The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Intrinsic stress in sputter-deposited thin films
Abstract
A review of the sputtered film stress literature shows that the intrinsic stress can be tensile or compressive depending on the energetics of the deposition process. Modeling studies of film growth and extensive experimental evidence show a direct link between the energetics of the deposition process and film microstructure, which in turn determines the nature and magnitude of the stress. The fundamental quantities are the particle flux and energy striking the condensing film, which are a function of many process parameters such as pressure (discharge voltage), target/sputtering gas mass ratio, cathode shape, bias voltage, and substrate orientation. Tensile stress is generally observed in zone 1-type, porous films and is explained in terms of the grain boundary relaxation model, whereas compressive stress, observed in zone T-type, dense films, is interpreted in terms of the atomic peening mechanism. Modeling of the atomic peening mechanism and experimental data indicate that the normalized momentum may be the appropriate stress scaling factor in the compressive stress regime. An idealized stress momentum curve is constructed depicting the three characteristic stress regions. The rapid tensile-to-compressive stress transition often observed in sputtered films may be associated with a threshold phenomenon, occurring at approximately the atomic displacement energy. Furthermore, data indicate that the inverse relationship between intrinsic stress and deposition temperature is a general phenomenon, independent of the nature of the stress, material, or method of deposition.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Theory of Sputtering. I. Sputtering Yield of Amorphous and Polycrystalline Targets
Sigmund, P. (1969) · Physical Review · doi:10.1103/physrev.184.383 · Cited by 3,589
Mechanical properties of thin films
Nix, W. D. (1989) · Metallurgical Transactions A · doi:10.1007/bf02666659 · Cited by 2,546
Thornton, J. A. (1974) · Journal of Vacuum Science and Technology · doi:10.1116/1.1312732 · Cited by 2,421
Thornton, J. A. (1977) · Annual Review of Materials Science · doi:10.1146/annurev.ms.07.080177.001323 · Cited by 2,188
Chopra, K. L., & Klerer, J. (1970) · Journal of The Electrochemical Society · doi:10.1149/1.2407581 · Cited by 2,048
The Displacement of Atoms in Solids by Radiation
Kinchin, G. H., & Pease, R. S. (1955) · Reports on Progress in Physics · doi:10.1088/0034-4885/18/1/301 · Cited by 1,697
The microstructure of sputter‐deposited coatings
Thornton, J. A. (1986) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.573628 · Cited by 1,336
Stress-related effects in thin films
Thornton, J. A., & Hoffman, D. W. (1989) · Thin Solid Films · doi:10.1016/0040-6090(89)90030-8 · Cited by 1,172
Revised structure zone model for thin film physical structure
Messier, R., Giri, A. P., & Roy, R. A. (1984) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.572604 · Cited by 968
Calculations of nuclear stopping, ranges, and straggling in the low-energy region
Wilson, W. D., Haggmark, L. G., & Biersack, J. P. (1977) · Physical Review B · doi:10.1103/physrevb.15.2458 · Cited by 816
Cited by
High power pulsed magnetron sputtering: A review on scientific and engineering state of the art
Sarakinos, K., Alami, J., & Konstantinidis, S. (2010) · Surface and Coatings Technology · doi:10.1016/j.surfcoat.2009.11.013 · Cited by 1,075
Tetrahedral bonding in amorphous carbon
McKenzie, D. R. (1996) · Reports on Progress in Physics · doi:10.1088/0034-4885/59/12/002 · Cited by 400
An introduction to thin film processing using high-power impulse magnetron sputtering
Lundin, D., & Sarakinos, K. (2012) · Journal of Materials Research · doi:10.1557/jmr.2012.8 · Cited by 306
Stress and strain in polycrystalline thin films
Janssen, G. C. A. M. (2007) · Thin Solid Films · doi:10.1016/j.tsf.2007.03.007 · Cited by 253
A Kinetic Model for Stress Generation in Thin Films Grown from Energetic Vapor Fluxes
Chason, E., Karlson, M., Colin, J. J., Magnfält, D., Sarakinos, K., & Abadias, G. (2016) · Journal of Applied Physics · doi:10.1063/1.4946039 · Cited by 90
Metadata
- Authors
- Windischmann, H.
- Venue
- Critical Reviews in Solid State and Materials Sciences
- Publisher
- Informa UK Limited
- Published
- 1992-01
- Volume
- 17
- Issue
- 6
- Pages
- 547-596
- ISSN
- 0161-1593 (ISSN-L)
- 1040-8436
- 1547-6561
- OpenAlex
- W1964753392
- Cited by
- 662
- References
- 29
- FWCI
- 26.31
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Intrinsic stress in sputter-deposited thin films. https://app.cochat.ai/papers/10.1080/10408439208244586
- The paper
- Windischmann, H. (1992). Intrinsic stress in sputter-deposited thin films. Critical Reviews in Solid State and Materials Sciences. https://doi.org/10.1080/10408439208244586
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.