The DOI matches its Crossref record; 32 of the 32 references it cites were found in a registry or an index.
Cellulose Nanofiber Orientation in Nanopaper and Nanocomposites by Cold Drawing
Abstract
To exploit the mechanical potential of native cellulose fibrils, we report on the preparation of nanopaper with preferred orientation of nanofibrillated cellulose (TEMPO-NFC) by cold drawing. The preparation route is papermaking-like and includes vacuum filtering of a TEMPO-oxidated NFC water dispersion, drawing in wet state and drying. The orientation of the fibrils in the nanopaper was assessed by AFM and wide-angle X-ray diffraction analysis, and the effect on mechanical properties of the resulting nanopaper structure was investigated by tensile tests. At high draw ratio, the degree of orientation is as high as 82 and 89% in-the-plane and cross-sectional planes of the nanopaper, respectively, and the Young's modulus is 33 GPa. This is much higher than mechanical properties of isotropic nanopaper. The cold drawing method can be also applied to NFC nanocomposites as demonstrated by preparation of TEMPO-NFC/hydroxyethyl cellulose (HEC) nanocomposites. The introduction of the soft HEC matrix allows further tailoring of the mechanical properties.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Cellulose nanofibers prepared by TEMPO-mediated oxidation of native cellulose
Saito, T., Kimura, S., Nishiyama, Y., & Isogai, A. (2007) · Biomacromolecules · doi:10.1021/bm0703970 · Cited by 2,493
Pääkkö, M., Ankerfors, M., Kosonen, H., Nykänen, A., Ahola, S., Österberg, M., Ruokolainen, J., Laine, J., Larsson, P. T., Ikkala, O., et al. (2007) · Biomacromolecules · doi:10.1021/bm061215p · Cited by 1,962
Saito, T., Nishiyama, Y., Putaux, J.-L., Vignon, M., & Isogai, A. (2006) · Biomacromolecules · doi:10.1021/bm060154s · Cited by 1,796
Cellulose Nanopaper Structures of High Toughness
Henriksson, M., Berglund, L. A., Isaksson, P., Lindström, T., & Nishino, T. (2008) · Biomacromolecules · doi:10.1021/bm800038n · Cited by 1,299
Self-citationHelicoidal self-ordering of cellulose microfibrils in aqueous suspension
Revol, J.-F., Bradford, H., Giasson, J., Marchessault, R. H., & Gray, D. G. (1992) · International Journal of Biological Macromolecules · doi:10.1016/s0141-8130(05)80008-x · Cited by 1,250
Henriksson, M., Henriksson, G., Berglund, L. A., & Lindström, T. (2007) · European Polymer Journal · doi:10.1016/j.eurpolymj.2007.05.038 · Cited by 1,183
Self-citationOptically Transparent Nanofiber Paper
Nogi, M., Iwamoto, S., Nakagaito, A. N., & Yano, H. (2009) · Advanced Materials · doi:10.1002/adma.200803174 · Cited by 1,074
Optically Transparent Composites Reinforced with Networks of Bacterial Nanofibers
Yano, H., Sugiyama, J., Nakagaito, A. N., Nogi, M., Matsuura, T., Hikita, M., & Handa, K. (2005) · Advanced Materials · doi:10.1002/adma.200400597 · Cited by 975
Chen, W., Yu, H., Liu, Y., Chen, P., Zhang, M., & Hai, Y. (2011) · Carbohydrate Polymers · doi:10.1016/j.carbpol.2010.10.040 · Cited by 971
Olsson, R. T., Azizi Samir, M. A. S., Salazar-Alvarez, G., Belova, L., Ström, V., Berglund, L. A., Ikkala, O., Nogués, J., & Gedde, U. W. (2010) · Nature Nanotechnology · doi:10.1038/nnano.2010.155 · Cited by 807
Self-citationElastic modulus of single cellulose microfibrils from tunicate measured by atomic force microscopy
Iwamoto, S., Kai, W., Isogai, A., & Iwata, T. (2009) · Biomacromolecules · doi:10.1021/bm900520n · Cited by 754
Pääkkö, M., Vapaavuori, J., Silvennoinen, R., Kosonen, H., Ankerfors, M., Lindström, T., Berglund, L. A., & Ikkala, O. (2008) · Soft Matter · doi:10.1039/b810371b · Cited by 660
Self-citationNakagaito, A. N., & Yano, H. (2004) · Applied Physics A: Materials Science & Processing · doi:10.1007/s00339-003-2453-5 · Cited by 608
Cellulose fibrils for polymer reinforcement
Zimmermann, T., Pöhler, E., & Geiger, T. (2004) · Advanced Engineering Materials · doi:10.1002/adem.200400097 · Cited by 598
Strength and barrier properties of MFC films
Syverud, K., & Stenius, P. (2009) · Cellulose · doi:10.1007/s10570-008-9244-2 · Cited by 592
Elastic modulus of the crystalline regions of cellulose polymorphs
Nishino, T., Takano, K., & Nakamae, K. (1995) · Journal of Polymer Science Part B: Polymer Physics · doi:10.1002/polb.1995.090331110 · Cited by 581
Self-citationHigh-porosity aerogels of high specific surface area prepared from nanofibrillated cellulose (NFC)
Sehaqui, H., Zhou, Q., & Berglund, L. A. (2011) · Composites Science and Technology · doi:10.1016/j.compscitech.2011.07.003 · Cited by 568
Self-citationStrong and Tough Cellulose Nanopaper with High Specific Surface Area and Porosity
Sehaqui, H., Zhou, Q., Ikkala, O., & Berglund, L. A. (2011) · Biomacromolecules · doi:10.1021/bm2008907 · Cited by 510
Self-citationSehaqui, H., Salajková, M., Zhou, Q., & Berglund, L. A. (2010) · Soft Matter · doi:10.1039/b927505c · Cited by 462
Self-citationClay Nanopaper with Tough Cellulose Nanofiber Matrix for Fire Retardancy and Gas Barrier Functions
Liu, A., Walther, A., Ikkala, O., Belova, L., & Berglund, L. A. (2011) · Biomacromolecules · doi:10.1021/bm101296z · Cited by 412
Self-citationFast Preparation Procedure for Large, Flat Cellulose and Cellulose/Inorganic Nanopaper Structures
Sehaqui, H., Liu, A., Zhou, Q., & Berglund, L. A. (2010) · Biomacromolecules · doi:10.1021/bm100490s · Cited by 400
Self-citationSvagan, A. J., Samir, M. A. S. A., & Berglund, L. A. (2008) · Advanced Materials · doi:10.1002/adma.200701215 · Cited by 347
Self-citationStructure and Mechanical Properties of Wet-Spun Fibers Made from Natural Cellulose Nanofibers
Iwamoto, S., Isogai, A., & Iwata, T. (2011) · Biomacromolecules · doi:10.1021/bm101510r · Cited by 337
New films produced from microfibrillated natural fibres
Taniguchi, T., & Okamura, K. (1998) · Polymer International · doi:10.1002/(sici)1097-0126(199811)47:3<291::aid-pi11>3.0.co;2-1 · Cited by 329
Orientation of cellulose microcrystals by strong magnetic fields
Sugiyama, J., Chanzy, H., & Maret, G. (1992) · Macromolecules · doi:10.1021/ma00042a032 · Cited by 254
Orientation of Native Cellulose in an Electric Field
Bordel, D., Putaux, J., & Heux, L. (2006) · Langmuir · doi:10.1021/la0600402 · Cited by 207
Cellulose Microcrystal Film of High Uniaxial Orientation
Yoshiharu, N., Shigenori, K., Masahisa, W., & Takeshi, O. (1997) · Macromolecules · doi:10.1021/ma970503y · Cited by 193
Uddin, A. J., Araki, J., & Gotoh, Y. (2011) · Biomacromolecules · doi:10.1021/bm101280f · Cited by 187
Sehaqui, H., Zhou, Q., & Berglund, L. A. (2011) · Soft Matter · doi:10.1039/c1sm05325f · Cited by 165
Self-citationHigh-performance composites from low-cost plant primary cell walls
Bruce, D. M., Hobson, R. N., Farrent, J. W., & Hepworth, D. G. (2005) · Composites Part A Applied Science and Manufacturing · doi:10.1016/j.compositesa.2005.03.008 · Cited by 116
Olsson, R. T., Krämer, R. H., López‐Rubio, A., Torres‐Giner, S., Ocio, M. J., & Lagaron, J. M. (2010) · Macromolecules · doi:10.1021/ma100217q · Cited by 90
Drawing of self‐reinforced cellulose films
Gindl‐Altmutter, W., & Kečkéš, J. (2006) · Journal of Applied Polymer Science · doi:10.1002/app.25434 · Cited by 75
Cited by
Developing fibrillated cellulose as a sustainable technological material
Li, T., Chen, C., Brozena, A. H., Zhu, J. Y., Xu, L., Driemeier, C., Dai, J., Rojas, O. J., Isogai, A., Wågberg, L., et al. (2021) · Nature · doi:10.1038/s41586-020-03167-7 · Cited by 1,674
On the use of nanocellulose as reinforcement in polymer matrix composites
Lee, K.-Y., Aitomäki, Y., Berglund, L. A., Oksman, K., & Bismarck, A. (2014) · Composites Science and Technology · doi:10.1016/j.compscitech.2014.08.032 · Cited by 819
Self-citationWood-based nanotechnologies toward sustainability
Jiang, F., Li, T., Li, Y., Zhang, Y., Gong, A., Dai, J., Hitz, E., Luo, W., & Hu, L. (2018) · Advanced Materials · doi:10.1002/adma.201703453 · Cited by 599
Wood-Based Flexible Electronics
Fu, Q., Chen, Y., & Sorieul, M. (2020) · ACS Nano · doi:10.1021/acsnano.9b09817 · Cited by 269
Metadata
- Authors
- Sehaqui, H., Ezekiel Mushi, N., Morimune, S., Salajkova, M., Nishino, T., & Berglund, L. A.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2012-02-01
- Volume
- 4
- Issue
- 2
- Pages
- 1043-1049
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2003344616
- Cited by
- 351
- References
- 32
- FWCI
- 6.85
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.
