The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Simultaneously Strong and Tough Ultrafine Continuous Nanofibers
Abstract
Strength of structural materials and fibers is usually increased at the expense of strain at failure and toughness. Recent experimental studies have demonstrated improvements in modulus and strength of electrospun polymer nanofibers with reduction of their diameter. Nanofiber toughness has not been analyzed; however, from the classical materials property trade-off, one can expect it to decrease. Here, on the basis of a comprehensive analysis of long (5-10 mm) individual polyacrylonitrile nanofibers, we show that nanofiber toughness also dramatically improves. Reduction of fiber diameter from 2.8 μm to ∼100 nm resulted in simultaneous increases in elastic modulus from 0.36 to 48 GPa, true strength from 15 to 1750 MPa, and toughness from 0.25 to 605 MPa with the largest increases recorded for the ultrafine nanofibers smaller than 250 nm. The observed size effects showed no sign of saturation. Structural investigations and comparisons with mechanical behavior of annealed nanofibers allowed us to attribute ultrahigh ductility (average failure strain stayed over 50%) and toughness to low nanofiber crystallinity resulting from rapid solidification of ultrafine electrospun jets. Demonstrated superior mechanical performance coupled with the unique macro-nano nature of continuous nanofibers makes them readily available for macroscopic materials and composites that can be used in safety-critical applications. The proposed mechanism of simultaneously high strength, modulus, and toughness challenges the prevailing 50 year old paradigm of high-performance polymer fiber development calling for high polymer crystallinity and may have broad implications in fiber science and technology.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
VI. The phenomena of rupture and flow in solids
Griffith, A. A. (1921) · Philosophical Transactions of the Royal Society of London. Series A, Containing Papers of a Mathematical or Physical Character · doi:10.1098/rsta.1921.0006 · Cited by 11,052
The conflicts between strength and toughness
Ritchie, R. O. (2011) · Nature Materials · doi:10.1038/nmat3115 · Cited by 3,989
Structure and process relationship of electrospun bioabsorbable nanofiber membranes
Zong, X., Kim, K., Fang, D., Ran, S., Hsiao, B. S., & Chu, B. (2002) · Polymer · doi:10.1016/s0032-3861(02)00275-6 · Cited by 1,893
Multifunctional Carbon Nanotube Yarns by Downsizing an Ancient Technology
Zhang, M., Atkinson, K. R., & Baughman, R. H. (2004) · Science · doi:10.1126/science.1104276 · Cited by 1,721
Liquid crystalline spinning of spider silk
Vollrath, F., & Knight, D. P. (2001) · Nature · doi:10.1038/35069000 · Cited by 1,610
Super-tough carbon-nanotube fibres
Dalton, A. B., Collins, S., Muñoz, E., Razal, J. M., Ebron, V. H., Ferraris, J. P., Coleman, J. N., Kim, B. G., & Baughman, R. H. (2003) · Nature · doi:10.1038/423703a · Cited by 1,521
Spinning Continuous Fibers for Nanotechnology
Dzenis, Y. (2004) · Science · doi:10.1126/science.1099074 · Cited by 1,110
Self-citationStructural Relaxation of Polymer Glasses at Surfaces, Interfaces, and In Between
Priestley, R. D., Ellison, C. J., Broadbelt, L. J., & Torkelson, J. M. (2005) · Science · doi:10.1126/science.1112217 · Cited by 729
Zhu, Y. T., & Liao, X. (2004) · Nature Materials · doi:10.1038/nmat1141 · Cited by 548
Effect of fiber diameter on tensile properties of electrospun poly(ɛ-caprolactone)
Wong, S.-C., Baji, A., & Leng, S. (2008) · Polymer · doi:10.1016/j.polymer.2008.08.022 · Cited by 528
Hou, H., Ge, J. J., Zeng, J., Li, Q., Reneker, D. H., Greiner, A., & Cheng, S. Z. D. (2005) · Chemistry of Materials · doi:10.1021/cm0484955 · Cited by 449
Self-citationEffect of supramolecular structure on polymer nanofibre elasticity
Arinstein, A., Burman, M., Gendelman, O., & Zussman, E. (2007) · Nature Nanotechnology · doi:10.1038/nnano.2006.172 · Cited by 378
Kakade, M. V., Givens, S., Gardner, K., Lee, K. H., Chase, D. B., & Rabolt, J. F. (2007) · Journal of the American Chemical Society · doi:10.1021/ja065043f · Cited by 373
Hot-Drawing of Single and Multiwall Carbon Nanotube Fibers for High Toughness and Alignment
Miaudet, P., Badaire, S., Maugey, M., Derré, A., Pichot, V., Launois, P., Poulin, P., & Zakri, C. (2005) · Nano Letters · doi:10.1021/nl051419w · Cited by 323
Effects of crystalline morphology on the tensile properties of electrospun polymer nanofibers
Lim, C. T., Tan, E. P. S., & Ng, S. Y. (2008) · Applied Physics Letters · doi:10.1063/1.2857478 · Cited by 289
Cellulose and collagen: from fibres to tissues
Fratzl, P. (2003) · Current Opinion in Colloid & Interface Science · doi:10.1016/s1359-0294(03)00011-6 · Cited by 245
Kongkhlang, T., Tashiro, K., Kotaki, M., & Chirachanchai, S. (2008) · Journal of the American Chemical Society · doi:10.1021/ja804185s · Cited by 238
Dzenis, Y. (2008) · Science · doi:10.1126/science.1151434 · Cited by 230
Self-citationMechanical properties of single electrospun drug-encapsulated nanofibres
Chew, S. Y., Hufnagel, T. C., Lim, C. T., & Leong, K. W. (2006) · Nanotechnology · doi:10.1088/0957-4484/17/15/045 · Cited by 206
Physical properties of a single polymeric nanofiber
Tan, E. P. S., & Lim, C. T. (2004) · Applied Physics Letters · doi:10.1063/1.1651643 · Cited by 199
Naraghi, M., Arshad, S. N., & Chasiotis, I. (2011) · Polymer · doi:10.1016/j.polymer.2011.02.013 · Cited by 162
Investigation of the nanofibrils of silk fibers
Putthanarat, S., Stribeck, N., Fossey, S. A., et al. (2000) · Polymer · doi:10.1016/s0032-3861(00)00036-7 · Cited by 154
Pai, C., Boyce, M. C., & Rutledge, G. C. (2011) · Polymer · doi:10.1016/j.polymer.2011.03.041 · Cited by 139
High-speed fiber spinning : science and engineering aspects
(1991) · Cited by 108
Naraghi, M., Chasiotis, I., Kahn, H., et al. (2007) · Applied Physics Letters · doi:10.1063/1.2795799 · Cited by 89
Orientation studies in polyacrylonitrile films uniaxially drawn in the solid state
Bashir, Z., Tipping, A., & Church, S. P. (1994) · Polymer International · doi:10.1002/pi.1994.210330102 · Cited by 37
Cited by
Processing, structure, and properties of carbon fibers
Newcomb, B. A. (2016) · Composites Part A: Applied Science and Manufacturing · doi:10.1016/j.compositesa.2016.10.018 · Cited by 779
Commercial application of cellulose nano-composites – A review
Sharma, A., Thakur, M., Bhattacharya, M., Mandal, T., & Goswami, S. (2019) · Biotechnology Reports · doi:10.1016/j.btre.2019.e00316 · Cited by 762
Nanoparticles meet electrospinning: recent advances and future prospects
Zhang, C.-L., & Yu, S.-H. (2014) · Chemical Society Reviews · doi:10.1039/c3cs60426h · Cited by 665
Developments of Advanced Electrospinning Techniques: A Critical Review
Li, Y., Zhu, J., Cheng, H., Li, G., Cho, H., Jiang, M., Gao, Q., & Zhang, X. (2021) · Advanced Materials Technologies · doi:10.1002/admt.202100410 · Cited by 578
Electrospun nanofiber reinforced composites: a review
Jiang, S., Chen, Y., Duan, G., Mei, C., Greiner, A., & Agarwal, S. (2018) · Polymer Chemistry · doi:10.1039/c8py00378e · Cited by 560
Metadata
- Authors
- Papkov, D., Zou, Y., Andalib, M. N., Goponenko, A., Cheng, S. Z. D., & Dzenis, Y. A.
- Venue
- ACS Nano
- Publisher
- American Chemical Society (ACS)
- Published
- 2013-03-20
- Volume
- 7
- Issue
- 4
- Pages
- 3324-3331
- ISSN
- 1936-0851 (ISSN-L)
- 1936-086X
- OpenAlex
- W2055762937
- Cited by
- 299
- References
- 26
- FWCI
- 9.82
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.