1016/j.ultsonch.2016.05.013 · DOI
- Asfaram A., 2017, Ultrason. Sonochem., 34, 1, 10.1016/j.ultsonch.2016.05.011 · DOI
- Attia A.A., 2008, Dyes Pigm., 76, 282, 10.1016/j.dyepig.2006.08.039 · DOI
- Attouti S., 2013, Water Res., 47, 3375, 10.1016/j.watres.2013.03.038 · DOI
- Banat I.M., 1996, Bioresour. Technol., 58, 217, 10.1016/S0960-8524(96)00113-7 · DOI · Paper page
- Baughman G., 1988, Environ. Toxicol. Chem., 7, 183, 10.1002/etc.5620070302 · DOI
- Behnajady M.A., 2007, J. Hazard. Mater., 148, 98, 10.1016/j.jhazmat.2007.02.003 · DOI
- Clarke E.A., 1980, The Handbook of Environmental Chemistry. Anthropogenic Compounds, 3, 181, 10.1007/978-3-540-38522-6_7 · DOI
- Deniz F., 2011, Chem. Eng. J., 170, 67, 10.1016/j.cej.2011.03.029 · DOI · Paper page
- El Haddad M., 2012, J. Mater. Environ. Sci., 3, 1019
- El Haddad M., 2013, J. Taiwan. Inst. Chem. Eng., 44, 13, 10.1016/j.jtice.2012.10.003 · DOI
- El Haddad M., 2013, J. Assoc. Arab. Univ. Basic Appl. Sci., 14, 51
- El Haddad M., 2014, J. Taiwan. Inst. Chem. Eng., 45, 533, 10.1016/j.jtice.2013.05.002 · DOI
- El Haddad M., 2014, J. Ind. Eng. Chem., 20, 717, 10.1016/j.jiec.2013.05.038 · DOI
- Faria P.C., 2008, Appl. Surf. Sci., 254, 3497, 10.1016/j.apsusc.2007.11.043 · DOI
- Foo K.Y., 2011, Chem. Eng. J., 173, 385, 10.1016/j.cej.2011.07.073 · DOI
- Garcia-Montano J., 2007, J. Hazard. Mater., 138, 218, 10.1016/j.jhazmat.2006.05.061 · DOI
- Ghaedi M., 2015, Spectrochim. Acta. A, 152, 233, 10.1016/j.saa.2015.06.128 · DOI
- Gupta V.K., 2012, Chem. Eng. J., 180, 81, 10.1016/j.cej.2011.11.006 · DOI
- Gupta V.K., 1997, Waste Manage., 17, 517, 10.1016/S0956-053X(97)10062-9 · DOI
- Gupta V.K., 2011, J. Hazard. Mater., 31, 1062
- Gupta V.K., 2012, RSC Adv., 2, 6380, 10.1039/c2ra20340e · DOI
- Gupta V.K., 2012, Mater. Sci. Eng. C, 32, 12, 10.1016/j.msec.2011.08.018 · DOI
- Gupta V.K., 2013, Adv. Colloid. Interface. Sci., 193, 24, 10.1016/j.cis.2013.03.003 · DOI
- Gupta V.K., 2015, Environ. Eng. Res., 20, 1, 10.4491/eer.2015.018 · DOI
- 10.1080/10643389.2013.876526 · DOI
- Heibati B., 2015, J. Mol. Liq., 208, 99, 10.1016/j.molliq.2015.03.057 · DOI
- 10.1081/SS-120016585 · DOI
- Khormaei M., 2007, J. Hazard. Mater., 149, 269, 10.1016/j.jhazmat.2007.03.074 · DOI
- Liu H., 2012, J. Hazard. Mater., 235, 367, 10.1016/j.jhazmat.2012.08.015 · DOI
- Lorenc-Grabowsk E., 2007, Dyes Pigm., 74, 34, 10.1016/j.dyepig.2006.01.027 · DOI
- Malik P.K., 2003, Sep. Purif. Technol., 31, 241, 10.1016/S1383-5866(02)00200-9 · DOI
- Malik P.K., 2004, Sep. Purif. Technol., 36, 167, 10.1016/S1383-5866(03)00212-0 · DOI
- Mazaheri H., 2016, J. Mol. Liq., 219, 667, 10.1016/j.molliq.2016.03.050 · DOI
- Mittal A., 2009, J. Colloid Interface Sci., 337, 345, 10.1016/j.jcis.2009.05.016 · DOI
- Mittal A., 2009, J. Colloid Interface Sci., 340, 16, 10.1016/j.jcis.2009.08.019 · DOI
- Mittal A., 2010, J. Colloid Interface Sci., 344, 497, 10.1016/j.jcis.2010.01.007 · DOI
- Mittal A., 2010, J. Colloid Interface Sci., 342, 518, 10.1016/j.jcis.2009.10.046 · DOI · Paper page
- Mittal A., 2013, J. Mol. Liq., 179, 133, 10.1016/j.molliq.2012.11.032 · DOI
- Mohd A.A., 2014, Water Resour. Ind., 6, 18, 10.1016/j.wri.2014.06.002 · DOI
- Moussavi G., 2009, J. Hazard. Mater., 168, 806, 10.1016/j.jhazmat.2009.02.097 · DOI
- Njoku V.O., 2014, Chem. Eng. J., 250, 198, 10.1016/j.cej.2014.03.115 · DOI
- Ozcan A., 2007, J. Hazard. Mater., 140, 173, 10.1016/j.jhazmat.2006.06.138 · DOI
- Regti A., 2016, Appl. Surf. Sci., 390, 311, 10.1016/j.apsusc.2016.08.059 · DOI
- 10.1007/s40090-016-0090-z · DOI
- Regti A., 2017, J. Arab. Univ. Basic. Appl. Sci., 24, 1
- Regti A., 2017, Microchem. J., 130, 129, 10.1016/j.microc.2016.08.012 · DOI
- Robinson T., 2001, Bioresour. Technol., 77, 247, 10.1016/S0960-8524(00)00080-8 · DOI · Paper page
- Safa Y., 2011, Desalination, 272, 313, 10.1016/j.desal.2011.01.040 · DOI
- Saleh T.A., 2012, J. Colloid Interface Sci., 371, 101, 10.1016/j.jcis.2011.12.038 · DOI
- Saleh T.A., 2014, Adv. Colloid Interface Sci., 211, 92, 10.1016/j.cis.2014.06.006 · DOI
- Saravanan R., 2014, J. Mol. Liq., 198, 409, 10.1016/j.molliq.2014.07.030 · DOI
- Saravanan R., 2015, J. Mol. Liq., 209, 374, 10.1016/j.molliq.2015.05.040 · DOI
- Saravanan R., 2015, J. Colloid Interface Sci., 452, 126, 10.1016/j.jcis.2015.04.035 · DOI
- Saravanan R., 2016, Mol. Liq. J., 221, 1029, 10.1016/j.molliq.2016.06.074 · DOI
- Slimani R., 2014, J. Taiwan. Inst. Chem. Eng., 45, 1578, 10.1016/j.jtice.2013.10.009 · DOI
- Tawfik A., 2012, Envir. Sci . Poll. Res., 19, 1224, 10.1007/s11356-011-0670-6 · DOI
- Wang Z., 2011, J. Hazard. Mater., 188, 29, 10.1016/j.jhazmat.2011.01.041 · DOI
- Zermane F., 2010, J. Colloid Interface Sci., 350, 315, 10.1016/j.jcis.2010.06.040 · DOI
Cited by
Sorted by citations
Biomass-Based Adsorbents for Removal of Dyes From Wastewater: A Review
Aragaw, T. A., & Bogale, F. M. (2021) · Frontiers in Environmental Science · doi:10.3389/fenvs.2021.764958 · Cited by 360
Metadata
- Authors
- Regti, A., Laamari, M. R., Stiriba, S.-E., & El Haddad, M.
- Affiliations
- Equipe de Chimie Analytique & Environnement, Faculté Poly-disciplinaire, Université Cadi Ayyad, BP 4162, 46000 Safi, Morocco
- Equipe de Chimie Moléculaire, Matériaux et Modélisation, Faculté Poly-disciplinaire, Université Cadi Ayyad, BP 4162, 46000 Safi, Morocco
- Venue
- Journal of the Association of Arab Universities for Basic and Applied Sciences
- Publisher
- Informa UK Limited
- Published
- 2017-10
- Volume
- 24
- Issue
- 1
- Pages
- 10-18
- ISSN
- 1815-3852
- Cited by
- 25
- References
- 0
- Language
- en
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review