The DOI matches its Crossref record; 25 of the 25 references it cites were found in a registry or an index.
General Rules for Predicting Where a Catalytic Reaction Should Occur on Metal Surfaces: A Density Functional Theory Study of C−H and C−O Bond Breaking/Making on Flat, Stepped, and Kinked Metal Surfaces
Abstract
To predict where a catalytic reaction should occur is a fundamental issue scientifically. Technologically, it is also important because it can facilitate the catalyst's design. However, to date, the understanding of this issue is rather limited. In this work, two types of reactions, CH(4) <--> CH(3) + H and CO <--> C + O on two transition metal surfaces, were chosen as model systems aiming to address in general where a catalytic reaction should occur. The dissociations of CH(4) --> CH(3) + H and CO --> C + O and their reverse reactions on flat, stepped, and kinked Rh and Pd surfaces were studied in detail. We find the following: First, for the CH(4) <--> Ch(3) + H reaction, the dissociation barrier is reduced by approximately 0.3 eV on steps and kinks as compared to that on flat surfaces. On the other hand, there is essentially no difference in barrier for the association reaction of CH(3) + H on the flat surfaces and the defects. Second, for the CO <--> C + O reaction, the dissociation barrier decreases dramatically (more than 0.8 eV on Rh and Pd) on steps and kinks as compared to that on flat surfaces. In contrast to the CH(3) + H reaction, the C + O association reaction also preferentially occurs on steps and kinks. We also present a detailed analysis of the reaction barriers in which each barrier is decomposed quantitatively into a local electronic effect and a geometrical effect. Our DFT calculations show that surface defects such as steps and kinks can largely facilitate bond breaking, while whether the surface defects could promote bond formation depends on the individual reaction as well as the particular metal. The physical origin of these trends is identified and discussed. On the basis of our results, we arrive at some simple rules with respect to where a reaction should occur: (i) defects such as steps are always favored for dissociation reactions as compared to flat surfaces; and (ii) the reaction site of the association reactions is largely related to the magnitude of the bonding competition effect, which is determined by the reactant and metal valency. Reactions with high valency reactants are more likely to occur on defects (more structure-sensitive), as compared to reactions with low valency reactants. Moreover, the reactions on late transition metals are more likely to proceed on defects than those on the early transition metals.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Soft self-consistent pseudopotentials in a generalized eigenvalue formalism
Vanderbilt, D. (1990) · Physical Review B · doi:10.1103/physrevb.41.7892 · Cited by 23,185
Perdew, J. P., Chevary, J. A., Vosko, S. H., Jackson, K. A., Pederson, M. R., Singh, D. J., & Fiolhais, C. (1992) · Physical Review B · doi:10.1103/physrevb.46.6671 · Cited by 22,269
Perdew, J. P., Chevary, J. A., Vosko, S. H., Jackson, K. A., Pederson, M. R., Singh, D. J., & Fiolhais, C. (1993) · Physical Review B · doi:10.1103/physrevb.48.4978.2 · Cited by 17,144
Electronic factors determining the reactivity of metal surfaces
Hammer, B., & Nørskov, J. K. (1995) · Surface Science · doi:10.1016/0039-6028(96)80007-0 · Cited by 2,871
Self-Consistent Model of Hydrogen Chemisorption
NEWNS, D. M. (1969) · Physical Review · doi:10.1103/physrev.178.1123 · Cited by 1,632
Adiabatic Connection for Kinetics
Lynch, B. J., Fast, P. L., Harris, M., & Truhlar, D. G. (2000) · The Journal of Physical Chemistry A · doi:10.1021/jp000497z · Cited by 1,509
Introduction to surface chemistry and catalysis
Mckee, C. (1994) · Applied Catalysis A: General · doi:10.1016/0926-860x(94)85211-1 · Cited by 1,492
A chemical and theoretical way to look at bonding on surfaces
Hoffmann, R. (1988) · Reviews of Modern Physics · doi:10.1103/revmodphys.60.601 · Cited by 844
Role of Steps inN2Activation on Ru(0001)
Dahl, S., Logadottir, A., Egeberg, R. C., Larsen, J. H., Chorkendorff, I., Törnqvist, E., & Nørskov, J. K. (1999) · Physical Review Letters · doi:10.1103/physrevlett.83.1814 · Cited by 788
Identification of the "Active Sites" of a Surface-Catalyzed Reaction
Zambelli, T., Wintterlin, J., Trost, J., & Ertl, G. (1996) · Science · doi:10.1126/science.273.5282.1688 · Cited by 619
Cited by
Direct, Nonoxidative Conversion of Methane to Ethylene, Aromatics, and Hydrogen
Guo, X., Fang, G., Li, G., Ma, H., Fan, H., Yu, L., Ma, C., Wu, X., Deng, D., Wei, M., et al. (2014) · Science · doi:10.1126/science.1253150 · Cited by 1,422
Identification of Non-Precious Metal Alloy Catalysts for Selective Hydrogenation of Acetylene
Studt, F., Abild-Pedersen, F., Bligaard, T., Sørensen, R. Z., Christensen, C. H., & Nørskov, J. K. (2008) · Science · doi:10.1126/science.1156660 · Cited by 1,199
Deng, D., Chen, X., Yu, L., Wu, X., Liu, Q., Liu, Y., Yang, H., Tian, H., Hu, Y., Du, P., et al. (2015) · Science Advances · doi:10.1126/sciadv.1500462 · Cited by 869
Coking- and Sintering-Resistant Palladium Catalysts Achieved Through Atomic Layer Deposition
Lu, J., Fu, B., Kung, M. C., Xiao, G., Elam, J. W., Kung, H. H., & Stair, P. C. (2012) · Science · doi:10.1126/science.1212906 · Cited by 852
Selected perovskite oxides: Characterization, preparation and photocatalytic properties—A review
Grabowska, E. (2016) · Applied Catalysis B: Environmental · doi:10.1016/j.apcatb.2015.12.035 · Cited by 684
Efficient electrically powered CO2-to-ethanol via suppression of deoxygenation
Wang, X., Wang, Z., García de Arquer, F. P., Dinh, C.-T., Ozden, A., Li, Y. C., Nam, D.-H., Li, J., Liu, Y.-S., Wicks, J., et al. (2020) · Nature Energy · doi:10.1038/s41560-020-0607-8 · Cited by 666
Complementary Structure Sensitive and Insensitive Catalytic Relationships
Van Santen, R. A. (2009) · Accounts of Chemical Research · doi:10.1021/ar800022m · Cited by 655
Oxygen reduction reaction mechanism on nitrogen-doped graphene: A density functional theory study
Yu, L., Pan, X., Cao, X., Hu, P., & Bao, X. (2011) · Journal of Catalysis · doi:10.1016/j.jcat.2011.06.015 · Cited by 605
Self-citationvan Santen, R. A., Neurock, M., & Shetty, S. G. (2010) · Chemical Reviews · doi:10.1021/cr9001808 · Cited by 600
Wang, Y., Wang, Z., Dinh, C.-T., Li, J., Ozden, A., Golam Kibria, M., Seifitokaldani, A., Tan, C.-S., Gabardo, C. M., Luo, M., et al. (2019) · Nature Catalysis · doi:10.1038/s41929-019-0397-1 · Cited by 561
Zhan, C., Dattila, F., Rettenmaier, C., Bergmann, A., Kühl, S., García-Muelas, R., López, N., & Cuenya, B. R. (2021) · ACS Catalysis · doi:10.1021/acscatal.1c01478 · Cited by 554
Structure sensitivity and nanoscale effects in electrocatalysis
Koper, M. T. M. (2011) · Nanoscale · doi:10.1039/c0nr00857e · Cited by 468
Constraining CO coverage on copper promotes high-efficiency ethylene electroproduction
Li, J., Wang, Z., McCallum, C., Xu, Y., Li, F., Wang, Y., Gabardo, C. M., Dinh, C.-T., Zhuang, T.-T., Wang, L., et al. (2019) · Nature Catalysis · doi:10.1038/s41929-019-0380-x · Cited by 391
C–H bond activation in light alkanes: a theoretical perspective
Wang, Y., Hu, P., Yang, J., Zhu, Y.-A., & Chen, D. (2021) · Chemical Society Reviews · doi:10.1039/d0cs01262a · Cited by 375
Self-citationStructure sensitivity of Cu and CuZn catalysts relevant to industrial methanol synthesis
van den Berg, R., Prieto, G., Korpershoek, G., van der Wal, L. I., van Bunningen, A. J., Lægsgaard-Jørgensen, S., de Jongh, P. E., & de Jong, K. P. (2016) · Nature Communications · doi:10.1038/ncomms13057 · Cited by 326
Special Sites at Noble and Late Transition Metal Catalysts
Hammer, B. (2006) · Topics in Catalysis · doi:10.1007/s11244-006-0004-y · Cited by 311
Mechanism and microkinetics of the Fischer–Tropsch reaction
van Santen, R. A., Markvoort, A. J., Filot, I. A. W., Ghouri, M. M., & Hensen, E. J. M. (2013) · Physical Chemistry Chemical Physics · doi:10.1039/c3cp52506f · Cited by 291
Mechanism of H2O2 Decomposition on Transition Metal Oxide Surfaces
Lousada, C. M., Johansson, A. J., Brinck, T., & Jonsson, M. (2012) · The Journal of Physical Chemistry C · doi:10.1021/jp300255h · Cited by 286
Chen, X., Yu, L., Wang, S., Deng, D., & Bao, X. (2017) · Nano Energy · doi:10.1016/j.nanoen.2016.12.056 · Cited by 262
Face the Edges: Catalytic Active Sites of Nanomaterials
Ni, B., & Wang, X. (2015) · Advanced Science · doi:10.1002/advs.201500085 · Cited by 219
Machine learning potential era of zeolite simulation
Ma, S., & Liu, Z.-P. (2022) · Chemical Science · doi:10.1039/d2sc01225a · Cited by 57
Self-citation
Metadata
- Authors
- Liu, Z.-P., & Hu, P.
- Venue
- Journal of the American Chemical Society
- Publisher
- American Chemical Society (ACS)
- Published
- 2003-01-22
- Volume
- 125
- Issue
- 7
- Pages
- 1958-1967
- ISSN
- 0002-7863 (ISSN-L)
- 1520-5126
- OpenAlex
- W2048092337
- Cited by
- 620
- References
- 25
- FWCI
- 10.38
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.