Hollow cathode modeling: I. A coupled plasma thermal two-dimensional model
Open accessThe DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
Abstract
A two-dimensional axisymmetric quasi-neutral fluid model of an emissive hollow cathode that includes neutral xenon, single charge ions and electrons has been developed. The gas discharge is coupled with a thermal model of the cathode into a self-consistent generic model applicable to any hollow cathode design. An exhaustive description of the model assumptions and governing equations is given. Boundary conditions for both the gas discharge and thermal model are clearly specified as well. A new emissive sheath model that is valid for any emissive material and in both space charge and thermionic emission limited regimes is introduced. Then, setting the emitter temperature to an experimentally measured profile, we compare simulation results of the plasma model to measurements available in the literature for NASA NSTAR barium oxide cathode. Qualitative discrepancies between simulation results and measurements are noted in the cathode plume regarding the simulated plasma potential. Motivated by experimental evidence supporting the occurrence of ion acoustic instabilities in the cathode plume, an enhanced model of electron transport in the plume is presented and its consequences analyzed. Using the obtained plasma model, simulated quantities in the plume are qualitatively comparable with measurements. Inside the cathode, the simulated plasma density agrees well with measurements and is within the ± 50 % experimental uncertainty associated with these measurements. A comparison of simulation results of the full coupled cathode model for the NASA NSTAR cathode with experimental measurements is presented in a companion paper, as well as a physical analysis of the cathode behavior and a parametric study of the influence of the operating point and key design choices.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Principles of Plasma Discharges and Materials Processing
Lieberman, M. A., & Lichtenberg, A. J. (2005) · doi:10.1002/0471724254 · Cited by 4,748
Goebel, D. M., Jameson, K. K., Watkins, R. M., Katz, I., & Mikellides, I. G. (2005) · Journal of Applied Physics · doi:10.1063/1.2135417 · Cited by 129
Hollow cathode modeling: II. Physical analysis and parametric study
Sary, G., Garrigues, L., & Boeuf, J.-P. (2017) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/aa6210 · Cited by 57
Self-citationNumerical Simulations of the Partially Ionized Gas in a 100-A LaB6 Hollow Cathode
Mikellides, I. G., Goebel, D. M., Jorns, B. A., Polk, J. E., & Guerrero, P. (2015) · IEEE Transactions on Plasma Science · doi:10.1109/tps.2014.2320876 · Cited by 48
Plasma processes inside dispenser hollow cathodes
Mikellides, I. G., Katz, I., Goebel, D. M., Polk, J. E., & Jameson, K. K. (2006) · Physics of Plasmas · doi:10.1063/1.2208292 · Cited by 46
Thermal Model of the Hollow Cathode Using Numerically Simulated Plasma Fluxes
Katz, I., Mikellides, I. G., Polk, J. E., Goebel, D. M., & Hornbeck, S. E. (2007) · Journal of Propulsion and Power · doi:10.2514/1.21103 · Cited by 27 · cited 10×
“Unlike most of earlier models published in the literature (with one noteworthy exception in [2]), we couple here the plasma model to a thermal model which allows us to compute self-consistently the emitter temperature.”
BackgroundMethodInfluential
Cited by
Physics of E × B discharges relevant to plasma propulsion and similar technologies
Kaganovich, I. D., Smolyakov, A., Raitses, Y., Ahedo, E., Mikellides, I. G., Jorns, B., Taccogna, F., Gueroult, R., Tsikata, S., Bourdon, A., et al. (2020) · Physics of Plasmas · doi:10.1063/5.0010135 · Cited by 202
An overview of discharge plasma modeling for Hall effect thrusters
Hara, K. (2019) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/ab0f70 · Cited by 120
Goebel, D. M., Becatti, G., Mikellides, I. G., & Lopez Ortega, A. (2021) · Journal of Applied Physics · doi:10.1063/5.0051228 · Cited by 95
Hollow cathode modeling: II. Physical analysis and parametric study
Sary, G., Garrigues, L., & Boeuf, J.-P. (2017) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/aa6210 · Cited by 57
“The plasma density profile simulated in our companion paper [1] for a set emitter”
BackgroundMethodInfluentialSelf-citationHara, K., & Treece, C. (2019) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/ab18e4 · Cited by 36
Metadata
- Authors
- Sary, G., Garrigues, L., & Boeuf, J.-P.
- Venue
- Plasma Sources Science and Technology
- Publisher
- IOP Publishing
- Published
- 2017-03-31
- Volume
- 26
- Issue
- 5
- Pages
- 055007
- ISSN
- 0963-0252 (ISSN-L)
- 1361-6595
- OpenAlex
- W2591469608
- Cited by
- 71
- References
- 6
- FWCI
- 3.69
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Hollow cathode modeling: I. A coupled plasma thermal two-dimensional model. https://app.cochat.ai/papers/10.1088/1361-6595/aa6217
- The paper
- Sary, G., Garrigues, L., & Boeuf, J.-P. (2017). Hollow cathode modeling: I. A coupled plasma thermal two-dimensional model. Plasma Sources Science and Technology. https://doi.org/10.1088/1361-6595/aa6217
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.