Room temperature deposition of sputtered TiN films for superconducting coplanar waveguide resonators
The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Abstract
We present a systematic study of the properties of room temperature deposited TiN films by varying the deposition conditions in an ultra-high-vacuum reactive magnetron sputtering chamber. By increasing the deposition pressure from 2 to 9 mTorr while keeping a nearly stoichiometric composition of Ti1−xNx (x = 0.5) without substrate heating, the film resistivity increases, the dominant crystal orientation changes from (100) to (111), grain boundaries become clearer, and the strong compressive in-plane strain changes to weak tensile in-plane strain. The TiN films absorb a high concentration of contaminants including hydrogen, carbon, and oxygen when they are exposed to air after deposition. With the target–substrate distance set to 88 mm the contaminant levels increase from ∼0.1% to ∼10% as the pressure is increased from 2 to 9 mTorr. The contaminant concentrations also correlate with in-plane distance from the center of the substrate and increase by roughly two orders of magnitude as the target–substrate distance is increased from 88 to 266 mm. These contaminants are found to strongly influence the properties of TiN thin films. For instance, the resistivity of stoichiometric films increases by around a factor of 5 as the oxygen content increases from 0.1% to 11%. These results strongly suggest that the energy of the sputtered TiN particles plays a crucial role in determining the TiN film properties, and that it is important to precisely control the energy of these particles to obtain high-quality TiN films. Superconducting coplanar waveguide resonators made from a series of nearly stoichiometric films grown at pressures from 2 to 7 mTorr show a substantial increase in intrinsic quality factor from ∼104 to ∼106 as the magnitude of the compressive strain decreases from nearly 3800 MPa to approximately 150 MPa and the oxygen content increases from 0.1% to 8%. Surprisingly, the films with a higher oxygen content exhibit lower loss, but care must be taken when depositing at room temperature to avoid nonuniform oxygen incorporation, which presents as a radially dependent resistivity and becomes a radially dependent surface inductance in the superconductor.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Decoherence in Josephson Qubits from Dielectric Loss
Martinis, J. M., Cooper, K. B., McDermott, R., Steffen, M., Ansmann, M., Osborn, K. D., Cicak, K., Oh, S., Pappas, D. P., Simmonds, R. W., et al. (2005) · Physical Review Letters · doi:10.1103/physrevlett.95.210503 · Cited by 838
Self-citation
Cited by
Towards understanding two-level-systems in amorphous solids: insights from quantum circuits
Müller, C., Cole, J. H., & Lisenfeld, J. (2019) · Reports on Progress in Physics · doi:10.1088/1361-6633/ab3a7e · Cited by 508
Qubit compatible superconducting interconnects
Foxen, B., Mutus, J. Y., Lucero, E., Graff, R., Megrant, A., Chen, Y., Quintana, C., Burkett, B., Kelly, J., Jeffrey, E., et al. (2018) · Quantum Science and Technology · doi:10.1088/2058-9565/aa94fc · Cited by 143
Self-citationComparison of dielectric loss in titanium nitride and aluminum superconducting resonators
Melville, A., Calusine, G., Woods, W., Serniak, K., Golden, E., Niedzielski, B. M., Kim, D. K., Sevi, A., Yoder, J. L., Dauler, E. A., et al. (2020) · Applied Physics Letters · doi:10.1063/5.0021950 · Cited by 69
Proposal for Microwave Boson Sampling
Peropadre, B., Guerreschi, G. G., Huh, J., & Aspuru-Guzik, A. (2016) · Physical Review Letters · doi:10.1103/physrevlett.117.140505 · Cited by 44
Metadata
- Authors
- Ohya, S., Chiaro, B., Megrant, A., Neill, C., Barends, R., Chen, Y., Kelly, J., Low, D., Mutus, J., O’Malley, P. J. J., Roushan, P., Sank, D., Vainsencher, A., Wenner, J., White, T. C., Yin, Y., Schultz, B. D., Palmstrøm, C. J., Mazin, B. A., Cleland, A. N., & Martinis, J. M.
- Venue
- Superconductor Science and Technology
- Publisher
- IOP Publishing
- Published
- 2013-12-05
- Volume
- 27
- Issue
- 1
- Pages
- 015009
- ISSN
- 0953-2048 (ISSN-L)
- 1361-6668
- OpenAlex
- W2129310136
- Cited by
- 94
- References
- 1
- FWCI
- 2.55
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Room temperature deposition of sputtered TiN films for superconducting coplanar waveguide resonators. https://app.cochat.ai/papers/10.1088/0953-2048/27/1/015009
- The paper
- Ohya, S., Chiaro, B., Megrant, A., Neill, C., Barends, R., Chen, Y., Kelly, J., Low, D., Mutus, J., O’Malley, P. J. J., Roushan, P., Sank, D., Vainsencher, A., Wenner, J., White, T. C., Yin, Y., Schultz, B. D., Palmstrøm, C. J., Mazin, B. A., . . . Martinis, J. M. (2014). Room temperature deposition of sputtered TiN films for superconducting coplanar waveguide resonators. Superconductor Science and Technology. https://doi.org/10.1088/0953-2048/27/1/015009
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.