CoChat

Very high energy calibration of silicon Timepix detectors

Open access

The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.

Abstract

We investigate energy measurements in Timepix hybrid detectors in hole collection mode above pixel input energy depositions of about 2.2 MeV or 600,000 electron/hole pairs in Silicon. Measurement of the detector response well above this regime is important for our application measuring the heavy ion exposure of NASA astronauts. We find that high input charges produce a double pulse structure in the Timepix front end which creates a taxonomy of different clusters which are observed at accelerators, but not in typical operation on orbit. We investigate the LET response of the Timepix to different heavy ion species and find that for a given polar angle the so called 'volcano effect' can be compensated with a simple power law model. We also characterize the pixel response of the Timepix using mono-energetic stopping protons and derive a per pixel calibration method for correction of the pixel response up to about 8 MeV. We conclude that with an appropriate calibration procedure the Timepix can correctly measure the LET values in excess of 500 keV μm -1 in Silicon for tracks with a polar angle exceeding 60 o , corresponding to the entirety of the cosmic ray spectrum up to Nickel.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1088/1748-0221/13/11/p11014

Cites

21 of 21 references verified0 citation errors · 0 not checkable

Statistics

Figures

Image 1
From the PDF
Image 2
From the PDF
Figure 2 180 MeV A 56 Fe ion at 75°, single track (top) and averaged track over 10000 tracks (bottom). The volcano effect shows as a clear depression in the cluster core (approximate measured energy = 1600 keV per pixel) surrounded by a rim with a higher energy deposit. Each pixel has a pitch of 55 µm.
Figure 2 180 MeV A 56 Fe ion at 75°, single track (top) and averaged track over 10000 tracks (bottom). The volcano effect shows as a clear depression in the cluster core (approximate measured energy = 1600 keV per pixel) surrounded by a rim with a higher energy deposit. Each pixel has a pitch of 55 µm.From the PDF
Figure 3 Oscillatory (top) and double (bottom) pulse structures observed from high input charges measured in a Timepix detector with 500 µm thick silicon sensor. The top figure shows the typical response of the Timepix preamplifier to energies from approximately 800 keV to approximately 2 MeV. (Reproduced from [17]. © 2014 IOP Publishing Ltd and Sissa Medialab srl.) The bottom figure shows the response to charges much higher than these vales. The principal differences between these figures are the shortening of the first pulse and the lengthening of the gap between the first and second pulses.
Figure 3 Oscillatory (top) and double (bottom) pulse structures observed from high input charges measured in a Timepix detector with 500 µm thick silicon sensor. The top figure shows the typical response of the Timepix preamplifier to energies from approximately 800 keV to approximately 2 MeV. (Reproduced from [17]. © 2014 IOP Publishing Ltd and Sissa Medialab srl.) The bottom figure shows the response to charges much higher than these vales. The principal differences between these figures are the shortening of the first pulse and the lengthening of the gap between the first and second pulses.From the PDF
Image 5
From the PDF
Image 6
From the PDF
Figure 6 Measured vs calculated LET for tracks at 0° (left) and 75° (right) polar angle. In both cases the data calculated LET agrees with the measured LET up to a threshold value, when the data starts to follow a power law relationship.
Figure 6 Measured vs calculated LET for tracks at 0° (left) and 75° (right) polar angle. In both cases the data calculated LET agrees with the measured LET up to a threshold value, when the data starts to follow a power law relationship.From the PDF
Figure 7 Constant and exponent of power law fits y = ax b of the measured vs theoretical LET dataset (left). Calculated volcano effect cutoff for tested assembly as a function of polar angle (right).
Figure 7 Constant and exponent of power law fits y = ax b of the measured vs theoretical LET dataset (left). Calculated volcano effect cutoff for tested assembly as a function of polar angle (right).From the PDF
Figure 8 Cluster volume for 8 MeV protons at 0° degree polar angle as a function of the number of pixels > 1600 keV. All of these protons should stop in the sensor depositing the full 8 MeV of energy. The interpretation of this figure is that in the case of a single hot pixel the proton has stopped in the middle of a pixel depositing a large amount of energy which saturates the pixel. In the case of the 4 hot pixel cluster the proton has hit in the corner of all 4 pixels, sharing its energy between all them explaining the correct measurement of the full energy.
Figure 8 Cluster volume for 8 MeV protons at 0° degree polar angle as a function of the number of pixels > 1600 keV. All of these protons should stop in the sensor depositing the full 8 MeV of energy. The interpretation of this figure is that in the case of a single hot pixel the proton has stopped in the middle of a pixel depositing a large amount of energy which saturates the pixel. In the case of the 4 hot pixel cluster the proton has hit in the corner of all 4 pixels, sharing its energy between all them explaining the correct measurement of the full energy.From the PDF
Figure 9 High energy calibration of the Timepix pixel. The curve from 2-5 MeV is derived by comparing the expected and measured values for 8 MeV protons with a single saturating pixel. The high energy extension is achieved using a similar method with 650 MeV 40 Ar ions at high polar angle. Here the full cluster energy is substituted for the expected energy deposit in some segment of the track. The expected (measured = real) response line is also shown (dashed, dark blue). Characterizing the Pixel response to very high energies
Figure 9 High energy calibration of the Timepix pixel. The curve from 2-5 MeV is derived by comparing the expected and measured values for 8 MeV protons with a single saturating pixel. The high energy extension is achieved using a similar method with 650 MeV 40 Ar ions at high polar angle. Here the full cluster energy is substituted for the expected energy deposit in some segment of the track. The expected (measured = real) response line is also shown (dashed, dark blue). Characterizing the Pixel response to very high energiesFrom the PDF
The technique used to probe these regions uses stopping (5-8 MeV) protons which inject a lot of charge into a single pixel. Figure 10 . Schematic of the complete response of the Timepix front end to positive input charges. For a 500 µm thick silicon sensor the normal region can be calibrated with photons, the advanced region with 5 MeV protons and the volcano region with 8 MeV protons.
The technique used to probe these regions uses stopping (5-8 MeV) protons which inject a lot of charge into a single pixel. Figure 10 . Schematic of the complete response of the Timepix front end to positive input charges. For a 500 µm thick silicon sensor the normal region can be calibrated with photons, the advanced region with 5 MeV protons and the volcano region with 8 MeV protons.From the PDF
Figure 11 Cluster correction procedure for per pixel data on 250 MeV A on 56 Fe ion, volcano response curve is applied to the raw cluster (top left) yielding a cluster with some miscorrected pixels (top right). The cluster is then searched for pixels with substantially higher corrected energy deposition than their neighbors (bottom left) which are corrected back to the raw value. This yields the final corrected cluster (bottom right).
Figure 11 Cluster correction procedure for per pixel data on 250 MeV A on 56 Fe ion, volcano response curve is applied to the raw cluster (top left) yielding a cluster with some miscorrected pixels (top right). The cluster is then searched for pixels with substantially higher corrected energy deposition than their neighbors (bottom left) which are corrected back to the raw value. This yields the final corrected cluster (bottom right).From the PDF
Figure 12 Raw and corrected LET spectra of 250 MeV A 56 Fe at 75° polar angle. Corrections using the power law method (green) and per pixel method (red) are shown. The true LET is marked by the dotted line.
Figure 12 Raw and corrected LET spectra of 250 MeV A 56 Fe at 75° polar angle. Corrections using the power law method (green) and per pixel method (red) are shown. The true LET is marked by the dotted line.From the PDF
Figure 13 Result of per pixel LET correction for 5 different species as a function of track polar angle. The hatched bands show a region within 10% of the true LET value. Colored bands show the standard deviation of the corrected LET distribution. Lines are to guide the eye. In general the correction works best for higher polar angle tracks, with both narrower distributions and more accurate LET values.
Figure 13 Result of per pixel LET correction for 5 different species as a function of track polar angle. The hatched bands show a region within 10% of the true LET value. Colored bands show the standard deviation of the corrected LET distribution. Lines are to guide the eye. In general the correction works best for higher polar angle tracks, with both narrower distributions and more accurate LET values.From the PDF
Figure 14 LET Measurement accuracy (%) as a function of true particle LET and polar angle with no (left) and per-pixel correction of the volcano effect (right). Color bands show in 10% increments from 100%, so the darkest blue color band covers all LET values within 10% of the true value. Figure achieved by interpolating between experimental datapoints for 1 H 100 MeV A, 4 He 100 MeV A, 12 C 430 MeV A, 20 Ne 498 MeV A, 40 Ar 290 MeV A, 56 Fe 400 MeV A and 56 Fe 250 MeV A.
Figure 14 LET Measurement accuracy (%) as a function of true particle LET and polar angle with no (left) and per-pixel correction of the volcano effect (right). Color bands show in 10% increments from 100%, so the darkest blue color band covers all LET values within 10% of the true value. Figure achieved by interpolating between experimental datapoints for 1 H 100 MeV A, 4 He 100 MeV A, 12 C 430 MeV A, 20 Ne 498 MeV A, 40 Ar 290 MeV A, 56 Fe 400 MeV A and 56 Fe 250 MeV A.From the PDF

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 21 references

Cited by

See all 29

Metadata

Authors
George, S. P., Kroupa, M., Wheeler, S., Kodaira, S., Kitamura, H., Tlustos, L., Campbell-Ricketts, T., Stoffle, N. N., Semones, E., & Pinsky, L.
Affiliations
  • Johnson Space Center (US)
  • National Institute of Radiological Sciences (JP)
  • European Organization for Nuclear Research (CH)
  • University of Houston (US)
Venue
Journal of Instrumentation
Published
2018-11-19
Volume
13
Issue
11
Pages
P11014-P11014
ISSN
1748-0221 (ISSN-L)
OpenAlex
W2900636036
Cited by
29
References
21
Citations by year
2026: 1 · 2025: 3 · 2024: 9 · 2023: 6 · 2022: 3 · 2021: 1 · 2020: 2 · 2019: 4
FWCI
0.93
Type
journal article
Language
en
Open access
Licence
Locations
  • Journal of Instrumentation (publishedVersion, cc-by)
  • CERN Document Server (European Organization for Nuclear Research) (submittedVersion, cc-by)
  • Institutional Repositories DataBase (IRDB) (submittedVersion, cc-by-nc-nd)
Funders
Brookhaven National Laboratory
Topics
  • Physical Sciences › Physics and Astronomy › Nuclear and High Energy Physics › Particle Detector Development and Performance
  • Physical Sciences › Physics and Astronomy › Radiation › Radiation Detection and Scintillator Technologies
  • Physical Sciences › Physics and Astronomy › Radiation › Radiation Therapy and Dosimetry
Keywords
Timepix, silicon detectors, energy calibration, cosmic ray exposure, astronaut radiation protection, polar angle dependence, hybrid pixel detectors

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Very high energy calibration of silicon Timepix detectors. https://app.cochat.ai/papers/10.1088/1748-0221/13/11/p11014
The paper
George, S. P., Kroupa, M., Wheeler, S., Kodaira, S., Kitamura, H., Tlustos, L., Campbell-Ricketts, T., Stoffle, N. N., Semones, E., & Pinsky, L. (2018). Very high energy calibration of silicon Timepix detectors. Journal of Instrumentation. https://doi.org/10.1088/1748-0221/13/11/p11014

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.