The DOI matches its Crossref record; 16 of the 16 references it cites were found in a registry or an index.
Device modeling of perovskite solar cells based on structural similarity with thin film inorganic semiconductor solar cells
Abstract
Device modeling of CH3NH3PbI3−xCl3 perovskite-based solar cells was performed. The perovskite solar cells employ a similar structure with inorganic semiconductor solar cells, such as Cu(In,Ga)Se2, and the exciton in the perovskite is Wannier-type. We, therefore, applied one-dimensional device simulator widely used in the Cu(In,Ga)Se2 solar cells. A high open-circuit voltage of 1.0 V reported experimentally was successfully reproduced in the simulation, and also other solar cell parameters well consistent with real devices were obtained. In addition, the effect of carrier diffusion length of the absorber and interface defect densities at front and back sides and the optimum thickness of the absorber were analyzed. The results revealed that the diffusion length experimentally reported is long enough for high efficiency, and the defect density at the front interface is critical for high efficiency. Also, the optimum absorber thickness well consistent with the thickness range of real devices was derived.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Efficient Hybrid Solar Cells Based on Meso-Superstructured Organometal Halide Perovskites
Lee, M. M., Teuscher, J., Miyasaka, T., Murakami, T. N., & Snaith, H. J. (2012) · Science · doi:10.1126/science.1228604 · Cited by 10,687
Stranks, S. D., Eperon, G. E., Grancini, G., Menelaou, C., Alcocer, M. J. P., Leijtens, T., Herz, L. M., Petrozza, A., & Snaith, H. J. (2013) · Science · doi:10.1126/science.1243982 · Cited by 10,413
Sequential deposition as a route to high-performance perovskite-sensitized solar cells
Burschka, J., Pellet, N., Moon, S.-J., Humphry-Baker, R., Gao, P., Nazeeruddin, M. K., & Grätzel, M. (2013) · Nature · doi:10.1038/nature12340 · Cited by 9,547
Efficient planar heterojunction perovskite solar cells by vapour deposition
Liu, M., Johnston, M. B., & Snaith, H. J. (2013) · Nature · doi:10.1038/nature12509 · Cited by 7,976
Long-Range Balanced Electron- and Hole-Transport Lengths in Organic-Inorganic CH 3 NH 3 PbI 3
Xing, G., Mathews, N., Sun, S., Lim, S. S., Lam, Y. M., Grätzel, M., Mhaisalkar, S., & Sum, T. C. (2013) · Science · doi:10.1126/science.1243167 · Cited by 6,909
Noh, J. H., Im, S. H., Heo, J. H., Mandal, T. N., & Seok, S. I. (2013) · Nano Letters · doi:10.1021/nl400349b · Cited by 4,829
Modelling polycrystalline semiconductor solar cells
Burgelman, M., Nollet, P., & Degrave, S. (2000) · Thin Solid Films · doi:10.1016/s0040-6090(99)00825-1 · Cited by 3,172
Liu, D., & Kelly, T. L. (2014) · Nature Photonics · doi:10.1038/nphoton.2013.342 · Cited by 2,663
19·9%‐efficient ZnO/CdS/CuInGaSe2 solar cell with 81·2% fill factor
Repins, I., Contreras, M. A., Egaas, B., DeHart, C., Scharf, J., Perkins, C. L., To, B., & Noufi, R. (2008) · Progress in Photovoltaics: Research and Applications · doi:10.1002/pip.822 · Cited by 2,022
Eperon, G. E., Burlakov, V. M., Docampo, P., Goriely, A., & Snaith, H. J. (2014) · Advanced Functional Materials · doi:10.1002/adfm.201302090 · Cited by 1,982
Cited by
Halide perovskite materials for solar cells: a theoretical review
Yin, W.-J., Yang, J.-H., Kang, J., Yan, Y., & Wei, S.-H. (2015) · Journal of Materials Chemistry A · doi:10.1039/c4ta05033a · Cited by 1,437
Theoretical analysis on effect of band offsets in perovskite solar cells
Minemoto, T., & Murata, M. (2015) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2014.10.036 · Cited by 694
Self-citationModeling Anomalous Hysteresis in Perovskite Solar Cells
van Reenen, S., Kemerink, M., & Snaith, H. J. (2015) · The Journal of Physical Chemistry Letters · doi:10.1021/acs.jpclett.5b01645 · Cited by 687
Synthetic Approaches for Halide Perovskite Thin Films
Dunlap-Shohl, W. A., Zhou, Y., Padture, N. P., & Mitzi, D. B. (2019) · Chemical Reviews · doi:10.1021/acs.chemrev.8b00318 · Cited by 631
Roy, P., Kumar Sinha, N., Tiwari, S., & Khare, A. (2020) · Solar Energy · doi:10.1016/j.solener.2020.01.080 · Cited by 541
Current status of electron transport layers in perovskite solar cells: materials and properties
Mahmood, K., Sarwar, S., & Mehran, M. T. (2017) · RSC Advances · doi:10.1039/c7ra00002b · Cited by 468
Can slow-moving ions explain hysteresis in the current–voltage curves of perovskite solar cells?
Richardson, G., O'Kane, S. E. J., Niemann, R. G., Peltola, T. A., Foster, J. M., Cameron, P. J., & Walker, A. B. (2016) · Energy & Environmental Science · doi:10.1039/c5ee02740c · Cited by 461
Device simulation of lead-free CH 3 NH 3 SnI 3 perovskite solar cells with high efficiency
Du, H.-J., Wang, W.-C., & Zhu, J.-Z. (2016) · Chinese Physics B · doi:10.1088/1674-1056/25/10/108802 · Cited by 371
Device simulation of highly efficient eco-friendly CH3NH3SnI3 perovskite solar cell
Patel, P. K. (2021) · Scientific Reports · doi:10.1038/s41598-021-82817-w · Cited by 333
Huang, L., Sun, X., Li, C., Xu, R., Xu, J., Du, Y., Wu, Y., Ni, J., Cai, H., Li, J., et al. (2016) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2016.08.025 · Cited by 267
Chowdhury, M. S., Shahahmadi, S. A., Chelvanathan, P., Tiong, S. K., Amin, N., Techato, K., Nuthammachot, N., Chowdhury, T., & Suklueng, M. (2020) · Results in Physics · doi:10.1016/j.rinp.2019.102839 · Cited by 266
Controllable design of solid-state perovskite solar cells by SCAPS device simulation
Tan, K., Lin, P., Wang, G., Liu, Y., Xu, Z., & Lin, Y. (2016) · Solid-State Electronics · doi:10.1016/j.sse.2016.09.012 · Cited by 265
Tavakoli, M. M., Gu, L., Gao, Y., Reckmeier, C., He, J., Rogach, A. L., Yao, Y., & Fan, Z. (2015) · Scientific Reports · doi:10.1038/srep14083 · Cited by 259
Metadata
- Authors
- Minemoto, T., & Murata, M.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 2014-08-04
- Volume
- 116
- Issue
- 5
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2078550565
- Cited by
- 346
- References
- 16
- FWCI
- 10.97
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.