The DOI matches its Crossref record.
Contact Angle of Water on Polystyrene Thin Films: Effects of CO2 Environment and Film Thickness
Abstract
We examine the contact angle of water droplets on polystyrene (PS) thin films of varying thicknesses supported by silicon wafers under both air and pressurized carbon dioxide (CO2) environments. At 23 degrees C, the contact angle is found to increase upon increasing CO2 pressure in the vapor regime and then levels off in the liquid CO2 regime. A macroscopic model based on Young's equation and the geometric-mean method for interfacial tensions, and long-range van der Waals interactions, correctly predicts the trends and the magnitude of the contact angle dependence on pressure, although deviations occur at high CO2 activities. The contact angle was also found to depend on film thickness, h, when h was comparable to or smaller than 50 nm. Specifically, the contact angle decreases with decreasing PS film thickness. This behavior could be accounted for with the use of a model that incorporates the effects of film thickness, CO2 pressure, and the long-range van der Waals potential.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Yuan, Y., Giri, G., Ayzner, A. L., Zoombelt, A. P., Mannsfeld, S. C. B., Chen, J., Nordlund, D., Toney, M. F., Huang, J., & Bao, Z. (2014) · Nature Communications · doi:10.1038/ncomms4005 · Cited by 1,360
CO2wettability of seal and reservoir rocks and the implications for carbon geo-sequestration
Iglauer, S., Pentland, C. H., & Busch, A. (2015) · Water Resources Research · doi:10.1002/2014wr015553 · Cited by 639
Raja, S. N., Bekenstein, Y., Koc, M. A., Fischer, S., Zhang, D., Lin, L., Ritchie, R. O., Yang, P., & Alivisatos, A. P. (2016) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.6b09443 · Cited by 521
A Candida auris –specific adhesin, Scf1 , governs surface association, colonization, and virulence
Santana, D. J., Anku, J. A. E., Zhao, G., Zarnowski, R., Johnson, C. J., Hautau, H., Visser, N. D., Ibrahim, A. S., Andes, D., Nett, J. E., et al. (2023) · Science · doi:10.1126/science.adf8972 · Cited by 142
Wu, Z., Ding, Q., Li, Z., Zhou, Z., Luo, L., Tao, K., Xie, X., & Wu, J. (2022) · Science China Materials · doi:10.1007/s40843-021-2022-1 · Cited by 42
Metadata
- Authors
- Li, Y., Pham, J. Q., Johnston, K. P., & Green, P. F.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-08-09
- Volume
- 23
- Issue
- 19
- Pages
- 9785-9793
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W2017710756
- Cited by
- 193
- References
- 0
- FWCI
- 2.67
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.