The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Brake Wear Particulate Matter Emissions
Abstract
Current particulate matter (PM) emission factor models estimate brake wear particulate matter emission rates using data derived from asbestos brakes. However, most brake pads are now produced from nonasbestos materials. Little work has been performed on emissions from brakes using these materials. Therefore, a brake wear study was performed using seven brake pad formulations that were in high volume use in 1998. Included were semi-metallic brakes, brakes using potassium titanate fibers, and brakes using aramid fibers. Brakes were tested on a brake dynamometer under four wear conditions. On average, 35% of the brake pad mass loss was emitted as airborne PM. The observed wear rates correspond to vehicle emission rates of 5.1−14.1 mg/mi. On average, 86 and 63% of the airborne PM was smaller than 10 μm in diameter (PM 10 ) or 2.5 μm in diameter (PM 2.5 ), respectively. The large number of particles observed in some wear tests was attributed to condensation, a process that is highly dependent on dilution condition. Analysis of airborne PM showed very few inhalable fibers. On average, 18% of the airborne PM was carbonaceous material. Elemental analysis indicated that metallic species together with silicon, phosphorus, sulfur, and chlorine accounted for most of the remaining mass. Estimates of brake wear PM 10 and PM 2.5 emission rates from light-duty vehicles are made from brake dynanometer wear tests.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Composition of Light-Duty Motor Vehicle Exhaust Particulate Matter in the Denver, Colorado Area
Cadle, S. H., Mulawa, P. A., Hunsanger, E. C., Nelson, K., Ragazzi, R. A., Barrett, R., Gallagher, G. L., Lawson, D. R., Knapp, K. T., & Snow, R. (1999) · Environmental Science & Technology · doi:10.1021/es9810843 · Cited by 202
Self-citationWilliams, R. L., & Muhlbaier, J. L. (1982) · Environmental Research · doi:10.1016/0013-9351(82)90008-1 · Cited by 61
Simulation of Automobile Brake Wear Dynamics and Estimation of Emissions
Cha, S., Carter, P., & Bradow, R. L. (1983) · SAE technical papers on CD-ROM/SAE technical paper series · doi:10.4271/831036 · Cited by 28
Cited by
Sources and properties of non-exhaust particulate matter from road traffic: A review
Thorpe, A., & Harrison, R. M. (2008) · Science of The Total Environment · doi:10.1016/j.scitotenv.2008.06.007 · Cited by 1,685
Comparative Environmental Life Cycle Assessment of Conventional and Electric Vehicles
Hawkins, T. R., Singh, B., Majeau‐Bettez, G., & Strømman, A. H. (2013) · Journal of Industrial Ecology · doi:10.1111/j.1530-9290.2012.00532.x · Cited by 1,670
Pant, P., & Harrison, R. M. (2013) · Atmospheric Environment · doi:10.1016/j.atmosenv.2013.04.028 · Cited by 1,181
Atmospheric transport is a major pathway of microplastics to remote regions
Evangeliou, N., Grythe, H., Klimont, Z., Heyes, C., Eckhardt, S., Lopez-Aparicio, S., & Stohl, A. (2020) · Nature Communications · doi:10.1038/s41467-020-17201-9 · Cited by 1,118
Characterization of heavy metal particles embedded in tire dust
Adachi, K., & Tainosho, Y. (2004) · Environment International · doi:10.1016/j.envint.2004.04.004 · Cited by 968
Metadata
- Authors
- Garg, B. D., Cadle, S. H., Mulawa, P. A., Groblicki, P. J., Laroo, C., & Parr, G. A.
- Venue
- Environmental Science & Technology
- Publisher
- American Chemical Society (ACS)
- Published
- 2000-09-16
- Volume
- 34
- Issue
- 21
- Pages
- 4463-4469
- ISSN
- 0013-936X (ISSN-L)
- 1520-5851
- OpenAlex
- W2012427295
- Cited by
- 663
- References
- 3
- FWCI
- 11.48
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.