The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Characterization of Regular and Plugged SBA-15 Silicas by Using Adsorption and Inverse Carbon Replication and Explanation of the Plug Formation Mechanism
Abstract
A series of SBA-15 silicas was synthesized using triblock copolymer templates with the same length of poly(propylene oxide) block (PO m; m = 70) and different average lengths of poly(ethylene oxide) blocks (EO n, n = 17−28). The average EO n length was varied by mixing EO 20 PO 70 EO 20 copolymer with either EO 5 PO 70 EO 5 or EO 106 PO 70 EO 106 copolymer, whereas the tetraethyl orthosilicate (TEOS)/EO-unit molar ratio was kept constant. In addition, samples with the higher ratios were synthesized for the EO 20 PO 70 EO 20 template. In all cases, 2-D hexagonally ordered SBA-15 silicas with interconnected primary pore structure (as inferred from carbon inverse replication) were obtained, but higher TEOS/EO-unit molar ratios resulted in the formation of samples with plugged pore structures, which were recently reported by others and referred to as plugged hexagonal templated silicas (PHTSs). Nitrogen adsorption data showed that n equal to about 19 was optimal from the point of view of formation of high-pore-volume, large-pore SBA-15 structure. All of the replicas exhibited structures with high specific surface area and pore volume and tended to have a similar pore diameter but more optimized SBA-15 structures tended to afford better ordered inverse carbon replicas. Regular and PHTS SBA-15 samples were additionally studied using argon adsorption at 77 K, which provided an important insight into the plugged structure. In particular, a PHTS sample that on the basis of nitrogen adsorption at 77 K appeared to be fully plugged, that is, with all primary mesopore channels closed by finely porous plugs, was found to be only partially plugged based on argon adsorption at 77 K, although there was evidence for the presence of some constrictions in all of the channels. A mechanism of the plug formation at high TEOS/copolymer molar ratios is proposed on the basis of similarity of the PHTSs with as-synthesized SBA-15 subjected to postsynthesis modification with TEOS. It is proposed herein that when the TEOS/EO-unit molar ratio is excessively high, only a part of TEOS present initially interacts with the EO n blocks of the copolymer template and thus hydrolyzes and condenses faster to form the SBA-15 structure. Subsequently or concurrently, the remaining TEOS, which hydrolyzes and condenses more slowly, solubilizes in the copolymer template in the SBA-15 pores (perhaps in the poly(propylene oxide) core of the micelles), or displaces the template, and then condenses to form the plugs.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Sing, K. S. W. (1985) · Pure and Applied Chemistry · doi:10.1351/pac198557040603 · Cited by 24,485
Characterization of the porous structure of sba-15
Kruk, M., Jaroniec, M., Ko, C. H., & Ryoo, R. (2000) · Chemistry of Materials · doi:10.1021/cm000164e · Cited by 1,409
Self-citation
Cited by
The hydrothermal synthesis of zeolites: Precursors, intermediates and reaction mechanism
Cundy, C. S., & Cox, P. A. (2005) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2005.02.016 · Cited by 1,590
Verified syntheses of mesoporous materials
Meynen, V., Cool, P., & Vansant, E. F. (2009) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2009.03.046 · Cited by 682
Mesoporous materials for clean energy technologies
Linares, N., Silvestre-Albero, A. M., Serrano, E., Silvestre-Albero, J., & García-Martínez, J. (2014) · Chem. Soc. Rev. · doi:10.1039/c3cs60435g · Cited by 526
Choi, M., Heo, W., Kleitz, F., & Ryoo, R. (2003) · Chem. Commun. · doi:10.1039/b303696k · Cited by 311
Self-citation
Metadata
- Authors
- Kruk, M., Jaroniec, M., Joo, S. H., & Ryoo, R.
- Venue
- The Journal of Physical Chemistry B
- Publisher
- American Chemical Society (ACS)
- Published
- 2003-02-13
- Volume
- 107
- Issue
- 10
- Pages
- 2205-2213
- ISSN
- 1520-5207 (ISSN-L)
- 1520-6106
- OpenAlex
- W1997706869
- Cited by
- 196
- References
- 2
- FWCI
- 11.87
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.