The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Simultaneously Strong and Tough Ultrafine Continuous Nanofibers
Abstract
Strength of structural materials and fibers is usually increased at the expense of strain at failure and toughness. Recent experimental studies have demonstrated improvements in modulus and strength of electrospun polymer nanofibers with reduction of their diameter. Nanofiber toughness has not been analyzed; however, from the classical materials property trade-off, one can expect it to decrease. Here, on the basis of a comprehensive analysis of long (5-10 mm) individual polyacrylonitrile nanofibers, we show that nanofiber toughness also dramatically improves. Reduction of fiber diameter from 2.8 μm to ∼100 nm resulted in simultaneous increases in elastic modulus from 0.36 to 48 GPa, true strength from 15 to 1750 MPa, and toughness from 0.25 to 605 MPa with the largest increases recorded for the ultrafine nanofibers smaller than 250 nm. The observed size effects showed no sign of saturation. Structural investigations and comparisons with mechanical behavior of annealed nanofibers allowed us to attribute ultrahigh ductility (average failure strain stayed over 50%) and toughness to low nanofiber crystallinity resulting from rapid solidification of ultrafine electrospun jets. Demonstrated superior mechanical performance coupled with the unique macro-nano nature of continuous nanofibers makes them readily available for macroscopic materials and composites that can be used in safety-critical applications. The proposed mechanism of simultaneously high strength, modulus, and toughness challenges the prevailing 50 year old paradigm of high-performance polymer fiber development calling for high polymer crystallinity and may have broad implications in fiber science and technology.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
VI. The phenomena of rupture and flow in solids
Griffith, A. A. (1921) · Philosophical Transactions of the Royal Society of London. Series A, Containing Papers of a Mathematical or Physical Character · doi:10.1098/rsta.1921.0006 · Cited by 11,052
The conflicts between strength and toughness
Ritchie, R. O. (2011) · Nature Materials · doi:10.1038/nmat3115 · Cited by 3,989
Structure and process relationship of electrospun bioabsorbable nanofiber membranes
Zong, X., Kim, K., Fang, D., Ran, S., Hsiao, B. S., & Chu, B. (2002) · Polymer · doi:10.1016/s0032-3861(02)00275-6 · Cited by 1,893
Multifunctional Carbon Nanotube Yarns by Downsizing an Ancient Technology
Zhang, M., Atkinson, K. R., & Baughman, R. H. (2004) · Science · doi:10.1126/science.1104276 · Cited by 1,721
Liquid crystalline spinning of spider silk
Vollrath, F., & Knight, D. P. (2001) · Nature · doi:10.1038/35069000 · Cited by 1,610
Super-tough carbon-nanotube fibres
Dalton, A. B., Collins, S., Muñoz, E., Razal, J. M., Ebron, V. H., Ferraris, J. P., Coleman, J. N., Kim, B. G., & Baughman, R. H. (2003) · Nature · doi:10.1038/423703a · Cited by 1,521
Spinning Continuous Fibers for Nanotechnology
Dzenis, Y. (2004) · Science · doi:10.1126/science.1099074 · Cited by 1,110
Self-citationStructural Relaxation of Polymer Glasses at Surfaces, Interfaces, and In Between
Priestley, R. D., Ellison, C. J., Broadbelt, L. J., & Torkelson, J. M. (2005) · Science · doi:10.1126/science.1112217 · Cited by 729
Zhu, Y. T., & Liao, X. (2004) · Nature Materials · doi:10.1038/nmat1141 · Cited by 548
Effect of fiber diameter on tensile properties of electrospun poly(ɛ-caprolactone)
Wong, S.-C., Baji, A., & Leng, S. (2008) · Polymer · doi:10.1016/j.polymer.2008.08.022 · Cited by 528
Cited by
Processing, structure, and properties of carbon fibers
Newcomb, B. A. (2016) · Composites Part A: Applied Science and Manufacturing · doi:10.1016/j.compositesa.2016.10.018 · Cited by 779
Commercial application of cellulose nano-composites – A review
Sharma, A., Thakur, M., Bhattacharya, M., Mandal, T., & Goswami, S. (2019) · Biotechnology Reports · doi:10.1016/j.btre.2019.e00316 · Cited by 762
Nanoparticles meet electrospinning: recent advances and future prospects
Zhang, C.-L., & Yu, S.-H. (2014) · Chemical Society Reviews · doi:10.1039/c3cs60426h · Cited by 665
Developments of Advanced Electrospinning Techniques: A Critical Review
Li, Y., Zhu, J., Cheng, H., Li, G., Cho, H., Jiang, M., Gao, Q., & Zhang, X. (2021) · Advanced Materials Technologies · doi:10.1002/admt.202100410 · Cited by 578
Electrospun nanofiber reinforced composites: a review
Jiang, S., Chen, Y., Duan, G., Mei, C., Greiner, A., & Agarwal, S. (2018) · Polymer Chemistry · doi:10.1039/c8py00378e · Cited by 560
Thermal transport in polymeric materials and across composite interfaces
Mehra, N., Mu, L., Ji, T., Yang, X., Kong, J., Gu, J., & Zhu, J. (2018) · Applied Materials Today · doi:10.1016/j.apmt.2018.04.004 · Cited by 453
Electrospun polyimide nanofibers and their applications
Ding, Y., Hou, H., Zhao, Y., Zhu, Z., & Fong, H. (2016) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2016.06.006 · Cited by 452
High thermal conductivity of chain-oriented amorphous polythiophene
Singh, V., Bougher, T. L., Weathers, A., Cai, Y., Bi, K., Pettes, M. T., McMenamin, S. A., Lv, W., Resler, D. P., Gattuso, T. R., et al. (2014) · Nature Nanotechnology · doi:10.1038/nnano.2014.44 · Cited by 430
Lignin-derivatives based polymers, blends and composites: A review
Naseem, A., Tabasum, S., Zia, K. M., Zuber, M., Ali, M., & Noreen, A. (2016) · International Journal of Biological Macromolecules · doi:10.1016/j.ijbiomac.2016.08.030 · Cited by 343
High strength in combination with high toughness in robust and sustainable polymeric materials
Liao, X., Dulle, M., de Souza e Silva, J. M., Wehrspohn, R. B., Agarwal, S., Förster, S., Hou, H., Smith, P., & Greiner, A. (2019) · Science · doi:10.1126/science.aay9033 · Cited by 286
Huang, L., Arena, J. T., Manickam, S. S., Jiang, X., Willis, B. G., & McCutcheon, J. R. (2014) · Journal of Membrane Science · doi:10.1016/j.memsci.2014.01.045 · Cited by 280
Xiong, R., Grant, A. M., Ma, R., Zhang, S., & Tsukruk, V. V. (2018) · Materials Science and Engineering: R: Reports · doi:10.1016/j.mser.2018.01.002 · Cited by 276
High Strength and High Modulus Electrospun Nanofibers
Yao, J., Bastiaansen, C., & Peijs, T. (2014) · Fibers · doi:10.3390/fib2020158 · Cited by 270
Molecular Orientation in Electrospun Fibers: From Mats to Single Fibers
Richard-Lacroix, M., & Pellerin, C. (2013) · Macromolecules · doi:10.1021/ma401681m · Cited by 270
Mechanical Properties of Electrospun Fibers—A Critical Review
Rashid, T. U., Gorga, R. E., & Krause, W. E. (2021) · Advanced Engineering Materials · doi:10.1002/adem.202100153 · Cited by 268
Electrospun nanofiber: Emerging reinforcing filler in polymer matrix composite materials
Wang, G., Yu, D., Kelkar, A. D., & Zhang, L. (2017) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2017.08.002 · Cited by 254
Development of Filter Media by Electrospinning for Air Filtration of Nanoparticles from PET Bottles
Bonfim, D. P. F., Cruz, F. G. S., Guerra, V. G., & Aguiar, M. L. (2021) · Membranes · doi:10.3390/membranes11040293 · Cited by 60
“This could be explained by a higher degree of molecular alignment when thinner fibers were produced in the electrical field, due to the increased fiber stretching [24,37].”
Background
Metadata
- Authors
- Papkov, D., Zou, Y., Andalib, M. N., Goponenko, A., Cheng, S. Z. D., & Dzenis, Y. A.
- Venue
- ACS Nano
- Publisher
- American Chemical Society (ACS)
- Published
- 2013-03-20
- Volume
- 7
- Issue
- 4
- Pages
- 3324-3331
- ISSN
- 1936-0851 (ISSN-L)
- 1936-086X
- OpenAlex
- W2055762937
- Cited by
- 299
- References
- 26
- FWCI
- 9.82
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.