The DOI matches its Crossref record; 5 of the 5 references it cites were found in a registry or an index.
Synthesis of Iron-Doped Manganese Oxides with an Ion-Sieve Property: Lithium Adsorption from Bolivian Brine
Abstract
Iron-doped lithium manganese oxides Li 1.33 Fe x Mn 1.67– x O 4 ( x = 0.15, 0.30, and 0.40) were prepared by calcination of carbonates of Li, Mn, and nitrate of Fe in air at 350, 400, 450, 550, and 650 °C. The calcined samples, characterized by X-ray diffraction (XRD) and chemical analysis, were spinels. The protonated samples after treatment with HCl solution were tested as adsorbents for lithium adsorption from the salt lake brine collected from the Salar de Uyuni, Bolivia. The precursor showed 3.7% Mn extraction upon acid treatment with Fe/Mn ratio of 0.1 obtained from calcination at 450 °C. The amount of Mn extracted in HCl solution decreased with increasing of Fe/Mn ratio, and the amounts of lithium extraction were 90%, 96%, and 91% for Fe/Mn = 0.1, Fe/Mn = 0.2, and Fe/Mn = 0.3, respectively, while the amounts of dissolved iron showed the opposite trend. By studying the lithium adsorption in the raw brine and NaOH-added brine by a batch method, the adsorbent with Fe/Mn ratio of 0.1 obtained from calcination of the precursor at 450 °C was found to be efficient lithium adsorbent with lithium uptake of 18 mg/g at final pH 2.0 from the raw brine (initial pH 6.7) and 28 mg/g at final pH 7.2 from the NaOH-added brine (initial pH 8.2). The adsorbent with Fe/Mn ratio of 0.1 obtained from calcination of the precursor at 450 °C was evaluated for a 4 cycle adsorption/desorption experiment. The amount of manganese extracted (%) in the solution decreased with cycle numbers, 1.1% in the first cycle and 0.70% in the fourth cycle.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Global lithium resources: relative importance of pegmatite, brine and other deposits
Kesler, S. E., Gruber, P. W., Medina, P. A., Keoleian, G. A., Everson, M. P., & Wallington, T. J. (2012) · Ore Geology Reviews · doi:10.1016/j.oregeorev.2012.05.006 · Cited by 1,140
Recovery of lithium from Uyuni salar brine
An, J. W., Kang, D. J., Tran, K. T., Kim, M. J., Lim, T., & Tran, T. (2012) · Hydrometallurgy · doi:10.1016/j.hydromet.2012.02.008 · Cited by 509
Chitrakar, R., Kanoh, H., Miyai, Y., & Ooi, K. (2001) · Industrial & Engineering Chemistry Research · doi:10.1021/ie000911h · Cited by 340
Self-citationBatteries for lithium recovery from brines
Pasta, M., Battistel, A., & La Mantia, F. (2012) · Energy & Environmental Science · doi:10.1039/c2ee22977c · Cited by 278
Stamp, A., Lang, D. J., & Wäger, P. A. (2012) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2011.10.026 · Cited by 151
Cited by
Sun, Y., Wang, Q., Wang, Y., Yun, R., & Xiang, X. (2021) · Separation and Purification Technology · doi:10.1016/j.seppur.2020.117807 · Cited by 685
Extraction of lithium with functionalized lithium ion-sieves
Xu, X., Chen, Y., Wan, P., Gasem, K., Wang, K., He, T., Adidharma, H., & Fan, M. (2016) · Progress in Materials Science · doi:10.1016/j.pmatsci.2016.09.004 · Cited by 536
Electrochemical Methods for Lithium Recovery: A Comprehensive and Critical Review
Battistel, A., Palagonia, M. S., Brogioli, D., La Mantia, F., & Trócoli, R. (2020) · Advanced Materials · doi:10.1002/adma.201905440 · Cited by 504
Novel approaches for lithium extraction from salt-lake brines: A review
Liu, G., Zhao, Z., & Ghahreman, A. (2019) · Hydrometallurgy · doi:10.1016/j.hydromet.2019.05.005 · Cited by 465
Nie, X.-Y., Sun, S.-Y., Sun, Z., Song, X., & Yu, J.-G. (2017) · Desalination · doi:10.1016/j.desal.2016.05.010 · Cited by 380
Lithium Extraction from Seawater through Pulsed Electrochemical Intercalation
Liu, C., Li, Y., Lin, D., Hsu, P.-C., Liu, B., Yan, G., Wu, T., Cui, Y., & Chu, S. (2020) · Joule · doi:10.1016/j.joule.2020.05.017 · Cited by 365
Materials for lithium recovery from salt-lake brine
Xu, P., Hong, J., Qian, X., Xu, Z., Xia, H., Tao, X., Xu, Z., & Ni, Q.-Q. (2021) · Journal of Materials Science · doi:10.1007/s10853-020-05019-1 · Cited by 296
Technology for the Recovery of Lithium from Geothermal Brines
Stringfellow, W. T., & Dobson, P. F. (2021) · Energies · doi:10.3390/en14206805 · Cited by 293
Direct lithium extraction: A new paradigm for lithium production and resource utilization
Farahbakhsh, J., Arshadi, F., Mofidi, Z., Mohseni-Dargah, M., Kök, C., Assefi, M., Soozanipour, A., Zargar, M., Asadnia, M., Boroumand, Y., et al. (2024) · Desalination · doi:10.1016/j.desal.2023.117249 · Cited by 260
Introduction of manganese-based lithium-ion Sieve-A review
Weng, D., Duan, H., Hou, Y., Huo, J., Chen, L., Zhang, F., & Wang, J. (2020) · Progress in Natural Science: Materials International · doi:10.1016/j.pnsc.2020.01.017 · Cited by 230
Wei, S., Wei, Y., Chen, T., Liu, C., & Tang, Y. (2020) · Chemical Engineering Journal · doi:10.1016/j.cej.2019.122407 · Cited by 230
Guo, Z.-Y., Ji, Z.-Y., Chen, Q.-B., Liu, J., Zhao, Y.-Y., Li, F., Liu, Z.-Y., & Yuan, J.-S. (2018) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2018.05.077 · Cited by 198
Nie, X.-Y., Sun, S.-Y., Song, X., & Yu, J.-G. (2017) · Journal of Membrane Science · doi:10.1016/j.memsci.2017.02.020 · Cited by 195
On the Structure and Lithium Adsorption Mechanism of Layered H 2 TiO 3
Marthi, R., Asgar, H., Gadikota, G., & Smith, Y. R. (2021) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.0c20691 · Cited by 170
Ji, P.-Y., Ji, Z.-Y., Chen, Q.-B., Liu, J., Zhao, Y.-Y., Wang, S.-Z., Li, F., & Yuan, J.-S. (2018) · Separation and Purification Technology · doi:10.1016/j.seppur.2018.06.012 · Cited by 169
Separating Lithium and Magnesium in Brine by Aluminum-Based Materials
Liu, X., Zhong, M., Chen, X., & Zhao, Z. (2018) · Hydrometallurgy · doi:10.1016/j.hydromet.2018.01.005 · Cited by 153
Nikkhah, H., Ipekçi, D., Xiang, W., Stoll, Z., Xu, P., Li, B., McCutcheon, J. R., & Beykal, B. (2024) · Chemical Engineering Journal · doi:10.1016/j.cej.2024.155349 · Cited by 154
Chen, J., Lin, S., & Yu, J. (2021) · Separation and Purification Technology · doi:10.1016/j.seppur.2020.117710 · Cited by 137
Trócoli, R., Erinmwingbovo, C., & La Mantia, F. (2017) · ChemElectroChem · doi:10.1002/celc.201600509 · Cited by 136
Lee, D.-H., Ryu, T., Shin, J., Ryu, J. C., Chung, K.-S., & Kim, Y. H. (2017) · Hydrometallurgy · doi:10.1016/j.hydromet.2017.09.005 · Cited by 123
Reich, R., Slunitschek, K., Danisi, R. M., Eiche, E., & Kolb, J. (2023) · Mineral Processing and Extractive Metallurgy Review · doi:10.1080/08827508.2022.2047041 · Cited by 120
Luo, G., Li, X., Chen, L., Chao, Y., & Zhu, W. (2023) · Desalination · doi:10.1016/j.desal.2022.116228 · Cited by 69
Al-doped H 2 TiO 3 ion sieve with enhanced Li + adsorption performance
Dai, X., Zhan, H., Qian, Z., Li, J., Liu, Z., & Wu, Z. (2021) · RSC Advances · doi:10.1039/d1ra06535a · Cited by 66
Wang, P., Dai, J., Ma, Y., Chen, L., & Pan, J. (2020) · Chemical Engineering Journal · doi:10.1016/j.cej.2019.122495 · Cited by 59
Jamoussi, B., Chakroun, R., Al-Mur, B. A., Halawani, R. F., Aloufi, F. A., Chaabani, A., & Aljohani, N. S. (2023) · Polymers · doi:10.3390/polym15183847 · Cited by 14
Metadata
- Authors
- Chitrakar, R., Makita, Y., Ooi, K., & Sonoda, A.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 2014-02-21
- Volume
- 53
- Issue
- 9
- Pages
- 3682-3688
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2312655367
- Cited by
- 160
- References
- 5
- FWCI
- 7.79
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.