The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
11% Efficient Perovskite Solar Cell Based on ZnO Nanorods: An Effective Charge Collection System
Abstract
A perovskite solar cell based on ZnO nanorods was prepared, and its photovoltaic performance was investigated. ZnO nanorods were grown on the ZnO seed layer from solution, and their diameters and lengths were controlled by precursor concentration and growth time. CH 3 NH 3 PbI 3 perovskite infiltrated ZnO nanorods showed a power conversion efficiency of 11.13% with short-circuit current density J sc of 20.08 mA/cm 2, open-circuit voltage V oc of 991 mV and fill factor of 0.56. Square spectral feature of external quantum efficiency (EQE) was observed, where EQE exceeded 80% in almost the entire wavelength range from 400 to 750 nm, and the integrated current density of 20.03 mA/cm 2 calculated from EQE data was in good agreement with the observed J sc . Compared to the perfect spectral response of ZnO nanorods, a perovskite solar cell based on TiO 2 nanorods exhibited an integrated current density (16 mA/cm 2 ) much lower than the measured J sc (20.9 mA/cm 2 ). In addition, time-limited photocurrent response under 530 and 700 nm monochromatic beams at 10 Hz showed that device signal amplitude, associated with charge collection, was rapidly saturated for the ZnO nanorod-based device whereas charge collection was not fully detected for the TiO 2 nanorod-based device because of slow collection rate. The current results suggest that ZnO nanorod is an effective charge collection system in CH 3 NH 3 PbI 3 based perovskite solar cells.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Kim, H.-S., Lee, C.-R., Im, J.-H., Lee, K.-B., Moehl, T., Marchioro, A., Moon, S.-J., Humphry-Baker, R., Yum, J.-H., Moser, J. E., et al. (2012) · Scientific Reports · doi:10.1038/srep00591 · Cited by 8,092
Self-citation
Cited by
Perovskite Solar Cells: From Materials to Devices
Jung, H. S., & Park, N. (2015) · Small · doi:10.1002/smll.201402767 · Cited by 1,587
Self-citationColloidally prepared La-doped BaSnO 3 electrodes for efficient, photostable perovskite solar cells
Shin, S. S., Yeom, E. J., Yang, W. S., Hur, S., Kim, M. G., Im, J., Seo, J., Noh, J. H., & Seok, S. I. (2017) · Science · doi:10.1126/science.aam6620 · Cited by 1,163
Self-citationUnder the spotlight: The organic–inorganic hybrid halide perovskite for optoelectronic applications
Chen, Q., De Marco, N., Yang, Y. (., Song, T.-B., Chen, C.-C., Zhao, H., Hong, Z., Zhou, H., & Yang, Y. (2015) · Nano Today · doi:10.1016/j.nantod.2015.04.009 · Cited by 1,154
ZnO nanostructured materials and their potential applications: progress, challenges and perspectives
Raha, S., & Ahmaruzzaman, M. (2022) · Nanoscale Advances · doi:10.1039/d1na00880c · Cited by 1,107
Review on the Application of SnO2 in Perovskite Solar Cells
Xiong, L., Guo, Y., Wen, J., Liu, H., Yang, G., Qin, P., & Fang, G. (2018) · Advanced Functional Materials · doi:10.1002/adfm.201802757 · Cited by 653
Metal oxide nanoparticles in electrochemical sensing and biosensing: a review
George, J. M., Antony, A., & Mathew, B. (2018) · Microchimica Acta · doi:10.1007/s00604-018-2894-3 · Cited by 580
Recent progress in electron transport layers for efficient perovskite solar cells
Yang, G., Tao, H., Qin, P., Ke, W., & Fang, G. (2016) · Journal of Materials Chemistry A · doi:10.1039/c5ta09011c · Cited by 579
Applications of Phosphorene and Black Phosphorus in Energy Conversion and Storage Devices
Pang, J., Bachmatiuk, A., Yin, Y., Trzebicka, B., Zhao, L., Fu, L., Mendes, R. G., Gemming, T., Liu, Z., & Rummeli, M. H. (2018) · Advanced Energy Materials · doi:10.1002/aenm.201702093 · Cited by 518
Synthesis, properties and applications of ZnO nanomaterials with oxygen vacancies: A review
Wang, J., Chen, R., Xiang, L., & Komarneni, S. (2018) · Ceramics International · doi:10.1016/j.ceramint.2018.02.013 · Cited by 511
Current status of electron transport layers in perovskite solar cells: materials and properties
Mahmood, K., Sarwar, S., & Mehran, M. T. (2017) · RSC Advances · doi:10.1039/c7ra00002b · Cited by 468
Yu, Z., & Sun, L. (2015) · Advanced Energy Materials · doi:10.1002/aenm.201500213 · Cited by 462
Perovskite Solar Cells with ZnO Electron‐Transporting Materials
Zhang, P., Wu, J., Zhang, T., Wang, Y., Liu, D., Chen, H., Ji, L., Liu, C., Ahmad, W., Chen, Z. D., et al. (2018) · Advanced Materials · doi:10.1002/adma.201703737 · Cited by 450
Cao, J., Wu, B., Chen, R., Wu, Y., Hui, Y., Mao, B., & Zheng, N. (2018) · Advanced Materials · doi:10.1002/adma.201705596 · Cited by 447
Shetti, N. P., Bukkitgar, S. D., Reddy, K. R., Reddy, C. V., & Aminabhavi, T. M. (2019) · Biosensors and Bioelectronics · doi:10.1016/j.bios.2019.111417 · Cited by 403
Song, J., Zheng, E., Bian, J., Wang, X.-F., Tian, W., Sanehira, Y., & Miyasaka, T. (2015) · Journal of Materials Chemistry A · doi:10.1039/c5ta01207d · Cited by 366
Interfaces in Perovskite Solar Cells
Fakharuddin, A., Schmidt‐Mende, L., Garcia‐Belmonte, G., Jose, R., & Mora‐Sero, I. (2017) · Advanced Energy Materials · doi:10.1002/aenm.201700623 · Cited by 349
Sun, C., Wu, Z., Yip, H., Zhang, H., Jiang, X., Xue, Q., Hu, Z., Hu, Z., Shen, Y., Wang, M., et al. (2016) · Advanced Energy Materials · doi:10.1002/aenm.201501534 · Cited by 331
Engineered Nanomaterials for Renewable Energy
Salame, P. H., Pawade, V. B., & Bhanvase, B. A. (2018) · Handbook of Nanomaterials for Industrial Applications · doi:10.1016/b978-0-12-813351-4.00047-x · Cited by 4
Metadata
- Authors
- Son, D.-Y., Im, J.-H., Kim, H.-S., & Park, N.-G.
- Venue
- The Journal of Physical Chemistry C
- Publisher
- American Chemical Society (ACS)
- Published
- 2014-03-17
- Volume
- 118
- Issue
- 30
- Pages
- 16567-16573
- ISSN
- 1932-7447 (ISSN-L)
- 1932-7455
- OpenAlex
- W2030422013
- Cited by
- 701
- References
- 1
- FWCI
- 47.05
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.