Low-Temperature Electrochemical Upgrading of Bio-oils Using Polymer Electrolyte Membranes
The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Abstract
While bio-oil-derived fuels hold much promise as a replacement for petroleum, transformation of the highly oxygenated mixture has proven challenging. In particular, bio-oils are reactive and difficult to upgrade through catalytic pyrolysis. To reach a stabilized product capable of deep deoxygenation at elevated pressure and temperature, conversion or separation of reactive groups is required. This paper describes an electrochemical process for stabilization and upgrading of bio-oils prior to hydrotreating at high pressure and temperature. This electrolytic process uses a three-compartment cell designed to hydrogenate reactive carbonyl components while separating small acid molecules, such as acetic and formic acids, which act as catalysts for condensation reactions and consume hydrogen gas to produce low-value gases in hydrotreating. To avoid conductivity issues, electrodes are appended to anion- and cation-exchange membranes. The cell was tested using a mixed acetic acid and formic acid surrogate fed to the cathode compartment, where the decrease in the concentration followed the applied charge to the cell. Experiments performed using pine pyrolysis oil demonstrated a significant reduction in the total acid number (TAN), an increase in pH from 2.6 to over 4, and a modest reduction of the carbonyl concentration. Analysis showed the reduction in TAN was primarily due to removal of carboxylic compounds. Experiments observed a decrease in the reactive carbonyl (aldehydes and ketones) concentration that followed applied charge. The results with the newly devised reactor show promise for the electrochemical route for upgrading bio-oils, but significant improvements in TAN removal and carbonyl conversion are needed. Given the distributed nature of biomass, an electrochemical process paired with pyrolysis could be used to densify and stabilize an oil product near the source. The densified liquid could then be shipped to centralized refineries for final upgrading to fuel and/or chemical products.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Anion-exchange membranes in electrochemical energy systems
Varcoe, J. R., Atanassov, P., Dekel, D. R., Herring, A. M., Hickner, M. A., Kohl, P. A., Kucernak, A. R., Mustain, W. E., Nijmeijer, K., Scott, K., et al. (2014) · Energy Environ. Sci. · doi:10.1039/c4ee01303d · Cited by 2,051
A review of the chemical and physical mechanisms of the storage stability of fast pyrolysis bio-oils
Diebold, J. P. (1999) · doi:10.2172/753818 · Cited by 549
Cited by
Electrocatalytic Hydrogenation of Biomass-Derived Organics: A Review
Akhade, S. A., Singh, N., Gutiérrez, O. Y., Lopez-Ruiz, J., Wang, H., Holladay, J. D., Liu, Y., Karkamkar, A., Weber, R. S., Padmaperuma, A. B., et al. (2020) · Chemical Reviews · doi:10.1021/acs.chemrev.0c00158 · Cited by 440
Self-citationEvolution of Aromatic Structures during the Low-Temperature Electrochemical Upgrading of Bio-oil
Deng, W., Xu, K., Xiong, Z., Chaiwat, W., Wang, X., Su, S., Hu, S., Qiu, J., Wang, Y., & Xiang, J. (2019) · Energy & Fuels · doi:10.1021/acs.energyfuels.9b03099 · Cited by 180
Gupta, S., Mondal, P., Borugadda, V. B., & Dalai, A. K. (2021) · Environmental Technology & Innovation · doi:10.1016/j.eti.2020.101276 · Cited by 113
Upgrading of Bio-Oil Model Compounds and Bio-Crude into Biofuel by Electrocatalysis: A Review
Chen, G., Liang, L., Li, N., Lu, X., Yan, B., & Cheng, Z. (2021) · ChemSusChem · doi:10.1002/cssc.202002063 · Cited by 48
Metadata
- Authors
- Lister, T. E., Diaz, L. A., Lilga, M. A., Padmaperuma, A. B., Lin, Y., Palakkal, V. M., & Arges, C. G.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2018-04-09
- Volume
- 32
- Issue
- 5
- Pages
- 5944-5950
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2797171420
- Cited by
- 54
- References
- 2
- FWCI
- 2.83
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Low-Temperature Electrochemical Upgrading of Bio-oils Using Polymer Electrolyte Membranes. https://app.cochat.ai/papers/10.1021/acs.energyfuels.8b00134
- The paper
- Lister, T. E., Diaz, L. A., Lilga, M. A., Padmaperuma, A. B., Lin, Y., Palakkal, V. M., & Arges, C. G. (2018). Low-Temperature Electrochemical Upgrading of Bio-oils Using Polymer Electrolyte Membranes. Energy & Fuels. https://doi.org/10.1021/acs.energyfuels.8b00134
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.