CoChat

Bias sputtered NbN and superconducting nanowire devices

Open access

The DOI matches its Crossref record; 38 of the 38 references it cites were found in a registry or an index.

Abstract

Superconducting nanowire single photon detectors (SNSPDs) promise to combine near-unity quantum efficiency with >100 megacounts per second rates, picosecond timing jitter, and sensitivity ranging from x-ray to mid-infrared wavelengths. However, this promise is not yet fulfilled, as superior performance in all metrics is yet to be combined into one device. The highest single-pixel detection efficiency and the widest bias windows for saturated quantum efficiency have been achieved in SNSPDs based on amorphous materials, while the lowest timing jitter and highest counting rates were demonstrated in devices made from polycrystalline materials. Broadly speaking, the amorphous superconductors that have been used to make SNSPDs have higher resistivities and lower critical temperature (Tc) values than typical polycrystalline materials. Here, we demonstrate a method of preparing niobium nitride (NbN) that has lower-than-typical superconducting transition temperature and higher-than-typical resistivity. As we will show, NbN deposited onto unheated SiO2 has a low Tc and high resistivity but is too rough for fabricating unconstricted nanowires, and Tc is too low to yield SNSPDs that can operate well at liquid helium temperatures. By adding a 50 W RF bias to the substrate holder during sputtering, the Tc of the unheated NbN films was increased by up to 73%, and the roughness was substantially reduced. After optimizing the deposition for nitrogen flow rates, we obtained 5 nm thick NbN films with a Tc of 7.8 K and a resistivity of 253 μΩ cm. We used this bias sputtered room temperature NbN to fabricate SNSPDs. Measurements were performed at 2.5 K using 1550 nm light. Photon count rates appeared to saturate at bias currents approaching the critical current, indicating that the device's quantum efficiency was approaching unity. We measured a single-ended timing jitter of 38 ps. The optical coupling to these devices was not optimized; however, integration with front-side optical structures to improve absorption should be straightforward. This material preparation was further used to fabricate nanocryotrons and a large-area imager device, reported elsewhere. The simplicity of the preparation and promising device performance should enable future high-performance devices.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1063/1.4990066

Cites

38 of 38 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 64

Metadata

Authors
Dane, A. E., McCaughan, A. N., Zhu, D., Zhao, Q., Kim, C.-S., Calandri, N., Agarwal, A., Bellei, F., & Berggren, K. K.
Affiliations
  • Massachusetts Institute of Technology (US)
  • National Institute of Standards and Technology (US)
  • Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology 1 , 77 Massachusetts Avenue, Cambridge, Massachusetts 02139,
Venue
Applied Physics Letters
Published
2017-09-18
Volume
111
Issue
12
ISSN
  • 0003-6951 (ISSN-L)
  • 1077-3118
OpenAlex
W2754181820
Cited by
64
References
37
Citations by year
2026: 1 · 2025: 9 · 2024: 4 · 2023: 5 · 2022: 7 · 2021: 14 · 2020: 7 · 2019: 13 · 2018: 3 · 2017: 1
FWCI
3.59
Type
journal article
Language
en
Open access
Locations
  • Applied Physics Letters (publishedVersion)
  • DSpace@MIT (Massachusetts Institute of Technology) (submittedVersion, cc-by-nc)
Funders
  • National Science Foundation (DMR-1419807)
  • National Aeronautics and Space Administration (NNX14AL48H)
  • Intelligence Advanced Research Projects Activity (W911NF-14-C0089)
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Superconducting and THz Device Technology
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Superconducting Materials and Applications
  • Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Quantum Information and Cryptography
Keywords
superconducting nanowire single-photon detectors, niobium nitride, superconducting transition temperature, film resistivity, film roughness, quantum efficiency, timing jitter, photon counting rate, 1550 nm detection

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.