The DOI matches its Crossref record; 16 of the 16 references it cites were found in a registry or an index.
Intercalation and exfoliation routes to graphite nanoplatelets
Abstract
Graphite nanoplatelets with thicknesses down to 2–10 nm are synthesized by alkali metal intercalation followed by ethanol exfoliation and microwave drying. Graphite that has already been intercalated and exfoliated with an oxidizing acid is reintercalated with an alkali metal to form a first stage compound, as confirmed by powder X-ray diffraction. This can be achieved either by heating graphite and potassium or caesium at 200 °C, or at room temperature using a sodium–potassium alloy. Reaction of the intercalated graphite with ethanol causes exfoliation of the graphene layers. Microwave radiation aids in drying and results in further separation of the sheets. Thermogravimetric analysis indicates that the graphite nanoplatelets are approximately 150 °C less stable in air than pristine graphite. High aspect ratio graphite nanoplatelets offer promise as reinforcements for high strength carbon–carbon composites.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Alexandre, M., & Dubois, P. (2000) · Materials Science and Engineering: R: Reports · doi:10.1016/s0927-796x(00)00012-7 · Cited by 6,377
A route to high surface area, porosity and inclusion of large molecules in crystals
Materials Design and Discovery Group, Chae, H. K., Siberio-Pérez, D. Y., Kim, J., Go, Y., Eddaoudi, M., Matzger, A. J., O'Keeffe, M., & Yaghi, O. M. (2004) · Nature · doi:10.1038/nature02311 · Cited by 2,816
Load transfer and deformation mechanisms in carbon nanotube-polystyrene composites
Qian, D., Dickey, E. C., Andrews, R., & Rantell, T. (2000) · Applied Physics Letters · doi:10.1063/1.126500 · Cited by 2,455
Mechanical properties of nylon 6-clay hybrid
Kojima, Y., Usuki, A., Kawasumi, M., Okada, A., Fukushima, Y., Kurauchi, T., & Kamigaito, O. (1993) · Journal of Materials Research · doi:10.1557/jmr.1993.1185 · Cited by 2,442
Synthesis of nylon 6-clay hybrid
Usuki, A., Kojima, Y., Kawasumi, M., Okada, A., Fukushima, Y., Kurauchi, T., & Kamigaito, O. (1993) · Journal of Materials Research · doi:10.1557/jmr.1993.1179 · Cited by 2,203
Specific surface area of carbon nanotubes and bundles of carbon nanotubes
Peigney, A., Laurent, C., Flahaut, E., Bacsa, R. R., & Rousset, A. (2001) · Carbon · doi:10.1016/s0008-6223(00)00155-x · Cited by 2,040
The role of carbon materials in heterogeneous catalysis
Rodríguez-reinoso, F. (1998) · Carbon · doi:10.1016/s0008-6223(97)00173-5 · Cited by 1,760
Load transfer in carbon nanotube epoxy composites
Schadler, L. S., Giannaris, S. C., & Ajayan, P. M. (1998) · Applied Physics Letters · doi:10.1063/1.122911 · Cited by 1,657
Single-Walled Carbon Nanotube-Polymer Composites: Strength and Weakness
Ajayan, P. M., Schadler, L. S., Giannaris, C., & Rubio, A. (2000) · Advanced Materials · doi:10.1002/(sici)1521-4095(200005)12:10<750::aid-adma750>3.0.co;2-6 · Cited by 1,435
Fabrication and Characterization of Carbon Nanotube/Poly(vinyl alcohol) Composites
Shaffer, M. S. P., & Windle, A. H. (1999) · Advanced Materials · doi:10.1002/(sici)1521-4095(199908)11:11<937::aid-adma937>3.0.co;2-9 · Cited by 1,184
Hydrogen adsorption and cohesive energy of single-walled carbon nanotubes
Ye, Y., Ahn, C. C., Witham, C., Fultz, B., Liu, J., Rinzler, A. G., Colbert, D., Smith, K. A., & Smalley, R. E. (1999) · Applied Physics Letters · doi:10.1063/1.123833 · Cited by 904
A Chemical Route to Carbon Nanoscrolls
Viculis, L. M., Mack, J. J., & Kaner, R. B. (2003) · Science · doi:10.1126/science.1078842 · Cited by 814
Self-citationPolymer–clay nanocomposites: exfoliation of organophilic montmorillonite nanolayers in polystyrene
Fu, X., & Qutubuddin, S. (2001) · Polymer · doi:10.1016/s0032-3861(00)00385-2 · Cited by 614
Messersmith, P. B., & Giannelis, E. P. (1993) · Chemistry of Materials · doi:10.1021/cm00032a005 · Cited by 374
Synthesis of carbon nanostructures on nanocrystalline Ni–Ni3P catalyst supported by SiC whiskers
Ding, D., Wang, J., Cao, Z., & Dai, J. (2003) · Carbon · doi:10.1016/s0008-6223(02)00339-1 · Cited by 157
Effect of surface acidity of activated carbon on hydrogen storage
Agarwal, R. K., Noh, J. S., Schwarz, J. A., & Davini, P. (1987) · Carbon · doi:10.1016/0008-6223(87)90119-9 · Cited by 125
Cited by
Synthesis of graphene-based nanosheets via chemical reduction of exfoliated graphite oxide
Stankovich, S., Dikin, D. A., Piner, R. D., Kohlhaas, K. A., Kleinhammes, A., Jia, Y., Wu, Y., Nguyen, S. T., & Ruoff, R. S. (2007) · Carbon · doi:10.1016/j.carbon.2007.02.034 · Cited by 13,878
Two‐Dimensional Nanocrystals Produced by Exfoliation of Ti3AlC2
Naguib, M., Kurtoglu, M., Presser, V., Lu, J., Niu, J., Heon, M., Hultman, L., Gogotsi, Y., & Barsoum, M. W. (2011) · Advanced Materials · doi:10.1002/adma.201102306 · Cited by 11,855
Honeycomb Carbon: A Review of Graphene
Allen, M. J., Tung, V. C., & Kaner, R. B. (2010) · Chemical Reviews · doi:10.1021/cr900070d · Cited by 6,998
Self-citation25th Anniversary Article: MXenes: A New Family of Two‐Dimensional Materials
Naguib, M., Mochalin, V. N., Barsoum, M. W., & Gogotsi, Y. (2014) · Advanced Materials · doi:10.1002/adma.201304138 · Cited by 6,414
Recent Advances in Ultrathin Two-Dimensional Nanomaterials
Tan, C., Cao, X., Wu, X.-J., He, Q., Yang, J., Zhang, X., Chen, J., Zhao, W., Han, S., Nam, G.-H., et al. (2017) · Chemical Reviews · doi:10.1021/acs.chemrev.6b00558 · Cited by 5,100
Metadata
- Authors
- Viculis, L. M., Mack, J. J., Mayer, O. M., Hahn, H. T., & Kaner, R. B.
- Venue
- Journal of Materials Chemistry
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2005
- Volume
- 15
- Issue
- 9
- Pages
- 974
- ISSN
- 0959-9428 (ISSN-L)
- 1364-5501
- OpenAlex
- W2029442855
- Cited by
- 449
- References
- 16
- FWCI
- 5.24
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.