The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Adsorption of two antibiotics on biochar prepared in air-containing atmosphere: Influence of biochar porosity and molecular size of antibiotics
Abstract
The porous biochar was prepared by pyrolysis of wood at 600–800 °C in the air-containing atmosphere, so as to enhance the biochar's capacity for adsorption of antibiotics from water. The analytical results obtained from N2 adsorption/desorption indicated that air addition in pyrolysis atmosphere improved significantly the biochar's porosity, especially the development of mesopores. The mesoporous biochars showed high adsorption of antibiotics, and the highest adsorption was observed on the A1/5C800 biochar prepared at the air/gas ratio of 1/5 and heat treatment temperature (HTT) of 800 °C. The adsorption isotherm data were well fitted to the Langmuir model, and the maximum adsorptions (Qm) of tetracycline and sulfadiazine on the A1/5C800 sample are 163 and 261 mg/g respectively, which are 18.8 and 52.8 folds of those on the microporous NC800 biochar prepared at the same HTT but in total nitrogen atmosphere. The outstanding performance of mesoporous biochar was linked to the utilization of more inner pore surface for adsorption, which favors the adsorption of smaller-sized sulfadiazine molecules. While the stronger interactions between tetracycline and biochar contributed to the relatively higher adsorption of tetracycline on the microporous biochar. The mesoporous biochar retained most of the adsorption capacity (>50%) in a wide pH range (3.5–10) and with the co-existence of humic acid (10 mg/L). In general, this research provides a simple and green method to enhance the biochar's efficiency as an adsorbent for remediation of water contaminated by antibiotics.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Dynamic Molecular Structure of Plant Biomass-Derived Black Carbon (Biochar)
Keiluweit, M., Nico, P. S., Johnson, M. G., & Kleber, M. (2010) · Environmental Science & Technology · doi:10.1021/es9031419 · Cited by 3,230
Sustainable biochar to mitigate global climate change
Woolf, D., Amonette, J. E., Street-Perrott, F. A., Lehmann, J., & Joseph, S. (2010) · Nature Communications · doi:10.1038/ncomms1053 · Cited by 2,680
Influence of Pyrolysis Temperature on Biochar Property and Function as a Heavy Metal Sorbent in Soil
Uchimiya, M., Wartelle, L. H., Klasson, K. T., Fortier, C. A., & Lima, I. M. (2011) · Journal of Agricultural and Food Chemistry · doi:10.1021/jf104206c · Cited by 854
Uchimiya, M., Lima, I. M., Thomas Klasson, K., Chang, S., Wartelle, L. H., & Rodgers, J. E. (2010) · Journal of Agricultural and Food Chemistry · doi:10.1021/jf9044217 · Cited by 719
Liu, P., Liu, W.-J., Jiang, H., Chen, J.-J., Li, W.-W., & Yu, H.-Q. (2012) · Bioresource Technology · doi:10.1016/j.biortech.2012.06.085 · Cited by 643
Catechol and Humic Acid Sorption onto a Range of Laboratory-Produced Black Carbons (Biochars)
Kasozi, G. N., Zimmerman, A. R., Nkedi-Kizza, P., & Gao, B. (2010) · Environmental Science & Technology · doi:10.1021/es1014423 · Cited by 509
Enhanced sulfamethazine removal by steam-activated invasive plant-derived biochar
Rajapaksha, A. U., Vithanage, M., Ahmad, M., Seo, D.-C., Cho, J.-S., Lee, S.-E., Lee, S. S., & Ok, Y. S. (2015) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2015.02.046 · Cited by 398 · cited 1×
“The adsorption capacity of sulfadiazine by the three mesoporous biochars (A1/5C800, A1/5C750 and A1/5C700) is much larger than the adsorption of sulfamethazine by tea waste biochars [54], steam-activated plant-derived biochars [55] and H3PO4-activated bamboo-derived biochars [56].”
BackgroundPyrolysis condition affected sulfamethazine sorption by tea waste biochars
Rajapaksha, A. U., Vithanage, M., Zhang, M., Ahmad, M., Mohan, D., Chang, S. X., & Ok, Y. S. (2014) · Bioresource Technology · doi:10.1016/j.biortech.2014.05.029 · Cited by 357
Cited by
Biochar physicochemical properties: pyrolysis temperature and feedstock kind effects
Tomczyk, A., Sokołowska, Z., & Boguta, P. (2020) · Reviews in Environmental Science and Bio/Technology · doi:10.1007/s11157-020-09523-3 · Cited by 2,948
“The sorption efficiency of mesoporous biochar was associated with a higher internal porosity, which promoted the adsorption of smaller-size antibiotic molecules (Li et al. 2019).”
BackgroundInfluentialCarbon based materials: a review of adsorbents for inorganic and organic compounds
Sabzehmeidani, M. M., Mahnaee, S., Ghaedi, M., Heidari, H., & Roy, V. A. L. (2021) · Materials Advances · doi:10.1039/d0ma00087f · Cited by 646
Mangla, D., Annu, Sharma, A., & Ikram, S. (2022) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2021.127946 · Cited by 437
Engineered biochar – A sustainable solution for the removal of antibiotics from water
Krasucka, P., Pan, B., Sik Ok, Y., Mohan, D., Sarkar, B., & Oleszczuk, P. (2021) · Chemical Engineering Journal · doi:10.1016/j.cej.2020.126926 · Cited by 401
Du, L., Ahmad, S., Liu, L., Wang, L., & Tang, J. (2023) · Science of The Total Environment · doi:10.1016/j.scitotenv.2022.159815 · Cited by 298
Metadata
- Authors
- Li, C., Zhu, X., He, H., Fang, Y., Dong, H., Lü, J., Li, J., & Li, Y.
- Venue
- Journal of Molecular Liquids
- Publisher
- Elsevier BV
- Published
- 2019-01
- Volume
- 274
- Pages
- 353-361
- ISSN
- 0167-7322 (ISSN-L)
- OpenAlex
- W2899195985
- Cited by
- 177
- References
- 8
- FWCI
- 5.62
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Adsorption of two antibiotics on biochar prepared in air-containing atmosphere: Influence of biochar porosity and molecular size of antibiotics. https://app.cochat.ai/papers/10.1016/j.molliq.2018.10.142
- The paper
- Li, C., Zhu, X., He, H., Fang, Y., Dong, H., Lü, J., Li, J., & Li, Y. (2019). Adsorption of two antibiotics on biochar prepared in air-containing atmosphere: Influence of biochar porosity and molecular size of antibiotics. Journal of Molecular Liquids. https://doi.org/10.1016/j.molliq.2018.10.142
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.