The Influence of Microwave Drying on Biomass Pyrolysis
The DOI matches its Crossref record.
Abstract
Microwave drying is a rapid, high-effect, and economical method to decrease the moisture content of biomass materials to produce higher quantity and better quality bio-oil during the fast pyrolysis process. In this paper, the influence of microwave drying on the behavior of biomass pyrolysis was investigated in a bench-scale fluidized-bed reactor in comparison to drying in an electrical oven at 105 °C. Three types of biomass were studied, comprising pine wood sawdust, peanut shell, and maize stalk. First, biomass samples were dried using a microwave oven at four different power levels, i.e., 200, 400, 600, and 800 W. It was found that the power capacity of the microwave showed great influence on the moisture removing property. The dehydration was very fast, and it was finished in 6 min at 600 W; however, it was quite slow with electrical oven drying (about 40 min). The specific surface area of biomass was found, being increased greatly after microwave drying. Then, the pyrolysis of biomass samples dried by two different methods was carried out in the bench-scale reactor at 500 °C. Samples dried at 600 W in 6 min were selected as representative for microwave drying. The yields and properties of pyrolysis products, including liquid oil, solid char, and uncondensable gas, were determined and analyzed. It was observed that the yields of solid char and liquid oil increased, while the yield of the gas product decreased by microwave oven drying compared to conventional electrical oven drying. A higher CO 2 concentration in gas but a lower organic compound content in char was achieved using microwave drying. At the same time, the viscosity and heating value increased because the water content decreased and the average molecular weight increased in the bio-oil from the samples dried by the microwave. These results were all caused by the fact that microwave drying suppressed the second reaction of volatiles during biomass pyrolysis. A higher heating value and lower water content are beneficial to bio-oil use as a fuel, and more primary pyrolysis products make bio-oil produce high add-value chemical materials. Thus, microwave drying is a technically and economically feasible pretreatment method for biomass fast pyrolysis.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Kan, T., Strezov, V., & Evans, T. J. (2016) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.12.185 · Cited by 2,239
Foong, S. Y., Liew, R. K., Yang, Y., Cheng, Y. W., Yek, P. N. Y., Wan Mahari, W. A., Lee, X. Y., Han, C. S., Vo, D.-V. N., Van Le, Q., et al. (2020) · Chemical Engineering Journal · doi:10.1016/j.cej.2020.124401 · Cited by 749
Hu, X., & Gholizadeh, M. (2019) · Journal of Energy Chemistry · doi:10.1016/j.jechem.2019.01.024 · Cited by 671
Biochar from microwave pyrolysis of biomass: A review
Li, J., Dai, J., Liu, G., Zhang, H., Gao, Z., Fu, J., He, Y., & Huang, Y. (2016) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2016.09.010 · Cited by 442
Microwave-assisted pyrolysis of biomass for liquid biofuels production
Yin, C. (2012) · Bioresource Technology · doi:10.1016/j.biortech.2012.06.016 · Cited by 419
Arpia, A. A., Chen, W.-H., Lam, S. S., Rousset, P., & de Luna, M. D. G. (2021) · Chemical Engineering Journal · doi:10.1016/j.cej.2020.126233 · Cited by 375
Ge, S., Yek, P. N. Y., Cheng, Y. W., Xia, C., Wan Mahari, W. A., Liew, R. K., Peng, W., Yuan, T.-Q., Tabatabaei, M., Aghbashlo, M., et al. (2021) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2020.110148 · Cited by 329
Kostas, E. T., Beneroso, D., & Robinson, J. P. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.03.135 · Cited by 319
“10% is the ideal target required prior to processing [54, 55], however the drying process of biomass feedstocks, if performed using”
A review on microwave pyrolysis of lignocellulosic biomass
Huang, Y.-F., Chiueh, P.-T., & Lo, S.-L. (2016) · Sustainable Environment Research · doi:10.1016/j.serj.2016.04.012 · Cited by 317
Li, Y., Shao, J., Wang, X., Deng, Y., Yang, H., & Chen, H. (2014) · Energy & Fuels · doi:10.1021/ef500725c · Cited by 271
Self-citationEffects of feedstock characteristics on microwave-assisted pyrolysis – A review
Zhang, Y., Chen, P., Liu, S., Peng, P., Min, M., Cheng, Y., Anderson, E., Zhou, N., Fan, L., Liu, C., et al. (2017) · Bioresource Technology · doi:10.1016/j.biortech.2017.01.046 · Cited by 260
Nitrogen transformations during fast pyrolysis of sewage sludge
Cao, J.-P., Li, L.-Y., Morishita, K., Xiao, X.-B., Zhao, X.-Y., Wei, X.-Y., & Takarada, T. (2013) · Fuel · doi:10.1016/j.fuel.2010.08.015 · Cited by 257
The integration of green chemistry into future biorefineries
H. Clark, J., E. I. Deswarte, F., & J. Farmer, T. (2009) · Biofuels, Bioproducts and Biorefining · doi:10.1002/bbb.119 · Cited by 241
Vijayaraghavan, K. (2019) · Environmental Technology Reviews · doi:10.1080/21622515.2019.1631393 · Cited by 146
“Several research studies employed different feedstocks for production of biochar throughmicrowave-assistedpyrolysis, including wheat straw [23], rice straw [24], seaweeds [25], oil palm biomass [26], bagasse [27] and peanut shell [28].”
BackgroundRex, P., Mohammed Ismail, K., Meenakshisundaram, N., Barmavatu, P., & Sai Bharadwaj, A. (2023) · ChemEngineering · doi:10.3390/chemengineering7030050 · Cited by 74
Metadata
- Authors
- Wang, X., Chen, H., Luo, K., Shao, J., & Yang, H.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-09-19
- Volume
- 22
- Issue
- 1
- Pages
- 67-74
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2022890085
- Cited by
- 138
- References
- 0
- FWCI
- 2.29
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.