The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Methanol Electrooxidation over Pt/C Fuel Cell Catalysts: Dependence of Product Yields on Catalyst Loading
Abstract
We have investigated the influence of the catalyst loading (7−35 μg Pt ·cm - 2 ) on methanol oxidation product yields over Vulcan XC72 supported Pt catalyst by differential electrochemical mass spectrometry (DEMS), both under potentiodynamic and potentiostatic (0.6 V RHE ) conditions. Experiments were performed at room temperature and under continuous flow conditions (0.1 M CH 3 OH in 0.5 M H 2 SO 4 solution). Absolute calibration of the DEMS signal allowed determination of current efficiencies for the final reaction product CO 2 and for the reaction intermediates formic acid and formaldehyde. These could be converted into turnover frequencies (TOFs) on the basis of the physical (transmission electron microscopy) and electrochemical (CO stripping, H UPD ) determination of the absolute particle surface area. The good agreement between these values indicates 100% utilization of the catalyst. The electrochemical efficiencies, product distribution, and the turnover frequencies of partial reactions (methanol oxidation to formaldehyde, formic acid, and CO 2 ), during the methanol oxidation reaction (MOR) show a pronounced dependence on the catalyst loading. With increasing Pt loading the current efficiency for methanol oxidation to formaldehyde decays significantly (40% to almost 0%), while that for complete oxidation to CO 2 increases from 50 to 80%. The variation in current efficiency for methanol oxidation to formic acid is small (ca. 10%). The product distribution varies accordingly; the absolute numbers, however, are different: Low (5−20%) formic acid yields are accompanied by a decaying formaldehyde yield (60% to zero) and increasing CO 2 yield (30−80%) with increasing catalyst loading. The total TOF values calculated from the values for the individual reaction pathways and products are significantly higher than the Faradaic TOF numbers at low catalyst loadings, while at high loadings, where complete oxidation of methanol to CO 2 is preferred, they agree satisfactorily. The pronounced variations in product distribution/TOF values are attributed to increasing readsorption and subsequent complete oxidation of desorbed reaction intermediates (formaldehyde and formic acid) at higher catalyst loadings, while at low loadings or, even more pronounced, on smooth electrodes these intermediates are more likely to survive. This has to be considered for predictions of MOR characteristics under fuel cell conditions on the basis of studies on smooth electrodes.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Characterization of High‐Surface‐Area Electrocatalysts Using a Rotating Disk Electrode Configuration
Schmidt, T. J., Gasteiger, H. A., Stäb, G. D., Urban, P. M., Kolb, D. M., & Behm, R. J. (1998) · Journal of The Electrochemical Society · doi:10.1149/1.1838642 · Cited by 1,131
Self-citation
Cited by
Tian, Z. Q., Jiang, S. P., Liang, Y. M., & Shen, P. K. (2006) · The Journal of Physical Chemistry B · doi:10.1021/jp056401o · Cited by 390
Differential electrochemical mass spectrometry
Baltruschat, H. (2004) · Journal of the American Society for Mass Spectrometry · doi:10.1016/j.jasms.2004.09.011 · Cited by 368
Ethanol Electrooxidation on a Carbon-Supported Pt Catalyst: Reaction Kinetics and Product Yields
Wang, H., Jusys, Z., & Behm, R. J. (2004) · The Journal of Physical Chemistry B · doi:10.1021/jp046561k · Cited by 345
Self-citationToward Electrocatalytic Methanol Oxidation Reaction: Longstanding Debates and Emerging Catalysts
Wang, J., Zhang, B., Guo, W., Wang, L., Chen, J., Pan, H., & Sun, W. (2023) · Advanced Materials · doi:10.1002/adma.202211099 · Cited by 339
Cohen, J. L., Volpe, D. J., & Abruña, H. D. (2007) · Phys. Chem. Chem. Phys. · doi:10.1039/b612040g · Cited by 262
Metadata
- Authors
- Jusys, Z., Kaiser, J., & Behm, R. J.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2003-07-25
- Volume
- 19
- Issue
- 17
- Pages
- 6759-6769
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W2030951199
- Cited by
- 178
- References
- 1
- FWCI
- 9.56
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Methanol Electrooxidation over Pt/C Fuel Cell Catalysts: Dependence of Product Yields on Catalyst Loading. https://app.cochat.ai/papers/10.1021/la020932b
- The paper
- Jusys, Z., Kaiser, J., & Behm, R. J. (2003). Methanol Electrooxidation over Pt/C Fuel Cell Catalysts: Dependence of Product Yields on Catalyst Loading. Langmuir. https://doi.org/10.1021/la020932b
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.