The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Preparation and Characterization of Activated Carbon from the Pyrolysis of Physic Nut (Jatropha curcas L.) Waste
Abstract
Use of waste as raw material for producing porous carbon was investigated in this work. Physic nut ( Jatropha curcas L.) residue from oil extraction for biodiesel production was pyrolyzed at 400–800 °C with hold times of 15, 120, and 240 min to obtain char precursors. Activated carbon, with favorable Brunauer–Emmett–Teller surface area in a narrow range, was prepared by soaking these chars in concentrated KOH, H 3 PO 4, as well as a pure CO 2 gas flash activator. The maximum specific surface area of 532.30 m 2 g −1 was developed for the alkaline-treated sample. The carbon fraction of activated materials was as much as 90 wt %, significantly higher than the char precursor. Mesopore of 2–50 nm and total pore volumes of the materials were also significantly enhanced by these activations. Nitrogen adsorption isotherms of physic-nut-waste-activated carbons indicated that they were mainly mesopores. Pores of char activated by KOH and H 3 PO 4 are irregular, of different shapes and sizes, and the macropores seemed to be connected to mesopores, especially for the KOH-activated case. Surface analysis of pyrolyzed and activated char using Fourier transform infrared spectroscopy indicated main functional groups that are considerably different to those of activated materials, which may lead to greater adsorption potential of activated samples. However, functional groups on each activated carbon are quite similar even with different activation processes. According to the data obtained, physic nut residue pyrolyzed at 800 °C and followed by KOH activation could be used as a low-cost adsorbent with favorable surface properties.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The preparation of active carbons from coal by chemical and physical activation
Ahmadpour, A., & Do, D. D. (1996) · Carbon · doi:10.1016/0008-6223(95)00204-9 · Cited by 763
About reactions occurring during chemical activation with hydroxides
Lillo-Ródenas, M. A., Juan-Juan, J., Cazorla-Amorós, D., & Linares-Solano, A. (2004) · Carbon · doi:10.1016/j.carbon.2004.01.008 · Cited by 389
Cited by
A review on surface modification of activated carbon for carbon dioxide adsorption
Shafeeyan, M. S., Daud, W. M. A. W., Houshmand, A., & Shamiri, A. (2010) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2010.07.006 · Cited by 1,128
Hoang, A. T., Ong, H. C., Fattah, I. M. R., Chong, C. T., Cheng, C. K., Sakthivel, R., & Ok, Y. S. (2021) · Fuel Processing Technology · doi:10.1016/j.fuproc.2021.106997 · Cited by 512
Sulyman, M., Namiesnik, J., & Gierak, A. (2017) · Polish Journal of Environmental Studies · doi:10.15244/pjoes/66769 · Cited by 260
Kharrazi, S. M., Mirghaffari, N., Dastgerdi, M. M., & Soleimani, M. (2020) · Powder Technology · doi:10.1016/j.powtec.2020.01.065 · Cited by 107
Jamalzadeh, S., Haghighi, M., & Asgari, N. (2014) · Journal of Industrial and Engineering Chemistry · doi:10.1016/j.jiec.2013.11.001 · Cited by 29
Shawabkeh, R. A., Al-Harthi, M., & Al-Ghamdi, S. M. (2014) · Energy Sources, Part A: Recovery, Utilization, and Environmental Effects · doi:10.1080/15567036.2010.535103 · Cited by 15
“The oxidizing gas attacked the more readily oxidizable portion of the carbon surface, resulting in the development of the porous structure and the extensive internal surface area according to the reactions (Sricharoenchaikul et al., 2008): CO2 C Cx !”
BackgroundMiranda, R., Sosa, C., Bustos, D., Carrillo, E., & Rodrguez-Cant, M. (2012) · Lignocellulosic Precursors Used in the Synthesis of Activated Carbon - Characterization Techniques and Applications in the Wastewater Treatment · doi:10.5772/39368 · Cited by 12
Metadata
- Authors
- Sricharoenchaikul, V., Pechyen, C., Aht-ong, D., & Atong, D.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-09-21
- Volume
- 22
- Issue
- 1
- Pages
- 31-37
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2089825447
- Cited by
- 160
- References
- 2
- FWCI
- 3.43
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.