The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Thermoelectric and structural characterizations of individual electrodeposited bismuth telluride nanowires
Abstract
The thermoelectric properties and crystal structure of individual electrodeposited bismuth telluride nanowires (NWs) were characterized using a microfabricated measurement device and transmission electron microscopy. Annealing in hydrogen was used to obtain electrical contact between the NW and the supporting Pt electrodes. By fitting the measured Seebeck coefficient with a two-band model, the NW samples were determined to be highly n-type doped. Higher thermal conductivity and electrical conductivity were observed in a 52 nm diameter monocrystalline NW than a 55 nm diameter polycrystalline NW. The electron mobility of the monocrystalline NW was found to be about 19% lower than that of bulk crystal at a similar carrier concentration and about 2.5 times higher than that of the polycrystalline NW. The specularity parameter for electron scattering by the NW surface was determined to be about 0.7 and partially specular and partially diffuse, leading to a reduction in the electron mean-free path from 61 nm in the bulk to about 40 nm in the 52 nm NW. Because of the already short phonon mean-free path of about 3 nm in bulk bismuth telluride, diffuse phonon-surface scattering is expected to reduce the lattice thermal conductivity of the 52–55 nm diameter NWs by only about 20%, which is smaller than the uncertainty in the extracted lattice thermal conductivity based on the measured total thermal conductivity and calculated electron thermal conductivity. Although the lattice thermal conductivity of the polycrystalline NW is likely lower than the bulk values, the lower thermal conductivity observed in this polycrystalline sample is mainly caused by the lower electron concentration and mobility. For both samples, the thermoelectric figure of merit (ZT) increases with temperature and is about 0.1 at a temperature of 400 K. The low ZT compared to that of bulk crystals is mainly caused by a high doping level, suggesting the need for better control of the chemical composition in order to improve the ZT of the electrodeposited NWs. Moreover, bismuth telluride NWs with diameter less than 10 nm would be required for substantial suppression of the lattice thermal conductivity as well as experimental verification of theoretical predictions of power factor enhancement in quantum wires. Such stringent diameter requirement can be relaxed in other NW systems with longer bulk phonon mean-free path or smaller effective mass and thus longer electron wavelength than those in bulk bismuth telluride.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Shi, L., Li, D., Yu, C., Jang, W., Kim, D., Yao, Z., Kim, P., & Majumdar, A. (2003) · Journal of Heat Transfer · doi:10.1115/1.1597619 · Cited by 733
Self-citationMorelli, D. T., Heremans, J. P., & Slack, G. A. (2002) · Physical Review B · doi:10.1103/physrevb.66.195304 · Cited by 628
Cited by
Nanoscale thermal transport. II. 2003–2012
Cahill, D. G., Braun, P. V., Chen, G., Clarke, D. R., Fan, S., Goodson, K. E., Keblinski, P., King, W. P., Mahan, G. D., Majumdar, A., et al. (2014) · Applied Physics Reviews · doi:10.1063/1.4832615 · Cited by 1,763
Self-citation25th Anniversary Article: Semiconductor Nanowires – Synthesis, Characterization, and Applications
Dasgupta, N. P., Sun, J., Liu, C., Brittman, S., Andrews, S. C., Lim, J., Gao, H., Yan, R., & Yang, P. (2014) · Advanced Materials · doi:10.1002/adma.201305929 · Cited by 880
Nanostructured thermoelectric materials: Current research and future challenge
Chen, Z.-G., Han, G., Yang, L., Cheng, L., & Zou, J. (2012) · Progress in Natural Science: Materials International · doi:10.1016/j.pnsc.2012.11.011 · Cited by 825
Enhancement of the thermoelectric properties in nanoscale and nanostructured materials
Szczech, J. R., Higgins, J. M., & Jin, S. (2011) · J. Mater. Chem. · doi:10.1039/c0jm02755c · Cited by 405
Nanoengineering thermoelectrics for 21st century: Energy harvesting and other trends in the field
Martín-González, M., Caballero-Calero, O., & Díaz-Chao, P. (2013) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2013.03.008 · Cited by 291
Metadata
- Authors
- Mavrokefalos, A., Moore, A. L., Pettes, M. T., Shi, L., Wang, W., & Li, X.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 2009-05-15
- Volume
- 105
- Issue
- 10
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2065848281
- Cited by
- 159
- References
- 2
- FWCI
- 5.26
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.