The DOI matches its Crossref record; 37 of the 37 references it cites were found in a registry or an index.
Highly Conducting, Strong Nanocomposites Based on Nanocellulose-Assisted Aqueous Dispersions of Single-Wall Carbon Nanotubes
Abstract
It is challenging to obtain high-quality dispersions of single-wall nanotubes (SWNTs) in composite matrix materials, in order to reach the full potential of mechanical and electronic properties. The most widely used matrix materials are polymers, and the route to achieving high quality dispersions of SWNT is mainly chemical functionalization of the SWNT. This leads to increased cost, a loss of strength and lower conductivity. In addition full potential of colloidal self-assembly cannot be fully exploited in a polymer matrix. This may limit the possibilities for assembly of highly ordered structural nanocomposites. Here we show that nanofibrillated cellulose (NFC) can act as an excellent aqueous dispersion agent for as-prepared SWNTs, making possible low-cost exfoliation and purification of SWNTs with dispersion limits exceeding 40 wt %. The NFC:SWNT dispersion may also offer a cheap and sustainable alternative for molecular self-assembly of advanced composites. We demonstrate semitransparent conductive films, aerogels and anisotropic microscale fibers with nanoscale composite structure. The NFC:SWNT nanopaper shows increased strength at 3 wt % SWNT, reaching a modulus of 13.3 GPa, and a strength of 307 MPa. The anisotropic microfiber composites have maximum conductivities above 200 S cm(-1) and current densities reaching 1400 A cm(-2).
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Cellulose nanomaterials review: structure, properties and nanocomposites
Moon, R. J., Martini, A., Nairn, J., Simonsen, J., & Youngblood, J. (2011) · Chemical Society Reviews · doi:10.1039/c0cs00108b · Cited by 6,756
Carbon Nanotubes: Present and Future Commercial Applications
De Volder, M. F. L., Tawfick, S. H., Baughman, R. H., & Hart, A. J. (2013) · Science · doi:10.1126/science.1222453 · Cited by 5,587
Exceptionally high Young's modulus observed for individual carbon nanotubes
Treacy, M. M. J., Ebbesen, T. W., & Gibson, J. M. (1996) · Nature · doi:10.1038/381678a0 · Cited by 5,428
The path to ubiquitous and low-cost organic electronic appliances on plastic
Forrest, S. R. (2004) · Nature · doi:10.1038/nature02498 · Cited by 5,165
Nanobeam Mechanics: Elasticity, Strength, and Toughness of Nanorods and Nanotubes
Wong, E. W., Sheehan, P. E., & Lieber, C. M. (1997) · Science · doi:10.1126/science.277.5334.1971 · Cited by 4,810
Nanocelluloses: A New Family of Nature‐Based Materials
Klemm, D., Kramer, F., Moritz, S., Lindström, T., Ankerfors, M., Gray, D., & Dorris, A. (2011) · Angewandte Chemie International Edition · doi:10.1002/anie.201001273 · Cited by 4,465
Polymer nanocomposites based on functionalized carbon nanotubes
Sahoo, N. G., Rana, S., Cho, J. W., Li, L., & Chan, S. H. (2010) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2010.03.002 · Cited by 1,670
Strong, Light, Multifunctional Fibers of Carbon Nanotubes with Ultrahigh Conductivity
Behabtu, N., Young, C. C., Tsentalovich, D. E., Kleinerman, O., Wang, X., Ma, A. W. K., Bengio, E. A., ter Waarbeek, R. F., de Jong, J. J., Hoogerwerf, R. E., et al. (2013) · Science · doi:10.1126/science.1228061 · Cited by 1,354
Transparent and high gas barrier films of cellulose nanofibers prepared by TEMPO-mediated oxidation
Fukuzumi, H., Saito, T., Iwata, T., Kumamoto, Y., & Isogai, A. (2009) · Biomacromolecules · doi:10.1021/bm801065u · Cited by 1,271
Percolation in Transparent and Conducting Carbon Nanotube Networks
Hu, L., Hecht, D. S., & Grüner, G. (2004) · Nano Letters · doi:10.1021/nl048435y · Cited by 1,128
Cited by
Advanced Carbon for Flexible and Wearable Electronics
Wang, C., Xia, K., Wang, H., Liang, X., Yin, Z., & Zhang, Y. (2019) · Advanced Materials · doi:10.1002/adma.201801072 · Cited by 1,300
Advanced Materials through Assembly of Nanocelluloses
Kontturi, E., Laaksonen, P., Linder, M. B., Nonappa, Gröschel, A. H., Rojas, O. J., & Ikkala, O. (2018) · Advanced Materials · doi:10.1002/adma.201703779 · Cited by 664
Superstructured Assembly of Nanocarbons: Fullerenes, Nanotubes, and Graphene
Li, Z., Liu, Z., Sun, H., & Gao, C. (2015) · Chemical Reviews · doi:10.1021/acs.chemrev.5b00102 · Cited by 554
Zeng, X., Sun, J., Yao, Y., Sun, R., Xu, J.-B., & Wong, C.-P. (2017) · ACS Nano · doi:10.1021/acsnano.7b02359 · Cited by 523
Usov, I., Nyström, G., Adamcik, J., Handschin, S., Schütz, C., Fall, A., Bergström, L., & Mezzenga, R. (2015) · Nature Communications · doi:10.1038/ncomms8564 · Cited by 498
Self-citationRecent Development of Carbon Nanotube Transparent Conductive Films
Yu, L., Shearer, C., & Shapter, J. (2016) · Chemical Reviews · doi:10.1021/acs.chemrev.6b00179 · Cited by 498
Use of nanocellulose in printed electronics: a review
Hoeng, F., Denneulin, A., & Bras, J. (2016) · Nanoscale · doi:10.1039/c6nr03054h · Cited by 459
A Review of the Synthesis and Applications of Polymer–Nanoclay Composites
Guo, F., Aryana, S., Han, Y., & Jiao, Y. (2018) · Applied Sciences · doi:10.3390/app8091696 · Cited by 445
Cellulose Nanopaper: Fabrication, Functionalization, and Applications
Liu, W., Liu, K., Du, H., Zheng, T., Zhang, N., Xu, T., Pang, B., Zhang, X., Si, C., & Zhang, K. (2022) · Nano-Micro Letters · doi:10.1007/s40820-022-00849-x · Cited by 435
Du, X., Zhang, Z., Liu, W., & Deng, Y. (2017) · Nano Energy · doi:10.1016/j.nanoen.2017.04.001 · Cited by 426
Han, J., Wang, H., Yue, Y., Mei, C., Chen, J., Huang, C., Wu, Q., & Xu, X. (2019) · Carbon · doi:10.1016/j.carbon.2019.04.029 · Cited by 375
Yin, R., Yang, S., Li, Q., Zhang, S., Liu, H., Han, J., Liu, C., & Shen, C. (2020) · Science Bulletin · doi:10.1016/j.scib.2020.02.020 · Cited by 322
Dispersion Properties of Nanocellulose: A Review
Chu, Y., Sun, Y., Wu, W., & Xiao, H. (2020) · Carbohydrate Polymers · doi:10.1016/j.carbpol.2020.116892 · Cited by 313
Cellulose composite aerogel for highly efficient electromagnetic interference shielding
Huang, H.-D., Liu, C.-Y., Zhou, D., Jiang, X., Zhong, G.-J., Yan, D.-X., & Li, Z.-M. (2015) · Journal of Materials Chemistry A · doi:10.1039/c4ta05998k · Cited by 306
Understanding the Dispersive Action of Nanocellulose for Carbon Nanomaterials
Hajian, A., Lindström, S. B., Pettersson, T., Hamedi, M. M., & Wågberg, L. (2017) · Nano Letters · doi:10.1021/acs.nanolett.6b04405 · Cited by 293
Self-citationZhao, D., Zhang, Q., Chen, W., Yi, X., Liu, S., Wang, Q., Liu, Y., Li, J., Li, X., & Yu, H. (2017) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.7b01852 · Cited by 285
A Janus evaporator with low tortuosity for long-term solar desalination
Hu, R., Zhang, J., Kuang, Y., Wang, K., Cai, X., Fang, Z., Huang, W., Chen, G., & Wang, Z. (2019) · Journal of Materials Chemistry A · doi:10.1039/c9ta01576k · Cited by 266
Zhao, H.-B., Yuan, L., Fu, Z.-B., Wang, C.-Y., Yang, X., Zhu, J.-Y., Qu, J., Chen, H.-B., & Schiraldi, D. A. (2016) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.6b00510 · Cited by 99
Metadata
- Authors
- Hamedi, M. M., Hajian, A., Fall, A. B., Håkansson, K., Salajkova, M., Lundell, F., Wågberg, L., & Berglund, L. A.
- Venue
- ACS Nano
- Publisher
- American Chemical Society (ACS)
- Published
- 2014-02-14
- Volume
- 8
- Issue
- 3
- Pages
- 2467-2476
- ISSN
- 1936-0851 (ISSN-L)
- 1936-086X
- OpenAlex
- W2058881477
- Cited by
- 381
- References
- 37
- FWCI
- 15.04
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.