The DOI matches its Crossref record.
Biomass Pyrolysis in a Fluidized Bed Reactor. Part 2: Experimental Validation of Model Results
Abstract
Various types of cylindrical biomass particles (pine, beech, bamboo, demolition wood) have been pyrolyzed in a batch-wise operated fluid bed laboratory setup. Conversion times, product yields, and product compositions were measured as a function of the particle size (0.7−17 mm), the vapor's residence time (0.25−6 s), the position of the biomass particles in the bed (dense bed or splash zone), and the fluid bed temperature (250−800 °C). For pyrolysis temperatures between 450 and 550 °C, the bio-oil yield appeared to be maximal (in this work: about 65 wt %), while the water content of the bio-oil is minimal. The position of the biomass particles in the fluid bed, either in the dense bed or in the splash zone, does not affect the conversion time and product yields to a large extent during pyrolysis at 500 °C. In the small fluid bed used for this work, with a char hold-up of up to 5 vol % (or 0.7 wt %), the residence time of the pyrolysis vapors is not that critical. At typical fast pyrolysis temperatures of around 500 °C, it appeared sufficient to keep this residence time below 5 s to prevent significant secondary cracking of the produced vapors to noncondensable gas. Up to a diameter of 17 mm, the particle size has only a minor effect on the total liquid yield. However, for particles larger than 3 mm, the water content of the produced bio-oil increases significantly. The experimental results are further compared with predictions from a one-dimensional (1D) and a two-dimensional (2D) single-particle pyrolysis model. Such models appeared to have a limited predictive power due to large uncertainties in the kinetics and selectivity of the biomass decomposition. Moreover, the product quality cannot be predicted at all.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Kan, T., Strezov, V., & Evans, T. J. (2016) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.12.185 · Cited by 2,239
Modeling chemical and physical processes of wood and biomass pyrolysis
DIBLASI, C. (2008) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2006.12.001 · Cited by 1,752
Biofuels Production through Biomass Pyrolysis—A Technological Review
Jahirul, M., Rasul, M., Chowdhury, A., & Ashwath, N. (2012) · Energies · doi:10.3390/en5124952 · Cited by 1,427
Characterization and prediction of biomass pyrolysis products
Neves, D., Thunman, H., Matos, A., Tarelho, L., & Gómez-Barea, A. (2011) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2011.01.001 · Cited by 856
Influence of inorganic salts on the primary pyrolysis products of cellulose
Patwardhan, P. R., Satrio, J. A., Brown, R. C., & Shanks, B. H. (2010) · Bioresource Technology · doi:10.1016/j.biortech.2010.01.112 · Cited by 799
Biomass pyrolysis-a review of modelling, process parameters and catalytic studies
Sharma, A., Pareek, V., & Zhang, D. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.04.193 · Cited by 675
Al-Rumaihi, A., Shahbaz, M., Mckay, G., Mackey, H., & Al-Ansari, T. (2022) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2022.112715 · Cited by 650
A review on bio-oil production from biomass by using pyrolysis method
Isahak, W. N. R. W., Hisham, M. W. M., Yarmo, M. A., & Yun Hin, T.-Y. (2012) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2012.05.039 · Cited by 624
Operating parameters for bio-oil production in biomass pyrolysis: A review
Guedes, R. E., Luna, A. S., & Torres, A. R. (2018) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2017.11.019 · Cited by 619
Fast pyrolysis technology development
Venderbosch, R., & Prins, W. (2010) · Biofuels, Bioproducts and Biorefining · doi:10.1002/bbb.205 · Cited by 552
Self-citationGarcia-Perez, M., Wang, X. S., Shen, J., Rhodes, M. J., Tian, F., Lee, W.-J., Wu, H., & Li, C.-Z. (2008) · Industrial & Engineering Chemistry Research · doi:10.1021/ie071497p · Cited by 391
Self-citationBiomass pyrolysis: A review on recent advancements and green hydrogen production
Vuppaladadiyam, A. K., Vuppaladadiyam, S. S. V., Awasthi, A., Sahoo, A., Rehman, S., Pant, K. K., Murugavelh, S., Huang, Q., Anthony, E., Fennel, P., et al. (2022) · Bioresource Technology · doi:10.1016/j.biortech.2022.128087 · Cited by 382
An Overview of Recent Developments in Biomass Pyrolysis Technologies
Uddin, M. N., Techato, K., Taweekun, J., Rahman, M. M., Rasul, M. G., Mahlia, T. M. I., & Ashrafur, S. M. (2018) · Energies · doi:10.3390/en11113115 · Cited by 377
Effects of particle size on the fast pyrolysis of oil mallee woody biomass
Shen, J., Wang, X.-S., Garcia-Perez, M., Mourant, D., Rhodes, M. J., & Li, C.-Z. (2009) · Fuel · doi:10.1016/j.fuel.2009.05.001 · Cited by 376
Self-citationInfluence of temperature on biomass pyrolysis in a conical spouted bed reactor
Amutio, M., Lopez, G., Artetxe, M., Elordi, G., Olazar, M., & Bilbao, J. (2012) · Resources, Conservation and Recycling · doi:10.1016/j.resconrec.2011.04.002 · Cited by 345
Historical Developments of Pyrolysis Reactors: A Review
Garcia-Nunez, J. A., Pelaez-Samaniego, M. R., Garcia-Perez, M. E., Fonts, I., Abrego, J., Westerhof, R. J. M., & Garcia-Perez, M. (2017) · Energy & Fuels · doi:10.1021/acs.energyfuels.7b00641 · Cited by 331
Dabros, T. M. H., Stummann, M. Z., Høj, M., Jensen, P. A., Grunwaldt, J.-D., Gabrielsen, J., Mortensen, P. M., & Jensen, A. D. (2018) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2018.05.002 · Cited by 309
A review on biomass pyrolysis models: Kinetic, network and mechanistic models
Hameed, S., Sharma, A., Pareek, V., Wu, H., & Yu, Y. (2019) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2019.02.008 · Cited by 307
Production of biofuels via co-processing in conventional refining processes
Lappas, A. A., Bezergianni, S., & Vasalos, I. A. (2009) · Catalysis Today · doi:10.1016/j.cattod.2008.07.001 · Cited by 262
An investigation into the effect of biomass particle size on its torrefaction
Basu, P., Rao, S., & Dhungana, A. (2013) · The Canadian Journal of Chemical Engineering · doi:10.1002/cjce.21710 · Cited by 87
Soni, B., & Karmee, S. K. (2020) · Fuel · doi:10.1016/j.fuel.2020.117570 · Cited by 83
Doassans-Carrère, N., Ferrasse, J.-H., Boutin, O., Mauviel, G., & Lédé, J. (2014) · Energy & Fuels · doi:10.1021/ef500641c · Cited by 49
Recent advances in fluidized bed technology in biomass processes
Fouilland, T., Grace, J. R., & Ellis, N. (2010) · Biofuels · doi:10.4155/bfs.10.20 · Cited by 43
Metadata
- Authors
- Wang, X., Kersten, S. R. A., Prins, W., & van Swaaij, W. P. M.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-10-11
- Volume
- 44
- Issue
- 23
- Pages
- 8786-8795
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2123422491
- Cited by
- 219
- References
- 0
- FWCI
- 3.37
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.