CoChat

Bimetallic (Co/Ni) MOF-Derived CoNiP Hierarchically Porous Carbon Monolithic Aerogel for the Hydrolysis of Ammonia Borane

Yue, Zhengchu, Cheng, Yanran, Jiang, Qi, Bai, Xueyun, Fang, Xiaolong, Zhao, Xinyu, Yao, Yao, Dong, Didi, Che, Yuanyuan, Chang, Ganggang · 2024 · Industrial & Engineering Chemistry Research

The DOI matches its Crossref record; 75 of the 75 references it cites were found in a registry or an index; none of the 21 sources its claims cite is checked for support yet.

Abstract

As a safe and efficient hydrogen storage material, ammonia borane (NH 3 –BH 3, AB) shows great promise in the era of clean energy advocated by hydrogen. Thus, it is imperative to focus on the exploitation of high-performance heterogeneous catalytic systems for the effective utilization of hydrogen energy stored in AB. However, noble metal catalysts as high-efficiency systems suffer from high expenditure, and the traditional powder-based catalyst faces poor processability and recoverability. Herein, a bimetallic (Co/Ni) MOF-derived CoNiP/hierarchically porous carbon (HPC) monolithic aerogel was successfully prepared by the gelation–carbonization–phosphorization method and applied in the hydrolysis of AB. The ultrasmall transition bimetallic phosphide CoNiP nanoparticles were uniformly fabricated in the hierarchically porous aerogel after pyrolysis. Benefiting from the rapid mass transfer and high exposure of well-defined CoNiP-active species within the hierarchical aerogel support, the Co 0.3 Ni 0.7 P/HPC aerogel performed high hydrogen evolution activity and exhibited fast hydrogen generation rate with a completion time of 2 min under mild conditions. The theoretical calculations reveal the key effects of the adsorption energies between AB and water on CoNiP-active sites in the Co 0.3 Ni 0.7 P/HPC aerogel. Furthermore, the Co 0.3 Ni 0.7 P/HPC monolithic aerogel catalyst can be effortlessly separated and recycled at least 10 times without a remarkable loss of activity. The controllable design of P -doped bimetallic species in the porous aerogel herein should serve as the foundation for the preparation of practical functional monolithic applied catalysts for the hydrolysis of AB.

Overview

CoChat Summary

TL;DR

A bimetallic (Co/Ni) MOF-derived CoNiP/hierarchically porous carbon (HPC) monolithic aerogel was prepared by gelation–carbonization–phosphorization and applied to ammonia borane (AB) hydrolysis. The optimized Co0.3Ni0.7P/HPC aerogel completed hydrogen generation in 2 min under mild conditions and retained activity over 10 cycles.

Key findings

  • The Co0.3Ni0.7P/HPC aerogel gave the fastest hydrogen evolution among the CoxNi1−xP/HPC series, with a completion time of 2 min at 25 °C, whereas CoP/HPC took longer than 20 min.
  • Activation energy (Ea) for the Co0.3Ni0.7P/HPC aerogel was 24.73 kJ·mol−1, lower than the Co0.3Ni0.7P/HPC powder (25.27 kJ·mol−1) and the Co0.3Ni0.7/HPC aerogel (32.48 kJ·mol−1).
  • The monolithic aerogel outperformed its powder counterpart in catalytic kinetics, and the aerogel had the highest TOF among the compared catalysts.
  • The monolithic catalyst was separated and recycled at least 10 times with largely maintained activity; ICP showed a metal ion leaching rate of 0.46% after 10 runs, and SEM/XRD/N2 sorption indicated retained structural integrity.
  • DFT showed NH3−BH3 adsorption energy of −0.22 eV on CoNiP vs −0.05 eV on CoNi, and H2O adsorption of −0.09 eV on CoNiP vs −0.02 eV on CoNi, supporting stronger adsorption on the phosphide sites.

Methods

  • Synthesis: CoxNi1−x-BTC (x = 0, 0.1, 0.3, 0.5, 0.7, 1) precursors from Co(NO3)2·6H2O, Ni(NO3)2·6H2O and H3BTC in DMF; gelation with ethanol/water and freeze-drying to form aerogel; carbonization at 400 °C for 3 h under Ar; phosphorization at 350 °C for 3 h with NaH2PO2.
  • Catalytic tests: 10 mg catalyst in 7.0 mL deionized water with 1 mL AB aqueous solution (1 mmol), 25 °C, gas volume measured by burette; temperature-varied runs used to obtain Ea; 10 consecutive recycles.
  • Characterization: FESEM, TEM/HRTEM, EDS mapping, XRD, XPS, ICP-AES, N2 adsorption/desorption at 77 K; DFT (Materials Studio 2020, Forcite/Adsorption Locator, universal force field) for adsorption energies of AB and water on CoNi and CoNiP surfaces.

Limitations

  • Not stated in the paper: the authors do not include an explicit limitations section.
  • Evident from the text: the BET surface area of the Co0.3Ni0.7P/HPC aerogel (51.2 m2·g−1) declined relative to Co0.3Ni0.7/HPC (52.7 m2·g−1), which the authors attribute to possible structural collapse during phosphorization.
  • Evident from the text: the reported TOF is described as "moderate" relative to other reported catalysts, and the DFT adsorption-energy calculations use a universal force field rather than a higher-level electronic-structure method.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1021/acs.iecr.4c02523

Cites

75 of 75 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Verification

Claims the paper makes

0 Valid · 0 Not valid · 6 Not checked · 25 Own results and interpretations

20 more claims

Create a free account to see all 31 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 5
  • The quote only partly states this claim. 1
  • Probably not a substantial claim. 1

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

1 of 1

Citations

Cites

Show all 75 references

Research works printed but not linked: 3

  1. Du, X.; Yang, C.; Zeng, X.; Wu, T.; Zhou, Y.; Cai, P.; Cheng, G.; Luo, W. Amorphous NiP supported on rGO for superior hydrogen generation from hydrolysis of ammonia borane. Int. J. Hydrogen Energy 2017, 42 (20), 14181−14187. · doi:10.1016/j.ijhydene.2017.04.052.1016/j.ijhydene.2017.04.052
  2. Yang, C.; Men, Y.; Xu, Y.; Liang, L.; Cai, P.; Luo, W. In situ synthesis of NiCoP nanoparticles supported on reduced graphene oxide for the catalytic hydrolysis of ammonia borane. ChemPlusChem 2019, 84, 382−386. · DOI · Paper page
  3. Ma, X.; He, Y.; Zhang, D.; Chen, M.; Ke, S.; Yin, Y.; Chang, G. Cobalt-based MOF-derived CoP/hierarchical porous carbon (HPC) composites as robust catalyst for efficient dehydrogenation of ammonia-borane. ChemistrySelect 2020, 5, 2190−2196. · DOI

Cited by

See all 6

Metadata

Authors
Yue, Z., Cheng, Y., Jiang, Q., Bai, X., Fang, X., Zhao, X., Yao, Y., Dong, D., Che, Y., & Chang, G.
Affiliations
Wuhan University of Technology (CN)
Corresponding author
  • Zhao, Xinyu
  • Chang, Ganggang
Venue
Industrial & Engineering Chemistry Research
Published
2024-11-14
Volume
63
Issue
47
Pages
20510-20519
ISSN
  • 0888-5885 (ISSN-L)
  • 1520-5045
OpenAlex
W4404341851
Cited by
6
References
68
Citations by year
2026: 3 · 2025: 3
FWCI
0.59
Type
journal article
Language
en
Open access
closed
Locations
Industrial & Engineering Chemistry Research (publishedVersion)
Funders
  • National Key Research and Development Program of China (2022YFB3806800)
  • Deutsche Forschungsgemeinschaft
  • National Natural Science Foundation of China
  • Hubei Province Key Research and Development Program (2023BAB101)
  • Young Top-Notch Talent Cultivation Program of Hubei Province
Topics
  • Physical Sciences › Materials Science › Materials Chemistry › Hydrogen Storage and Materials
  • Physical Sciences › Chemical Engineering › Catalysis › Ammonia Synthesis and Nitrogen Reduction
  • Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
Keywords
ammonia borane, ammonia borane hydrolysis, hydrogen storage, hydrogen evolution reaction, metal-organic framework derived materials, hierarchical porous carbon, monolithic aerogels, phosphorization, catalyst reusability, transition metal phosphides

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

A language model drew the claims from the paper on 2026-10-11, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-11 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.