Influence of Oxide on the Oxygen Reduction Reaction of Carbon-Supported Pt−Ni Alloy Nanoparticles
The DOI matches its Crossref record; 48 of the 48 references it cites were found in a registry or an index.
Abstract
Pt−Ni alloy nanoparticles supported on carbon black (Pt:Ni = 1:1) were prepared by the borohydride reduction method using acetate anions as a stabilizer in anhydrous ethanol solvent. Here, we surveyed the effect of oxide phases in Pt−Ni alloy nanoparticles on the electrocatalytic activity toward oxygen reduction reaction (ORR). As-prepared Pt 1 Ni 1 /C, which showed a relatively high degree of alloying, possessed the lower oxygen reduction reaction (ORR) activity as compared to pure Pt. However, following heat treatment in a flow of Ar at 300 °C for 3 h, Pt 1 Ni 1 /C showed oxygen reduction activity higher than that of commercial Pt/C (40 wt % Pt/C, Johnson-Matthey). The potential of zero total charge (PZTC) was calculated from cyclic voltammograms and the CO-displacement charge at dosing potentials at which anions are the main adsorbed species. The calculated value then shifted to a more positive potential after heat treatment. This indicates that the surface of the Pt−Ni nanoparticles became less oxophilic mainly due to the clustering of Pt. This anodic shift of the PZTC is consistent with the results of X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and X-ray absorption near-edge structure spectroscopy (XANES). Consequently, the observed catalytic enhancement by heat treatment is due to the increase of metallic Pt and NiO and the phase separation between metallic Pt and Ni oxides.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“The average size of the obtained Pt-Ni particles was approximately 3.4 nm, regardless of heat treatment, since 300 °C was not sufficient to sinter carbon-supported Pt-Ni alloy nanoparticles and thus resulted in incomplete alloying (∼35%).”
In the citing paper
“It should be mentioned that as a stabilizer, SA was helpful in protecting the formed nanoparticles, which had a controlled size and shape, as no marked changes in their shape or size were observed during the TEM analysis after heat treatment.”
Citations
Cites
Monodisperse FePt Nanoparticles and Ferromagnetic FePt Nanocrystal Superlattices
Sun, S., Murray, C. B., Weller, D., Folks, L., & Moser, A. (2000) · Science · doi:10.1126/science.287.5460.1989 · Cited by 6,137
Gasteiger, H. A., Kocha, S. S., Sompalli, B., & Wagner, F. T. (2005) · Applied Catalysis B: Environmental · doi:10.1016/j.apcatb.2004.06.021 · Cited by 4,876
Improved Oxygen Reduction Activity on Pt 3 Ni(111) via Increased Surface Site Availability
Stamenkovic, V. R., Fowler, B., Mun, B. S., Wang, G., Ross, P. N., Lucas, C. A., & Marković, N. M. (2007) · Science · doi:10.1126/science.1135941 · Cited by 4,421
Theoretical surface science and catalysis—calculations and concepts
Hammer, B., & Nørskov, J. K. (2000) · Advances in Catalysis · doi:10.1016/s0360-0564(02)45013-4 · Cited by 3,972
Size-Controlled Synthesis of Magnetite Nanoparticles
Sun, S., & Zeng, H. (2002) · Journal of the American Chemical Society · doi:10.1021/ja026501x · Cited by 2,829
CO Chemisorption at Metal Surfaces and Overlayers
Hammer, B., Morikawa, Y., & Nørskov, J. K. (1996) · Physical Review Letters · doi:10.1103/physrevlett.76.2141 · Cited by 1,501
Kitchin, J. R., Nørskov, J. K., Barteau, M. A., & Chen, J. G. (2004) · The Journal of Chemical Physics · doi:10.1063/1.1737365 · Cited by 1,358
Surface segregation energies in transition-metal alloys
Ruban, A. V., Skriver, H. L., & Nørskov, J. K. (1999) · Physical Review B · doi:10.1103/physrevb.59.15990 · Cited by 1,033
Mayrhofer, K. J. J., Strmcnik, D., Blizanac, B. B., Stamenkovic, V., Arenz, M., & Markovic, N. M. (2008) · Electrochimica Acta · doi:10.1016/j.electacta.2007.11.057 · Cited by 980
Oxygen Reduction on Carbon-Supported Pt−Ni and Pt−Co Alloy Catalysts
Paulus, U. A., Wokaun, A., Scherer, G. G., Schmidt, T. J., Stamenkovic, V., Radmilovic, V., Markovic, N. M., & Ross, P. N. (2002) · The Journal of Physical Chemistry B · doi:10.1021/jp013442l · Cited by 954
Research works printed but not linked: 1
- Mayrhofer K. J. J., 2008, Electrochim. Acta, 53, 3181, 10.1016/j.electacta.2007.11.057 · DOI · Paper page
Cited by
Recent Advances in Electrocatalysts for Oxygen Reduction Reaction
Shao, M., Chang, Q., Dodelet, J.-P., & Chenitz, R. (2016) · Chemical Reviews · doi:10.1021/acs.chemrev.5b00462 · Cited by 3,903
Wang, Y.-J., Zhao, N., Fang, B., Li, H., Bi, X. T., & Wang, H. (2015) · Chemical Reviews · doi:10.1021/cr500519c · Cited by 1,267
Highly Durable and Active Pt‐Based Nanoscale Design for Fuel‐Cell Oxygen‐Reduction Electrocatalysts
Chung, D. Y., Yoo, J. M., & Sung, Y. (2018) · Advanced Materials · doi:10.1002/adma.201704123 · Cited by 297
Self-citationYoo, T. Y., Yoo, J. M., Sinha, A. K., Bootharaju, M. S., Jung, E., Lee, H. S., Lee, B.-H., Kim, J., Antink, W. H., Kim, Y. M., et al. (2020) · Journal of the American Chemical Society · doi:10.1021/jacs.0c05140 · Cited by 268
Self-citationHu, Y., Zhang, H., Wu, P., Zhang, H., Zhou, B., & Cai, C. (2011) · Physical Chemistry Chemical Physics · doi:10.1039/c0cp01998d · Cited by 264
Metadata
- Authors
- Jeon, T.-Y., Yoo, S. J., Cho, Y.-H., Lee, K.-S., Kang, S. H., & Sung, Y.-E.
- Affiliations
- Seoul National University (KR)
- Corresponding author
- Sung, Yung-Eun
- Venue
- The Journal of Physical Chemistry C
- Publisher
- American Chemical Society (ACS)
- Published
- 2009-10-19
- Volume
- 113
- Issue
- 45
- Pages
- 19732-19739
- ISSN
- 1932-7447 (ISSN-L)
- 1932-7455
- OpenAlex
- W1999803970
- Cited by
- 74
- References
- 48
- Citations by year
- 2024: 1 · 2022: 1 · 2021: 4 · 2020: 3 · 2019: 3 · 2018: 4 · 2017: 3 · 2016: 7 · 2015: 5 · 2014: 11 · 2013: 9 · 2012: 6
- FWCI
- 3.60
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- The Journal of Physical Chemistry C (publishedVersion)
- Seoul National University Open Repository (Seoul National University) (submittedVersion)
- Topics
- Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
- Physical Sciences › Materials Science › Materials Chemistry › Catalytic Processes in Materials Science
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Fuel Cells and Related Materials
- Keywords
- oxygen reduction reaction, carbon-supported electrocatalysts, oxide phases, heat treatment, phase separation, nickel oxide, borohydride reduction, anion adsorption, electrocatalytic activity
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.