CoChat

High-speed colour-converting photodetector with all-inorganic CsPbBr3 perovskite nanocrystals for ultraviolet light communication

Open access

The DOI matches its Crossref record; 47 of the 49 references it cites were found in a registry or an index.

Abstract

Optical wireless communication (OWC) using the ultra-broad spectrum of the visible-to-ultraviolet (UV) wavelength region remains a vital field of research for mitigating the saturated bandwidth of radio-frequency (RF) communication. However, the lack of an efficient UV photodetection methodology hinders the development of UV-based communication. The key technological impediment is related to the low UV-photon absorption in existing silicon photodetectors, which offer low-cost and mature platforms. To address this technology gap, we report a hybrid Si-based photodetection scheme by incorporating CsPbBr 3 perovskite nanocrystals (NCs) with a high photoluminescence quantum yield (PLQY) and a fast photoluminescence (PL) decay time as a UV-to-visible colour-converting layer for high-speed solar-blind UV communication. The facile formation of drop-cast CsPbBr 3 perovskite NCs leads to a high PLQY of up to ~73% and strong absorption in the UV region. With the addition of the NC layer, a nearly threefold improvement in the responsivity and an increase of ~25% in the external quantum efficiency (EQE) of the solar-blind region compared to a commercial silicon-based photodetector were observed. Moreover, time-resolved photoluminescence measurements demonstrated a decay time of 4.5 ns under a 372-nm UV excitation source, thus elucidating the potential of this layer as a fast colour-converting layer. A high data rate of up to 34 Mbps in solar-blind communication was achieved using the hybrid CsPbBr 3–silicon photodetection scheme in conjunction with a 278-nm UVC light-emitting diode (LED). These findings demonstrate the feasibility of an integrated high-speed photoreceiver design of a composition-tuneable perovskite-based phosphor and a low-cost silicon-based photodetector for UV communication.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1038/s41377-019-0204-4

Cites

47 of 47 references verified0 citation errors · 0 not checkable

Statistics

Figures

Fig. 1 Structural and optical characterisation of CsPbBr3 perovskite NCs. a Transmission electron microscopy (TEM) image and b high-resolution TEM image of CsPbBr3 perovskite NCs. c Absorption and photoluminescence spectra, as well as d time-resolved PL decay trace monitored at 506 nm following 372 nm excitation for the drop-cast CsPbBr3 perovskite NCs on a UV quartz substrate
Fig. 1 Structural and optical characterisation of CsPbBr3 perovskite NCs. a Transmission electron microscopy (TEM) image and b high-resolution TEM image of CsPbBr3 perovskite NCs. c Absorption and photoluminescence spectra, as well as d time-resolved PL decay trace monitored at 506 nm following 372 nm excitation for the drop-cast CsPbBr3 perovskite NCs on a UV quartz substrateCC BY · PubMed Central
Fig. 2 Novel photodetection scheme based on the hybrid CsPbBr3-Si platform. a Drop-cast CsPbBr3 perovskite NC layer on UV quartz under UV illumination. b Schematic illustration of the photoelectrical measurement setup of the Si-based PD with a CsPbBr3 perovskite NC layer on UV quartz inside the integrating sphere. c Measured responsivity spectrum of the bare Si-based PD
Fig. 2 Novel photodetection scheme based on the hybrid CsPbBr3-Si platform. a Drop-cast CsPbBr3 perovskite NC layer on UV quartz under UV illumination. b Schematic illustration of the photoelectrical measurement setup of the Si-based PD with a CsPbBr3 perovskite NC layer on UV quartz inside the integrating sphere. c Measured responsivity spectrum of the bare Si-based PDCC BY · PubMed Central
Fig. 3 Performance of the hybrid CsPbBr3–Si photodetection scheme. a I–V curves of the Si-based PD with reverse bias from 0 to 20 V. The dark current is represented by the black line, while the red line represents the I–V curves with a 270-nm incident wavelength (λin), and the purple line represents the I–V curves with a 510-nm incident wavelength. The enhanced photocurrent due to the down-conversion process of CsPbBr3 NCs measured with and without a 500-nm long-pass (LP) filter when excited by a 270-nm incident wavelength is represented by the green and cyan lines, respectively. b Comparison of the responsivity spectrum and c external quantum efficiency (EQE) for the bare Si-based PD and Si-based PD with the CsPbBr3 perovskite NC layer. The inset of b shows a schematic illustration of the photon conversion behaviour with an LP filter mounted between the CsPbBr3 layer in the integrating sphere and the Si-based PD (Pin: incident light power, λVIS: visible-wavelength photons, λUV: UV-wavelength photons). d Specific detectivity (D*) and noise equivalent power (NEP) of the hybrid CsPbBr3–Si photodetection scheme in the UV wavelength region
Fig. 3 Performance of the hybrid CsPbBr3–Si photodetection scheme. a I–V curves of the Si-based PD with reverse bias from 0 to 20 V. The dark current is represented by the black line, while the red line represents the I–V curves with a 270-nm incident wavelength (λin), and the purple line represents the I–V curves with a 510-nm incident wavelength. The enhanced photocurrent due to the down-conversion process of CsPbBr3 NCs measured with and without a 500-nm long-pass (LP) filter when excited by a 270-nm incident wavelength is represented by the green and cyan lines, respectively. b Comparison of the responsivity spectrum and c external quantum efficiency (EQE) for the bare Si-based PD and Si-based PD with the CsPbBr3 perovskite NC layer. The inset of b shows a schematic illustration of the photon conversion behaviour with an LP filter mounted between the CsPbBr3 layer in the integrating sphere and the Si-based PD (Pin: incident light power, λVIS: visible-wavelength photons, λUV: UV-wavelength photons). d Specific detectivity (D*) and noise equivalent power (NEP) of the hybrid CsPbBr3–Si photodetection scheme in the UV wavelength regionCC BY · PubMed Central
Fig. 4 Modulation bandwidth measurement using CsPbBr3 perovskite NCs. a Schematic diagram of the small-signal frequency response measurement setup using a 375-nm UV laser diode (LD) and a Si-based avalanche photodiode (APD) to obtain the results in (b). b The normalised frequency response of the UV LD and APD without CsPbBr3 perovskite NCs and a 500-nm long-pass filter is shown by the black line. The red line shows the frequency response of CsPbBr3 perovskite NCs measured using the UV LD and APD with the UV light filtered by a 500-nm long-pass filter
Fig. 4 Modulation bandwidth measurement using CsPbBr3 perovskite NCs. a Schematic diagram of the small-signal frequency response measurement setup using a 375-nm UV laser diode (LD) and a Si-based avalanche photodiode (APD) to obtain the results in (b). b The normalised frequency response of the UV LD and APD without CsPbBr3 perovskite NCs and a 500-nm long-pass filter is shown by the black line. The red line shows the frequency response of CsPbBr3 perovskite NCs measured using the UV LD and APD with the UV light filtered by a 500-nm long-pass filterCC BY · PubMed Central
Fig. 5 Data transmission measurement using CsPbBr3 perovskite NCs. a Schematic diagram of the data transmission measurement setup with an on-off keying (OOK) modulation scheme using a solar-blind 278-nm UVC LED and a Si-based APD. b Bit-error rate (BER) of data transmission at different data rates without a CsPbBr3 perovskite NC layer and a 500-nm long-pass filter. For comparison, an optical density (OD) filter was added to ensure that the optical power illuminating the APD is the same as that in the case of CsPbBr3 perovskite NCs and is below the saturation limit of the APD. The insets show the corresponding eye diagrams. c BER of data transmission at different data rates with the colour-converting CsPbBr3 perovskite NC layer and UV light filtered by a 500-nm long-pass filter. The insets show the corresponding eye diagrams
Fig. 5 Data transmission measurement using CsPbBr3 perovskite NCs. a Schematic diagram of the data transmission measurement setup with an on-off keying (OOK) modulation scheme using a solar-blind 278-nm UVC LED and a Si-based APD. b Bit-error rate (BER) of data transmission at different data rates without a CsPbBr3 perovskite NC layer and a 500-nm long-pass filter. For comparison, an optical density (OD) filter was added to ensure that the optical power illuminating the APD is the same as that in the case of CsPbBr3 perovskite NCs and is below the saturation limit of the APD. The insets show the corresponding eye diagrams. c BER of data transmission at different data rates with the colour-converting CsPbBr3 perovskite NC layer and UV light filtered by a 500-nm long-pass filter. The insets show the corresponding eye diagramsCC BY · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 47 references

Cited by

See all 339

Metadata

Authors
Kang, C. H., Dursun, I., Liu, G., Sinatra, L., Sun, X., Kong, M., Pan, J., Maity, P., Ooi, E.-N., Ng, T. K., Mohammed, O. F., Bakr, O. M., & Ooi, B. S.
Affiliations
King Abdullah University of Science and Technology (SA)
Corresponding author
  • Bakr, Osman M.
  • Ooi, Boon S.
Venue
Light: Science & Applications
Published
2019-10-16
Volume
8
Issue
1
Pages
94-94
ISSN
2047-7538 (ISSN-L)
OpenAlex
W2980352457
Cited by
329
References
49
Citations by year
2026: 25 · 2025: 34 · 2024: 44 · 2023: 49 · 2022: 68 · 2021: 61 · 2020: 46 · 2019: 2
FWCI
15.91
Type
journal article
Language
en
Open access
Licence
Locations
  • Light Science & Applications (publishedVersion, cc-by)
  • Europe PMC (PubMed Central) (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion)
  • King Abdullah University of Science and Technology Repository (King Abdullah University of Science and Technology) (submittedVersion)
Funders
  • King Abdullah University of Science and Technology (BAS/1/1614-01-01, KCR/1/2081-01-01, GEN/1/6607-01-01, REP/1/2878-01-01)
  • King Abdulaziz City for Science and Technology (KACST TIC R2-FP-008)
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Optical Wireless Communication Technologies
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Perovskite Materials and Applications
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Photonic and Optical Devices
Keywords
CsPbBr3 perovskite nanocrystals, optical wireless communication, photoluminescence quantum yield, photoluminescence decay time, external quantum efficiency, perovskite phosphors, UV-C LEDs, photoreceiver, high-speed data transmission

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: High-speed colour-converting photodetector with all-inorganic CsPbBr3 perovskite nanocrystals for ultraviolet light communication. https://app.cochat.ai/papers/10.1038/s41377-019-0204-4
The paper
Kang, C. H., Dursun, I., Liu, G., Sinatra, L., Sun, X., Kong, M., Pan, J., Maity, P., Ooi, E.-N., Ng, T. K., Mohammed, O. F., Bakr, O. M., & Ooi, B. S. (2019). High-speed colour-converting photodetector with all-inorganic CsPbBr3 perovskite nanocrystals for ultraviolet light communication. Light: Science & Applications. https://doi.org/10.1038/s41377-019-0204-4

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.