The DOI matches its Crossref record; 33 of the 33 references it cites were found in a registry or an index.
Morphology of Porous and Wrinkled Fibers of Polystyrene Electrospun from Dimethylformamide
Abstract
Submicron diameter fibers of polystyrene are electrospun from solutions in dimethylformamide (DMF). When electrospun in a high-humidity environment, the interior of these fibers was found to be highly porous rather than consolidated, despite the smooth and nonporous appearance of the fiber surfaces. The formation of interior porosity is attributed to the miscibility of water, a nonsolvent for the polymers in solution, with DMF. The resulting morphology is a consequence of the relatively rapid diffusion of water into the jet, leading to a liquid−liquid phase separation that precedes solidification due to evaporation of DMF from the jet. When electrospun in a low-humidity environment, the fibers exhibit a wrinkled morphology that can be explained by a buckling instability. Understanding which morphology forms under a given set of conditions is achieved through the comparison of three characteristic times: the drying time, the buckling time, and the phase separation time. The morphology has important consequences for the properties of the fibers such as their mechanical strength and stiffness.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Knops, R. J., & Wilkes, E. W. (1973) · Mechanics of Solids · doi:10.1007/978-3-642-69569-8_2 · Cited by 5,165
Correlation of diffusion coefficients in dilute solutions
Wilke, C. R., & Chang, P. (1955) · AIChE Journal · doi:10.1002/aic.690010222 · Cited by 4,884
Handbook of Chemistry and Physics.
Burger, A. (1965) · Journal of Medicinal Chemistry · doi:10.1021/jm00326a044 · Cited by 3,650
Nanometre diameter fibres of polymer, produced by electrospinning
Reneker, D. H., & Chun, I. (1996) · Nanotechnology · doi:10.1088/0957-4484/7/3/009 · Cited by 3,520
Bending instability of electrically charged liquid jets of polymer solutions in electrospinning
Reneker, D. H., Yarin, A. L., Fong, H., & Koombhongse, S. (2000) · Journal of Applied Physics · doi:10.1063/1.373532 · Cited by 2,462
Micro- and Nanostructured Surface Morphology on Electrospun Polymer Fibers
Megelski, S., Stephens, J. S., Chase, D. B., & Rabolt, J. F. (2002) · Macromolecules · doi:10.1021/ma020444a · Cited by 1,323
Nanostructured Fibers via Electrospinning
Bognitzki, M., Czado, W., Frese, T., Schaper, A., Hellwig, M., Steinhart, M., Greiner, A., & Wendorff, J. H. (2001) · Advanced Materials · doi:10.1002/1521-4095(200101)13:1<70::aid-adma70>3.0.co;2-h · Cited by 1,236
Spinning Continuous Fibers for Nanotechnology
Dzenis, Y. (2004) · Science · doi:10.1126/science.1099074 · Cited by 1,110
Electrospinning and electrically forced jets. I. Stability theory
Hohman, M. M., Shin, M., Rutledge, G. C., & Brenner, M. P. (2001) · Physics of Fluids · doi:10.1063/1.1383791 · Cited by 1,053
Self-citationCasper, C. L., Stephens, J. S., Tassi, N. G., Chase, D. B., & Rabolt, J. F. (2004) · Macromolecules · doi:10.1021/ma0351975 · Cited by 1,006
Three-Dimensionally Ordered Array of Air Bubbles in a Polymer Film
Srinivasarao, M., Collings, D., Philips, A., & Patel, S. (2001) · Science · doi:10.1126/science.1057887 · Cited by 907
Flat polymer ribbons and other shapes by electrospinning
Koombhongse, S., Liu, W., & Reneker, D. H. (2001) · Journal of Polymer Science Part B: Polymer Physics · doi:10.1002/polb.10015 · Cited by 824
Surface free energy and its effect on the elastic behavior of nano-sized particles, wires and films
DINGREVILLE, R., & QU, J. (2005) · Journal of the Mechanics and Physics of Solids · doi:10.1016/j.jmps.2005.02.012 · Cited by 729
Electrospinning and electrically forced jets. II. Applications
Hohman, M. M., Shin, M., Rutledge, G., & Brenner, M. P. (2001) · Physics of Fluids · doi:10.1063/1.1384013 · Cited by 698
Self-citationFormation of fibers by electrospinning
Rutledge, G. C., & Fridrikh, S. V. (2007) · Advanced Drug Delivery Reviews · doi:10.1016/j.addr.2007.04.020 · Cited by 638
Self-citationThe role of elasticity in the formation of electrospun fibers
Yu, J. H., Fridrikh, S. V., & Rutledge, G. C. (2006) · Polymer · doi:10.1016/j.polymer.2006.04.050 · Cited by 425
Self-citationFlügge, W. (1973) · Springer eBooks · doi:10.1007/978-3-642-88291-3 · Cited by 402
Predicting polymer/solvent diffusion coefficients using free‐volume theory
Zielinski, J. M., & Duda, J. L. (1992) · AIChE Journal · doi:10.1002/aic.690380309 · Cited by 401
Effect of supramolecular structure on polymer nanofibre elasticity
Arinstein, A., Burman, M., Gendelman, O., & Zussman, E. (2007) · Nature Nanotechnology · doi:10.1038/nnano.2006.172 · Cited by 378
Altena, F. W., & Smolders, C. A. (1982) · Macromolecules · doi:10.1021/ma00234a008 · Cited by 318
Yilmaz, L., & McHugh, A. J. (1986) · Journal of Applied Polymer Science · doi:10.1002/app.1986.070310404 · Cited by 253
Molecular diffusion in polymer solutions
Vrentas, J. S., & Duda, J. L. (1979) · AIChE Journal · doi:10.1002/aic.690250102 · Cited by 244
Mass transfer modeling of asymmetric membrane formation by phase inversion
Tsay, C. S., & Mchugh, A. J. (1990) · Journal of Polymer Science Part B: Polymer Physics · doi:10.1002/polb.1990.090280810 · Cited by 229
Mechanical properties of single electrospun drug-encapsulated nanofibres
Chew, S. Y., Hufnagel, T. C., Lim, C. T., & Leong, K. W. (2006) · Nanotechnology · doi:10.1088/0957-4484/17/15/045 · Cited by 206
Miyauchi, Y., Ding, B., & Shiratori, S. (2006) · Nanotechnology · doi:10.1088/0957-4484/17/20/019 · Cited by 188
Experimental and Theoretical Investigations of Porous Structure Formation in Electrospun Fibers
Dayal, P., Liu, J., Kumar, S., & Kyu, T. (2007) · Macromolecules · doi:10.1021/ma071418l · Cited by 186
Formation and properties of nylon-6 and nylon-6/montmorillonite composite nanofibers
Li, L., Bellan, L. M., Craighead, H. G., & Frey, M. W. (2006) · Polymer · doi:10.1016/j.polymer.2006.06.049 · Cited by 174
Effect of relative humidity on the morphology of electrospun polymer fibers
Medeiros, E. S. D., Mattoso, L. H. C., Offeman, R. D., Wood, D. F., & Orts, W. J. (2008) · Canadian Journal of Chemistry · doi:10.1139/v08-029 · Cited by 125
Three-point bending of electrospun TiO2 nanofibers
Lee, S.-H., Tekmen, Ç., & Sigmund, W. M. (2005) · Materials Science and Engineering A · doi:10.1016/j.msea.2005.03.014 · Cited by 121
Size-dependent elastic modulus of single electroactive polymer nanofibers
Shin, M. K., Kim, S. I., Kim, S. J., Kim, S.-K., Lee, H., & Spinks, G. M. (2006) · Applied Physics Letters · doi:10.1063/1.2402941 · Cited by 117
Matsuyama, H., Teramoto, M., Nakatani, R., & Maki, T. (1999) · Journal of Applied Polymer Science · doi:10.1002/(sici)1097-4628(19991003)74:1<159::aid-app20>3.0.co;2-s · Cited by 99
Modeling and simulation of nonsolvent vapor-induced phase separation
Yip, Y.-L., & McHugh, A. J. (2005) · Journal of Membrane Science · doi:10.1016/j.memsci.2005.06.063 · Cited by 97
CCXXXIV.—Molecular volumes at absolute zero. Part II. Zero volumes and chemical composition
Sugden, S. (1927) · Journal of the Chemical Society (Resumed) · doi:10.1039/jr9270001786 · Cited by 90
Cited by
A review on membrane fabrication: Structure, properties and performance relationship
Lalia, B. S., Kochkodan, V., Hashaikeh, R., & Hilal, N. (2013) · Desalination · doi:10.1016/j.desal.2013.06.016 · Cited by 1,109
Carbon Nanofibers Prepared via Electrospinning
Inagaki, M., Yang, Y., & Kang, F. (2012) · Advanced Materials · doi:10.1002/adma.201104940 · Cited by 801
Shin, J., Choi, S., Lee, I., Youn, D., Park, C. O., Lee, J., Tuller, H. L., & Kim, I. (2013) · Advanced Functional Materials · doi:10.1002/adfm.201202729 · Cited by 391
Coaxial Electrospinning Formation of Complex Polymer Fibers and their Applications
Han, D., & Steckl, A. J. (2019) · ChemPlusChem · doi:10.1002/cplu.201900281 · Cited by 355
The Evolution of Polystyrene as a Cell Culture Material
Lerman, M. J., Lembong, J., Muramoto, S., Gillen, G., & Fisher, J. P. (2018) · Tissue Engineering Part B: Reviews · doi:10.1089/ten.teb.2018.0056 · Cited by 258
Metadata
- Authors
- Pai, C.-L., Boyce, M. C., & Rutledge, G. C.
- Venue
- Macromolecules
- Publisher
- American Chemical Society (ACS)
- Published
- 2009-02-20
- Volume
- 42
- Issue
- 6
- Pages
- 2102-2114
- ISSN
- 0024-9297 (ISSN-L)
- 1520-5835
- OpenAlex
- W2056178233
- Cited by
- 260
- References
- 33
- FWCI
- 6.84
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.