Particle Size Effect on Platinum Dissolution: Considerations for Accelerated Stability Testing of Fuel Cell Catalysts
The DOI matches its Crossref record; 79 of the 79 references it cites were found in a registry or an index.
Abstract
Polymer electrolyte membrane fuel cells (PEMFCs) are highly attractive for use in electric vehicles. In PEMFCs, small particle sizes of the Pt catalyst are required to increase Pt utilization, which lower costs and also increase Pt dispersion, which itself minimizes O 2 mass transport losses. Reducing the particle size improves both the utilization and dispersion; however, stability of small particle sizes is an issue. Pt dissolution, as one of the major degradation mechanisms of PEMFC catalyst layers, is predicted to depend on the particle size. The particle size cannot be independently varied from loading in commercial Pt/C materials that have been used in numerous studies employing accelerated stability tests (ASTs). Therefore, in the study presented here, the Pt particle diameter was varied from 2 to 10 nm by depositing mass-selected nanoparticles on a flat glassy carbon substrate using magnetron sputtering. This allows exclusive control over particle density (interparticle distance) and particle size, which becomes difficult even with advanced synthetic techniques for applied Pt/C materials. Additionally, effects of the 3D porous support are eliminated. These model systems were subjected to an aggressive AST in order to cause significant Pt dissolution, which was monitored online using the scanning flow cell coupled to an inductively coupled plasma mass spectrometer. The results uncover a previously overlooked phenomenon: two competing trends in dissolution from (1) particle passivation caused by particle size-dependent shifts on oxophilicity and (2) electrochemically active surface area. Therefore, crucial impacts of the particle size on degradation may be overlooked in a variety of electrochemical studies, which compare catalytic materials. Finally, suggestions are given for improved ASTs for dissolution, which provide insights into the intrinsic stability of Pt nanoparticles toward dissolution.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“which is regarded as more stable under fuel cell and AST conditions.42,43”
From Effect of Solvent Ratio (Ethylene Glycol/Water) in the Synthesis of Pt/C Cathode Catalysts on PEM Fuel Cell Performance (2024) · cites this paper as [42]
Citations
Cites
Gasteiger, H. A., Kocha, S. S., Sompalli, B., & Wagner, F. T. (2005) · Applied Catalysis B: Environmental · doi:10.1016/j.apcatb.2004.06.021 · Cited by 4,876
Scientific Aspects of Polymer Electrolyte Fuel Cell Durability and Degradation
Borup, R., Meyers, J., Pivovar, B., Kim, Y. S., Mukundan, R., Garland, N., Myers, D., Wilson, M., Garzon, F., Wood, D., et al. (2007) · Chemical Reviews · doi:10.1021/cr050182l · Cited by 3,402
Highly Crystalline Multimetallic Nanoframes with Three-Dimensional Electrocatalytic Surfaces
Chen, C., Kang, Y., Huo, Z., Zhu, Z., Huang, W., Xin, H. L., Snyder, J. D., Li, D., Herron, J. A., Mavrikakis, M., et al. (2014) · Science · doi:10.1126/science.1249061 · Cited by 2,765
Biaxially strained PtPb/Pt core/shell nanoplate boosts oxygen reduction catalysis
Bu, L., Zhang, N., Guo, S., Zhang, X., Li, J., Yao, J., Wu, T., Lu, G., Ma, J.-Y., Su, D., et al. (2016) · Science · doi:10.1126/science.aah6133 · Cited by 1,642
Ultrafine jagged platinum nanowires enable ultrahigh mass activity for the oxygen reduction reaction
Li, M., Zhao, Z., Cheng, T., Fortunelli, A., Chen, C.-Y., Yu, R., Zhang, Q., Gu, L., Merinov, B. V., Lin, Z., et al. (2016) · Science · doi:10.1126/science.aaf9050 · Cited by 1,605
Kongkanand, A., & Mathias, M. F. (2016) · The Journal of Physical Chemistry Letters · doi:10.1021/acs.jpclett.6b00216 · Cited by 1,202
Global lithium resources: relative importance of pegmatite, brine and other deposits
Kesler, S. E., Gruber, P. W., Medina, P. A., Keoleian, G. A., Everson, M. P., & Wallington, T. J. (2012) · Ore Geology Reviews · doi:10.1016/j.oregeorev.2012.05.006 · Cited by 1,140
Shao, M., Peles, A., & Shoemaker, K. (2011) · Nano Letters · doi:10.1021/nl2017459 · Cited by 878
Toyota MIRAI Fuel Cell Vehicle and Progress Toward a Future Hydrogen Society
Yoshida, T., & Kojima, K. (2015) · Interface magazine · doi:10.1149/2.f03152if · Cited by 690
Mayrhofer, K. J. J., Blizanac, B. B., Arenz, M., Stamenkovic, V. R., Ross, P. N., & Markovic, N. M. (2005) · The Journal of Physical Chemistry B · doi:10.1021/jp051735z · Cited by 664
Research works printed but not linked: 6
- Yang Y., 2015, PEM Fuel Cell System Manufacturing Cost Analysis for Automotive Applications
- 10.1021/acscatal.8b00694 · DOI · Paper page
- DOE, 2013, U.S. DRIVE Fuel Cell Tech Team Cell Component Accelerated Stress Test and Polarization Curve Protocols for PEM Fuel Cells
- DOE, 2010, USCAR Fuel Cell Tech Team Cell Component Accelerated Stress Test Protocols for PEM Fuel Cells
- DOE, 2007, DOE Cell Component Accelerated Stress Test Protocols for PEM Fuel Cells
- Myers D. J., 2010, 2010 Annual Progress Report-Polymer Electrolyte Fuel Cell Lifetime Limitations: The Role of Electrocatalysts Degradation
Cited by
Suter, T. A. M., Smith, K., Hack, J., Rasha, L., Rana, Z., Angel, G. M. A., Shearing, P. R., Miller, T. S., & Brett, D. J. L. (2021) · Advanced Energy Materials · doi:10.1002/aenm.202101025 · Cited by 245
Magnetron sputtering enabled sustainable synthesis of nanomaterials for energy electrocatalysis
Liang, J., Liu, Q., Li, T., Luo, Y., Lu, S., Shi, X., Zhang, F., Asiri, A. M., & Sun, X. (2021) · Green Chemistry · doi:10.1039/d0gc03994b · Cited by 198
Fe–N–C Boosts the Stability of Supported Platinum Nanoparticles for Fuel Cells
Xiao, F., Wang, Y., Xu, G.-L., Yang, F., Zhu, S., Sun, C.-J., Cui, Y., Xu, Z., Zhao, Q., Jang, J., et al. (2022) · Journal of the American Chemical Society · doi:10.1021/jacs.2c08305 · Cited by 185
Isolated Ni Atoms Enable Near-Unity CH4 Selectivity for Photothermal CO2 Hydrogenation
Raziq, F., Feng, C., Hu, M., Zuo, S., Rahman, M. Z., Yan, Y., Li, Q.-H., Gascon, J., & Zhang, H. (2024) · Journal of the American Chemical Society · doi:10.1021/jacs.4c05873 · Cited by 169
Surface engineering for stable electrocatalysis
Do, V.-H., & Lee, J.-M. (2024) · Chemical Society Reviews · doi:10.1039/d3cs00292f · Cited by 167
Metadata
- Authors
- Sandbeck, D. J. S., Secher, N. M., Speck, F. D., Sørensen, J. E., Kibsgaard, J., Chorkendorff, I., & Cherevko, S.
- Affiliations
- Forschungszentrum Jülich (DE)
- Technical University of Denmark (DK)
- Corresponding author
- Sandbeck, Daniel J. S.
- Cherevko, Serhiy
- ORCID
- Venue
- ACS Catalysis
- Publisher
- American Chemical Society (ACS)
- Published
- 2020-05-06
- Volume
- 10
- Issue
- 11
- Pages
- 6281-6290
- ISSN
- 2155-5435 (ISSN-L)
- OpenAlex
- W3021937722
- Cited by
- 121
- References
- 79
- Citations by year
- 2026: 15 · 2025: 20 · 2024: 25 · 2023: 21 · 2022: 13 · 2021: 21 · 2020: 6
- FWCI
- 5.23
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- Locations
- ACS Catalysis (publishedVersion)
- Technical University of Denmark, DTU Orbit (Technical University of Denmark, DTU) (submittedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Fuel Cells and Related Materials
- Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
- Physical Sciences › Materials Science › Materials Chemistry › Catalytic Processes in Materials Science
- Keywords
- platinum dissolution, platinum nanoparticles, particle size effects, proton exchange membrane fuel cells, accelerated stability testing, Pt/C catalyst, magnetron sputtering, oxophilicity, electrochemically active surface area, catalyst deactivation, platinum dispersion
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Particle Size Effect on Platinum Dissolution: Considerations for Accelerated Stability Testing of Fuel Cell Catalysts. https://app.cochat.ai/papers/10.1021/acscatal.0c00779
- The paper
- Sandbeck, D. J. S., Secher, N. M., Speck, F. D., Sørensen, J. E., Kibsgaard, J., Chorkendorff, I., & Cherevko, S. (2020). Particle Size Effect on Platinum Dissolution: Considerations for Accelerated Stability Testing of Fuel Cell Catalysts. ACS Catalysis. https://doi.org/10.1021/acscatal.0c00779
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.