The DOI matches its Crossref record; 22 of the 22 references it cites were found in a registry or an index.
Numerical simulations of granular shear zones using the distinct element method: 1. Shear zone kinematics and the micromechanics of localization
Open accessAbstract
Two‐dimensional numerical simulations were conducted using the distinct element method (DEM) to examine the influences of particle size distribution (PSD) and interparticle friction μp on the nature of deformation in granular fault gouge. Particle fracture was not allowed in this implementation but points in PSD space were examined by constructing assemblages of particles with self‐similar size distributions defined by the two‐dimensional power law exponent D. For these numerical “experiments,” D ranged from 0.81 to 2.60, where D=1.60 represents the two‐dimensional equivalent of a characteristic PSD to which cataclastically deforming gouge is thought to evolve. Experiments presented here used μp values of 0.10 and 0.50 and were conducted using normal stress σn on the shear zone walls of 70 MPa. Shear strain within these simulated assemblages was accommodated by intermittent displacement along discrete slip surfaces, alternating between broadly distributed deformation along multiple slip planes and highly localized deformation along a single, sharply defined, subhorizontal zone of slip. Slip planes corresponded in orientation and sense of shear to shear structures observed in natural gouge zones, specifically Riedel and Y shears; the oblique Riedel shears showed more extreme orientations than typical, but their geometries were consistent with those predicted for low‐strength Coulomb materials. The character of deformation in the shear zone varied with PSD due to changes in the relative importance of interparticle slip and rolling as deformation mechanisms. A high degree of frictional coupling between large rolling particles in low D (coarse‐grained) assemblages resulted in wide zones of slip and broadly distributed deformation. In higher D assemblages (D >= 1.60), small rolling particles self‐organized into columns that separated large rolling particles, causing a reduction in frictional resistance within the deforming assemblage. This unusual particle configuration appears to depend on a critical abundance of small particles achieved at D ≈ 1.60 and may enable strain localization in both real and simulated granular assemblages.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A discrete numerical model for granular assemblies
Cundall, P. A., & Strack, O. D. L. (1979) · Géotechnique · doi:10.1680/geot.1979.29.1.47 · Cited by 17,527
Johnson, K. L. (1985) · Cambridge University Press eBooks · doi:10.1017/cbo9781139171731 · Cited by 7,796
Byerlee, J. (1978) · pure and applied geophysics · doi:10.1007/bf00876528 · Cited by 4,029
The mechanics of earthquakes and faulting
(1990) · Choice Reviews Online · doi:10.5860/choice.28-1579 · Cited by 3,569
A computer model for simulating progressive, large scale movement in blocky rock systems
Cundall, P. A. (1971) · Cited by 2,019
Turcotte, D. L. (1986) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb091ib02p01921 · Cited by 1,236
Wong, T., David, C., & Zhu, W. (1997) · Journal of Geophysical Research: Solid Earth · doi:10.1029/96jb03281 · Cited by 897
The mechanics of earthquakes and faulting
Savage, J. C. (1991) · Physics of the Earth and Planetary Interiors · doi:10.1016/0031-9201(91)90167-g · Cited by 750
NUMERICAL MODELLING OF DISCONTINUA
CUNDALL, P. A., & HART, R. D. (1992) · Engineering Computations · doi:10.1108/eb023851 · Cited by 674
Frictional behavior and constitutive modeling of simulated fault gouge
Marone, C., Raleigh, C. B., & Scholz, C. H. (1990) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb095ib05p07007 · Cited by 630
Constitutive Properties of Faults With Simulated Gouge
Dieterich, J. H. (2013) · Geophysical Monograph Series · doi:10.1029/gm024p0103 · Cited by 488
Fullsack, P. (1995) · Geophysical Journal International · doi:10.1111/j.1365-246x.1995.tb05908.x · Cited by 316
Wear and gouge formation in brittle faulting
Scholz, C. H. (1987) · Geology · doi:10.1130/0091-7613(1987)15<493:wagfib>2.0.co;2 · Cited by 315
Computer Simulations of Dense Sphere Assemblies
CUNDALL, P. A. (1988) · Studies in Applied Mechanics · doi:10.1016/b978-0-444-70523-5.50021-7 · Cited by 248
Self-similar cataclasis in the formation of fault gouge
Sammis, C. G., Osborne, R. H., Anderson, J. L., Banerdt, M., & White, P. (1986) · pure and applied geophysics · doi:10.1007/bf00875719 · Cited by 229
Computer simulated deformation of compact granular assemblies
Thornton, C., & Barnes, D. J. (1986) · Acta Mechanica · doi:10.1007/bf01180097 · Cited by 194
Deformation and failure of granular materials.
Matsuoka, H. (1988) · Journal of the Society of Powder Technology Japan · doi:10.4164/sptj.25.462 · Cited by 192
Morgan, J. K. (1999) · Journal of Geophysical Research: Solid Earth · doi:10.1029/1998jb900055 · Cited by 186
Self-citationModeling of Microscopic Mechanisms in Granular Material
CUNDALL, P. A., & STRACK, O. D. L. (1983) · Studies in Applied Mechanics · doi:10.1016/b978-0-444-42192-0.50018-9 · Cited by 164
Seismicity and stress rotation in a granular model of the brittle crust
Scott, D. R. (1996) · Nature · doi:10.1038/381592a0 · Cited by 136
Distinct element modeling of deformation bands in sandstone
Antonellini, M. A., & Pollard, D. D. (1995) · Journal of Structural Geology · doi:10.1016/0191-8141(95)00001-t · Cited by 113
Dynamic and kinematic growth and change of a Coulomb wedge
Willett, S. D. (1992) · Thrust Tectonics · doi:10.1007/978-94-011-3066-0_2 · Cited by 85
Cited by
Billi, A., Salvini, F., & Storti, F. (2003) · Journal of Structural Geology · doi:10.1016/s0191-8141(03)00037-3 · Cited by 355
Micromechanical modeling of cracking and failure in brittle rocks
Hazzard, J. F., Young, R. P., & Maxwell, S. C. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2000jb900085 · Cited by 285
Noda, H., Dunham, E. M., & Rice, J. R. (2009) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2008jb006143 · Cited by 283
Discrete element method for modelling solid and particulate materials
Tavarez, F. A., & Plesha, M. E. (2007) · International Journal for Numerical Methods in Engineering · doi:10.1002/nme.1881 · Cited by 222
Metadata
- Authors
- Morgan, J. K., & Boettcher, M. S.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1999-02-10
- Volume
- 104
- Issue
- B2
- Pages
- 2703-2719
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W1984040668
- Cited by
- 269
- References
- 22
- FWCI
- 6.69
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.