The DOI matches its Crossref record.
Slagging Characteristics during Residential Combustion of Biomass Pellets
Abstract
Limited availability of sawdust and planer shavings and an increasing demand for biomass pellets in Europe are pushing the market toward other, more problematic raw materials with broader variation in total fuel ash content and composition of the ash forming elements as well as in their slagging tendencies. The main objective in the present work was therefore to determine the influence of fuel−ash composition on residual ash and slag behavior. Twelve different biomass pellets were used: reed canary grass (two different samples), hemp (two different samples), wheat straw, salix, logging residues (two different samples), stem wood (sawdust) as well as spruce, pine, and birch bark. The different pellet qualities were combusted in a commercial under fed pellet burner (20 kW) installed in a reference boiler. Continuous measurements of O 2, CO, CO 2, HCl, SO 2, and total particle matter mass concentrations were determined in the exhaust gas directly after the boiler. The collected slag deposits, the corresponding deposited bottom ash in the boiler and the collected particle matter were characterized with X-ray diffraction (XRD) and scanning electron microscopy combined with energy dispersive X-ray analysis (SEM/EDS). For biomass fuel pellets rich in silicon (either inherent or contaminated with sand) and low content of alkaline earth metals the main part of the potassium reacted with the silicon rich ash-residual, forming sticky alkali−silicate particles, which were not entrained from the burner and thereby giving rise to/initiating slag formation. Silicon rich fuels, i.e. fuels were the ash characteristics were dominated by silicate−alkali chemistry, therefore generally showed relatively high slagging tendencies. Straw fuels have typically this ash composition but exceptions to these general trends exists (e.g., one of the hemp fuels used in this work). Wood derived fuels with a relatively low inherent silicon content therefore showed low or relatively moderate slagging tendencies. However, contamination of sand material to these fuels may greatly enhance the slagging tendencies.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Ash Transformation Chemistry during Combustion of Biomass
Boström, D., Skoglund, N., Grimm, A., Boman, C., Öhman, M., Broström, M., & Backman, R. (2012) · Energy & Fuels · doi:10.1021/ef201205b · Cited by 440
Self-citationWang, L., Hustad, J. E., Skreiberg, Ø., Skjevrak, G., & Grønli, M. (2012) · Energy Procedia · doi:10.1016/j.egypro.2012.03.004 · Cited by 314
Sommersacher, P., Brunner, T., & Obernberger, I. (2012) · Energy & Fuels · doi:10.1021/ef201282y · Cited by 272
Long, J., Song, H., Jun, X., Sheng, S., Lun-shi, S., Kai, X., & Yao, Y. (2012) · Bioresource Technology · doi:10.1016/j.biortech.2012.03.051 · Cited by 196
Biomass and energy yield of industrial hemp grown for biogas and solid fuel
Prade, T., Svensson, S.-E., Andersson, A., & Mattsson, J. E. (2011) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2011.04.006 · Cited by 192
Metadata
- Authors
- Gilbe, C., Öhman, M., Lindström, E., Boström, D., Backman, R., Samuelsson, R., & Burvall, J.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2008-09-03
- Volume
- 22
- Issue
- 5
- Pages
- 3536-3543
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2058688435
- Cited by
- 199
- References
- 0
- FWCI
- 4.90
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Slagging Characteristics during Residential Combustion of Biomass Pellets. https://app.cochat.ai/papers/10.1021/ef800087x
- The paper
- Gilbe, C., Öhman, M., Lindström, E., Boström, D., Backman, R., Samuelsson, R., & Burvall, J. (2008). Slagging Characteristics during Residential Combustion of Biomass Pellets. Energy & Fuels. https://doi.org/10.1021/ef800087x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.