The DOI matches its Crossref record; 45 of the 45 references it cites were found in a registry or an index.
Comparative Study of Biomass Fast Pyrolysis and Direct Liquefaction for Bio-Oils Production: Products Yield and Characterizations
Abstract
The objective of this work is to compare two biomass-to-oil processes: fast pyrolysis and direct liquefaction, using the same biomass (beech sawdust). Fast pyrolysis is conducted in a cyclone reactor (wall temperature between 870 and 1040 K) and direct liquefaction in a 150-mL-autoclave reactor (bulk temperature between 420 and 600 K). Three fractions of pyro-oil are obtained from fast pyrolysis (heavy oil, light oil, and aerosol), whereas two fractions of liq-oil (heavy oil and water-soluble organics) are obtained from direct liquefaction. The comparison of both processes is based on the product yields and their characterization (ultimate analysis for solid and oils, oil–water content, gas and oil molecular composition, 1 H NMR for oils). For both processes, there is an optimal temperature at which the oil yield is maximum. Up to 62.6 wt % of pyro-oil are obtained at 970 K with the cyclone reactor (with 25.7 wt % of gas and 11.7 wt % of solid), whereas 47.0 wt % of liq-oil was obtained at 573 K with the batch-reactor (completed by 5.5 wt % of gas and 17.8 wt % of solid). Water content mainly explains the differences (mass yield and oxygen content) between oils from fast pyrolysis and direct liquefaction. Nevertheless, there are also some differences in organic composition: levoglucosane is a main component in pyro-oil, whereas levulinic acid is a main component in liq-oil. Finally, gas formed during direct liquefaction is mainly composed of CO 2 (more than 99 wt %), whereas gas from fast pyrolysis is a mixture of CO, CO 2, H 2, CH 4, and light hydrocarbons.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Under optimal conditions, the process can effectively produce bio-oil with high heating values, i.e., it has higher energy density and lower oxygen content than other biomass-based fuels, such as fast pyrolysis oil [9].”
From Sub- and Supercritical Water Liquefaction of Kraft Lignin and Black Liquor Derived Lignin (2020) · cites this paper as [9]
In the citing paper
“For example, HTL bio-oil has a higher heating value due to its lower oxygen content and it is, therefore, more resistant to aging [9,93].”
From Sub- and Supercritical Water Liquefaction of Kraft Lignin and Black Liquor Derived Lignin (2020) · cites this paper as [9]
Citations
Cites
Review of fast pyrolysis of biomass and product upgrading
Bridgwater, A. V. (2012) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2011.01.048 · Cited by 4,856
Hydrothermal liquefaction of biomass: A review of subcritical water technologies
Toor, S. S., Rosendahl, L., & Rudolf, A. (2011) · Energy · doi:10.1016/j.energy.2011.03.013 · Cited by 1,840
Modeling chemical and physical processes of wood and biomass pyrolysis
DIBLASI, C. (2008) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2006.12.001 · Cited by 1,752
Historical Developments in Hydroprocessing Bio-oils
Elliott, D. C. (2007) · Energy & Fuels · doi:10.1021/ef070044u · Cited by 1,370
A review on process conditions for optimum bio-oil yield in hydrothermal liquefaction of biomass
Akhtar, J., & Amin, N. A. S. (2011) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2010.11.054 · Cited by 1,059
Biorefineries for biofuel upgrading: A critical review
Fatih Demirbas, M. (2009) · Applied Energy · doi:10.1016/j.apenergy.2009.04.043 · Cited by 729
Characterization of bio-oils in chemical families
Garcia-Perez, M., Chaala, A., Pakdel, H., Kretschmer, D., & Roy, C. (2007) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2006.02.006 · Cited by 498
Yu, Y., Lou, X., & Wu, H. (2008) · Energy & Fuels · doi:10.1021/ef700292p · Cited by 479
Demirbas, A. (2007) · Fuel Processing Technology · doi:10.1016/j.fuproc.2007.01.010 · Cited by 411
Fast Pyrolysis of Forestry Residue. 2. Physicochemical Composition of Product Liquid
Oasmaa, A., Kuoppala, E., & Solantausta, Y. (2003) · Energy & Fuels · doi:10.1021/ef020206g · Cited by 394
Research works printed but not linked: 2
- Broust, F.Le cyclone: un réacteur multifonctionnel. Application à la pyrogazéification et à la pyroliquéfaction de la biomasse. Ph.D. thesis,Institut National Polytechnique de Lorraine,Nancy, France, 2003.
- Thermal Biomass Conversion;Bridgwater, A. V.; Hofbauer, H.; van Loo, S., Eds.CPL Press: 2009; Vol.1, pp37–78.
Cited by
From lignocellulosic biomass to levulinic acid: A review on acid-catalyzed hydrolysis
Kang, S., Fu, J., & Zhang, G. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2018.06.016 · Cited by 580
Lohri, C. R., Diener, S., Zabaleta, I., Mertenat, A., & Zurbrügg, C. (2017) · Reviews in Environmental Science and Bio/Technology · doi:10.1007/s11157-017-9422-5 · Cited by 311
“Demirbaş (2000) and Doassans-Carrère et al. (2014) compare these two technologies in terms of operating conditions, products yields and characteristics.”
BackgroundZhang, Z., Zhen, J., Liu, B., Lv, K., & Deng, K. (2015) · Green Chemistry · doi:10.1039/c4gc01833h · Cited by 261
Recent advances in production and upgrading of bio-oil from biomass: A critical overview
Baloch, H. A., Nizamuddin, S., Siddiqui, M. T. H., Riaz, S., Jatoi, A. S., Dumbre, D. K., Mubarak, N. M., Srinivasan, M. P., & Griffin, G. J. (2018) · Journal of Environmental Chemical Engineering · doi:10.1016/j.jece.2018.07.050 · Cited by 248
Kraft Lignin: A Valuable, Sustainable Resource, Opportunities and Challenges
Argyropoulos, D. D. S., Crestini, C., Dahlstrand, C., Furusjö, E., Gioia, C., Jedvert, K., Henriksson, G., Hulteberg, C., Lawoko, M., Pierrou, C., et al. (2023) · ChemSusChem · doi:10.1002/cssc.202300492 · Cited by 231
Metadata
- Authors
- Doassans-Carrère, N., Ferrasse, J.-H., Boutin, O., Mauviel, G., & Lédé, J.
- Affiliations
- Centre National de la Recherche Scientifique (FR)
- Corresponding author
- Ferrasse, Jean-Henry
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2014-08-01
- Volume
- 28
- Issue
- 8
- Pages
- 5103-5111
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2066906008
- Cited by
- 49
- References
- 45
- Citations by year
- 2025: 3 · 2024: 1 · 2023: 4 · 2022: 4 · 2021: 2 · 2020: 4 · 2019: 6 · 2018: 9 · 2017: 5 · 2016: 7 · 2015: 1 · 2014: 3
- FWCI
- 2.77
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Energy & Fuels (publishedVersion)
- HAL (submittedVersion)
- Funders
- Fondation Tuck
- Topics
- Physical Sciences › Energy › Fuel Technology › Thermochemical Biomass Conversion Processes
- Physical Sciences › Energy › Fuel Technology › Biodiesel Production and Applications
- Physical Sciences › Engineering › Biomedical Engineering › Biofuel production and bioconversion
- Keywords
- biomass fast pyrolysis, direct liquefaction, bio-oil, beech sawdust, oil yield, reaction temperature, cyclone reactor, levoglucosan, levulinic acid, gas composition, moisture content, 1H NMR, elemental analysis
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Comparative Study of Biomass Fast Pyrolysis and Direct Liquefaction for Bio-Oils Production: Products Yield and Characterizations. https://app.cochat.ai/papers/10.1021/ef500641c
- The paper
- Doassans-Carrère, N., Ferrasse, J.-H., Boutin, O., Mauviel, G., & Lédé, J. (2014). Comparative Study of Biomass Fast Pyrolysis and Direct Liquefaction for Bio-Oils Production: Products Yield and Characterizations. Energy & Fuels. https://doi.org/10.1021/ef500641c
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.