The DOI matches its Crossref record; 5 of the 5 references it cites were found in a registry or an index.
Understanding Cloud and Convective Characteristics in Version 1 of the E3SM Atmosphere Model
Open accessAbstract
This study provides comprehensive insight into the notable differences in clouds and precipitation simulated by the Energy Exascale Earth System Model Atmosphere Model version 0 and version 1 (EAMv1). Several sensitivity experiments are conducted to isolate the impact of changes in model physics, resolution, and parameter choices on these differences. The overall improvement in EAMv1 clouds and precipitation is primarily attributed to the introduction of a simplified third‐order turbulence parameterization Cloud Layers Unified By Binormals (along with the companion changes) for a unified treatment of boundary layer turbulence, shallow convection, and cloud macrophysics, though it also leads to a reduction in subtropical coastal stratocumulus clouds. This lack of stratocumulus clouds is considerably improved by increasing vertical resolution from 30 to 72 layers, but the gain is unfortunately subsequently offset by other retuning to reach the top‐of‐atmosphere energy balance. Increasing vertical resolution also results in a considerable underestimation of high clouds over the tropical warm pool, primarily due to the selection for numerical stability of a higher air parcel launch level in the deep convection scheme. Increasing horizontal resolution from 1° to 0.25° without retuning leads to considerable degradation in cloud and precipitation fields, with much weaker tropical and subtropical short‐ and longwave cloud radiative forcing and much stronger precipitation in the intertropical convergence zone, indicating poor scale awareness of the cloud parameterizations. To avoid this degradation, significantly different parameter settings for the low‐resolution (1°) and high‐resolution (0.25°) were required to achieve optimal performance in EAMv1.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Lamarque, J.-F., Bond, T. C., Eyring, V., Granier, C., Heil, A., Klimont, Z., Lee, D., Liousse, C., Mieville, A., Owen, B., et al. (2010) · Atmospheric Chemistry and Physics · doi:10.5194/acp-10-7017-2010 · Cited by 2,105 · cited 1×
“Six-year AMIP-style climatology runs with present-day forcing from the IPCC AR5 emission data set (Lamarque et al., 2010) for year 2000 with 1° resolution configurations are conducted using present-day emissions along with climatological sea surface temperature and sea ice prescribed from the observations (repeating s…”
Liu, X., Ma, P.-L., Wang, H., Tilmes, S., Singh, B., Easter, R. C., Ghan, S. J., & Rasch, P. J. (2016) · Geoscientific Model Development · doi:10.5194/gmd-9-505-2016 · Cited by 671
Self-citationThe Art and Science of Climate Model Tuning
Hourdin, F., Mauritsen, T., Gettelman, A., Golaz, J.-C., Balaji, V., Duan, Q., Folini, D., Ji, D., Klocke, D., Qian, Y., et al. (2017) · Bulletin of the American Meteorological Society · doi:10.1175/bams-d-15-00135.1 · Cited by 611
Self-citationKato, S., Loeb, N. G., Rose, F. G., Doelling, D. R., Rutan, D. A., Caldwell, T. E., Yu, L., & Weller, R. A. (2013) · Journal of Climate · doi:10.1175/jcli-d-12-00436.1 · Cited by 437
The ‘too few, too bright’ tropical low-cloud problem in CMIP5 models.
Nam, C., Bony, S., Dufresne, J. ‐., & Chepfer, H. (2012) · Geophysical Research Letters · doi:10.1029/2012gl053421 · Cited by 375
Cited by
The DOE E3SM Coupled Model Version 1: Overview and Evaluation at Standard Resolution
Golaz, J., Caldwell, P. M., Van Roekel, L. P., Petersen, M. R., Tang, Q., Wolfe, J. D., Abeshu, G., Anantharaj, V., Asay‐Davis, X. S., Bader, D. C., et al. (2019) · Journal of Advances in Modeling Earth Systems · doi:10.1029/2018ms001603 · Cited by 825
Self-citationThe DOE E3SM Model Version 2: Overview of the Physical Model and Initial Model Evaluation
Golaz, J., Van Roekel, L. P., Zheng, X., Roberts, A. F., Wolfe, J. D., Lin, W., Bradley, A. M., Tang, Q., Maltrud, M. E., Forsyth, R. M., et al. (2022) · Journal of Advances in Modeling Earth Systems · doi:10.1029/2022ms003156 · Cited by 371
Self-citationAn Overview of the Atmospheric Component of the Energy Exascale Earth System Model
Rasch, P. J., Xie, S., Ma, P. ‐., Lin, W., Wang, H., Tang, Q., Burrows, S. M., Caldwell, P., Zhang, K., Easter, R. C., et al. (2019) · Journal of Advances in Modeling Earth Systems · doi:10.1029/2019ms001629 · Cited by 345
Self-citationThe DOE E3SM Coupled Model Version 1: Description and Results at High Resolution
Caldwell, P. M., Mametjanov, A., Tang, Q., Van Roekel, L. P., Golaz, J., Lin, W., Bader, D. C., Keen, N. D., Feng, Y., Jacob, R., et al. (2019) · Journal of Advances in Modeling Earth Systems · doi:10.1029/2019ms001870 · Cited by 267
Self-citation
Metadata
- Authors
- Xie, S., Lin, W., Rasch, P. J., Ma, P., Neale, R., Larson, V. E., Qian, Y., Bogenschutz, P. A., Caldwell, P., Cameron‐Smith, P., Golaz, J., Mahajan, S., Singh, B., Tang, Q., Wang, H., Yoon, J., Zhang, K., & Zhang, Y.
- Venue
- Journal of Advances in Modeling Earth Systems
- Publisher
- American Geophysical Union (AGU)
- Published
- 2018-10
- Volume
- 10
- Issue
- 10
- Pages
- 2618-2644
- ISSN
- 1942-2466 (ISSN-L)
- OpenAlex
- W2895729600
- Cited by
- 212
- References
- 5
- FWCI
- 7.50
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.