Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat
Sign Up
Cited by 279

The DOI matches its Crossref record; 33 of the 33 references it cites were found in a registry or an index.

Evidence of the Existence of Three Types of Species at the Quartz−Aqueous Solution Interface at pH 0−10: XPS Surface Group Quantification and Surface Complexation Modeling

Duval, Y., Mielczarski, J. A., Pokrovsky, O. S., Mielczarski, E., Ehrhardt, J. J.·2002·The Journal of Physical Chemistry B
DOI 10.1021/jp012818s
Open this paper in CoChat — free account

Abstract

The surface composition of a quartz surface reacted with various aqueous solutions of pH 0−10 was qualitatively and quantitatively evaluated using X-ray photoelectron spectroscopy (XPS). The positions and intensities of the recorded Si 2p and O 1s lines change depending on solution conditions. The O 1s line, where the position varies more significantly, was analyzed in detail showing three components corresponding to three surface species: >SiOH 2 +, >SiOH 0, and >SiO - (where > represents the bulk quartz). The changes in the Si 2p spectra support these findings. The atomic ratio between the surface oxygen and silicon atoms was found to be 1.8. These data allow proposing a two-step deprotonation model of the quartz surface where two surface oxygen atoms are bonded to one silicon surface atom and where the most deprotonated surface sites show the SiO - configuration. Physisorbed water in the amount of around 10% of the monolayer was also found on all samples under spectroscopic investigation. The density of the >SiO - group increases significantly with an increase of pH, whereas the surface concentration of the >SiOH 2 + group is the highest at pH 0. The maximum of the neutral >SiOH 0 group is observed at pH 6. These results indicate immediately the validity of a 2-p K model of protonation of quartz/electrolyte interface versus a 1-p K model. The 2-p K surface capacitance model of the electric double layer having p K 1 = − 1.0 and p K 2 = 4.0 was derived from the XPS data. The new surface stability constants allow a quantitative description of quartz surface charge and dissolution kinetics in neutral to alkaline solutions and explicitly account for an increase of quartz dissolution rate at pH < 2 due to significant increase of the concentration of the >SiOH 2 + surface species. These results provide, for the first time, direct atomic level spectroscopic evidence of the validity of the chemical surface speciation approach, notably the existence of the charged >SiOH 2 + and >SiO - species at the quartz surface and their relative densities in acidic and alkaline solutions.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1021/jp012818s

Cites

33 of 33 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 279

Metadata

Authors
Duval, Y., Mielczarski, J. A., Pokrovsky, O. S., Mielczarski, E., & Ehrhardt, J. J.
Venue
The Journal of Physical Chemistry B
Publisher
American Chemical Society (ACS)
Published
2002-02-20
Volume
106
Issue
11
Pages
2937-2945
ISSN
  • 1520-5207 (ISSN-L)
  • 1520-6106
DOI
10.1021/jp012818s
OpenAlex
W2040527150
Cited by
279
References
33
FWCI
5.32
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.