The DOI matches its Crossref record; 43 of the 43 references it cites were found in a registry or an index.
Layer by Layer Buildup of Polysaccharide Films: Physical Chemistry and Cellular Adhesion Aspects
Abstract
The formation ofpolysaccharide films based on the alternate deposition of chitosan (CHI) and hyaluronan (HA) was investigated by several techniques. The multilayer buildup takes place in two stages: during the first stage, the surface is covered by isolated islets that grow and coalesce as the construction goes on. After several deposition steps, a continuous film is formed and the second stage of the buildup process takes place. The whole process is characterized by an exponential increase of the mass and thickness of the film with the number of deposition steps. This exponential growth mechanism is related to the ability of the polycation to diffuse "in" and "out" of the whole film at each deposition step. Using confocal laser microscopy and fluorescently labeled CHI, we show that such a diffusion behavior, already observed with poly(L-lysine) as a polycation, is also found with CHI, a polycation presenting a large persistence length. We also analyze the effect of the molecular weight (MW) of the diffusing polyelectrolyte (CHI) on the buildup process and observe a faster growth for low MW chitosan. The influence of the salt concentration during buildup is also investigated. Whereas the CHI/HA films grow rapidly at high salt concentration (0.15 M NaCl) with the formation of a uniform film after only a few deposition steps, it is very difficult to build the film at 10(-4) M NaCl. In this latter case, the deposited mass increases linearly with the number of deposition steps and the first deposition stage, where the surface is covered by islets, lasts at least up to 50 bilayer deposition steps. However, even at these low salt concentrations and in the islet configuration, CHI chains seem to diffuse in and out of the CHI/HA complexes. The linear mass increase of the film with the number of deposition steps despite the CHI diffusion is explained by a partial redissolution of the CHI/HA complexes forming the film during different steps of the buildup process. Finally, the uniform films built at high salt concentrations were also found to be chondrocyte resistant and, more interestingly, bacterial resistant. Therefore, the (CHI/HA) films may be used as an antimicrobial coating.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Fuzzy Nanoassemblies: Toward Layered Polymeric Multicomposites
Decher, G. (1997) · Science · doi:10.1126/science.277.5330.1232 · Cited by 10,054
pH-Dependent Thickness Behavior of Sequentially Adsorbed Layers of Weak Polyelectrolytes
Shiratori, S. S., & Rubner, M. F. (2000) · Macromolecules · doi:10.1021/ma991645q · Cited by 1,588
Computational Design of Hierarchically Structured Materials
Olson, G. B. (1997) · Science · doi:10.1126/science.277.5330.1237 · Cited by 1,229
Bertrand, P., Jonas, A., Laschewsky, A., & Legras, R. (2000) · Macromolecular Rapid Communications · doi:10.1002/(sici)1521-3927(20000401)21:7<319::aid-marc319>3.0.co;2-7 · Cited by 1,213
Molecular basis for the explanation of the exponential growth of polyelectrolyte multilayers
Picart, C., Mutterer, J., Richert, L., Luo, Y., Prestwich, G. D., Schaaf, P., Voegel, J.-C., & Lavalle, P. (2002) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.202486099 · Cited by 904
Self-citationHyaluronan: Preparation, Structure, Properties, and Applications
Lapčík, L., Lapčík, L., De Smedt, S., Demeester, J., & Chabreček, P. (1998) · Chemical Reviews · doi:10.1021/cr941199z · Cited by 737
Buildup Mechanism for Poly(l-lysine)/Hyaluronic Acid Films onto a Solid Surface
Picart, C., Lavalle, P., Hubert, P., Cuisinier, F. J. G., Decher, G., Schaaf, P., & Voegel, J.-C. (2001) · Langmuir · doi:10.1021/la010848g · Cited by 695
Self-citationSensitivity of grating couplers as integrated-optical chemical sensors
Tiefenthaler, K., & Lukosz, W. (1989) · Journal of the Optical Society of America B · doi:10.1364/josab.6.000209 · Cited by 620
Rinaudo, M., Milas, M., & Dung, P. L. (1993) · International Journal of Biological Macromolecules · doi:10.1016/0141-8130(93)90027-j · Cited by 615
Lavalle, P., Gergely, C., Cuisinier, F. J. G., Decher, G., Schaaf, P., Voegel, J. C., & Picart, C. (2002) · Macromolecules · doi:10.1021/ma0119833 · Cited by 534
Self-citation
Cited by
Banerjee, I., Pangule, R. C., & Kane, R. S. (2011) · Advanced Materials · doi:10.1002/adma.201001215 · Cited by 2,749
Biomedical Applications of Layer‐by‐Layer Assembly: From Biomimetics to Tissue Engineering
Tang, Z., Wang, Y., Podsiadlo, P., & Kotov, N. A. (2006) · Advanced Materials · doi:10.1002/adma.200600113 · Cited by 1,302
Molecular Interactions Driving the Layer-by-Layer Assembly of Multilayers
Borges, J., & Mano, J. F. (2014) · Chemical Reviews · doi:10.1021/cr400531v · Cited by 882
Yi, H., Wu, L.-Q., Bentley, W. E., Ghodssi, R., Rubloff, G. W., Culver, J. N., & Payne, G. F. (2005) · Biomacromolecules · doi:10.1021/bm050410l · Cited by 759
Multiple Functionalities of Polyelectrolyte Multilayer Films: New Biomedical Applications
Boudou, T., Crouzier, T., Ren, K., Blin, G., & Picart, C. (2010) · Advanced Materials · doi:10.1002/adma.200901327 · Cited by 736
Self-citationChua, P.-H., Neoh, K.-G., Kang, E.-T., & Wang, W. (2008) · Biomaterials · doi:10.1016/j.biomaterials.2007.12.019 · Cited by 483
Lichter, J. A., Van Vliet, K. J., & Rubner, M. F. (2009) · Macromolecules · doi:10.1021/ma901356s · Cited by 478
Intumescent Multilayer Nanocoating, Made with Renewable Polyelectrolytes, for Flame-Retardant Cotton
Laufer, G., Kirkland, C., Morgan, A. B., & Grunlan, J. C. (2012) · Biomacromolecules · doi:10.1021/bm300873b · Cited by 370
Clay–Chitosan Nanobrick Walls: Completely Renewable Gas Barrier and Flame-Retardant Nanocoatings
Laufer, G., Kirkland, C., Cain, A. A., & Grunlan, J. C. (2012) · ACS Applied Materials & Interfaces · doi:10.1021/am2017915 · Cited by 367
Responsive polymer films and capsules via layer-by-layer assembly
Sukhishvili, S. A. (2005) · Current Opinion in Colloid & Interface Science · doi:10.1016/j.cocis.2005.05.001 · Cited by 355
Gribova, V., Auzely-Velty, R., & Picart, C. (2012) · Chemistry of Materials · doi:10.1021/cm2032459 · Cited by 338
Self-citationMacrophage Uptake of Core−Shell Nanoparticles Surface Modified with Poly(ethylene glycol)
Zahr, A. S., Davis, C. A., & Pishko, M. V. (2006) · Langmuir · doi:10.1021/la060951b · Cited by 324
Antifouling and antimicrobial biomaterials: an overview
Francolini, I., Vuotto, C., Piozzi, A., & Donelli, G. (2017) · APMIS · doi:10.1111/apm.12675 · Cited by 322
Nasti, A., Zaki, N. M., de Leonardis, P., Ungphaiboon, S., Sansongsak, P., Rimoli, M. G., & Tirelli, N. (2009) · Pharmaceutical Research · doi:10.1007/s11095-009-9908-0 · Cited by 312
Polysaccharide nanoparticles: from fabrication to applications
Plucinski, A., Lyu, Z., & Schmidt, B. V. K. J. (2021) · Journal of Materials Chemistry B · doi:10.1039/d1tb00628b · Cited by 308
Biocompatible and Bioactive Surface Modifications for Prolonged In Vivo Efficacy
Meyers, S. R., & Grinstaff, M. W. (2012) · Chemical Reviews · doi:10.1021/cr2000916 · Cited by 294
Knopf‐Marques, H., Pravda, M., Wolfova, L., Velebny, V., Schaaf, P., Vrana, N. E., & Lavalle, P. (2016) · Advanced Healthcare Materials · doi:10.1002/adhm.201600316 · Cited by 257
Self-citationCai, K., Rechtenbach, A., Hao, J., Bossert, J., & Jandt, K. D. (2005) · Biomaterials · doi:10.1016/j.biomaterials.2005.03.020 · Cited by 254
Polysaccharide-based antibiofilm surfaces
Junter, G.-A., Thébault, P., & Lebrun, L. (2016) · Acta Biomaterialia · doi:10.1016/j.actbio.2015.11.010 · Cited by 215
Metadata
- Authors
- Richert, L., Lavalle, P., Payan, E., Shu, X. Z., Prestwich, G. D., Stoltz, J.-F., Schaaf, P., Voegel, J.-C., & Picart, C.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2003-12-18
- Volume
- 20
- Issue
- 2
- Pages
- 448-458
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W1979491885
- Cited by
- 534
- References
- 43
- FWCI
- 9.69
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.