The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Anisotropy of the Electronic Work Function of Metals
Abstract
Work function is experimentally known to be different for different faces of a crystal by amounts ranging from one-tenth to half a volt. For tungsten the faces can be arranged according to decreasing work function as follows: 110, 211, 100 and finally 111. The explanations so far suggested for the differences of the work function are discussed and shown to give either an incorrect sequence or a wrong order of magnitude of the observed differences. The author uses the picture of Wigner and Bardeen according to which the work function is a sum of a volume contribution and a contribution due to a double layer on the surface of the metal. The origin of the latter can be described in the following manner. With every atom one can associate a polyhedron ("$s$-polyhedron") with the atom at its center, such that it contains all points nearer to the atom under consideration than to any other atom. If the distribution of the electron density within these polyhedra of the surface atoms was the same as for the inside atoms then there would be no double layer on the surface. However, this is not the case since the total energy is lowered by a redistribution of the electron cloud on the surface. There are two effects: the first is a partial spread of the charge out of the $s$-polyhedra and the second is a tendency to smooth out the surface of the polyhedra. In consequence of the second effect the surfaces of equal charge density are more nearly plane than in the original picture. The two effects have opposite influences and since they are comparable in magnitude, it is not possible to predict the sign of the total double layer without numerical computations. Some general formulae for the double layers are derived and discussed more fully in the case of a simple cubic and a body-centered cubic lattice. The minimum problem of the surface energy is solved for four faces of a body-centered crystal and the results are applied to the case of tungsten. One obtains the differences between the work functions for different directions. The results agree satisfactorily with the experimental data: assuming a reasonable density of the free electrons, one obtains the correct sequence of faces and the correct differences of the work function. The surface energies are calculated an d found in agreement with the observed stability of certain crystal faces.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Weizs�cker, C. F. V. (1935) · Zeitschrift f�r Physik · doi:10.1007/bf01337700 · Cited by 2,241
Electronic Energy Bands in Metallic Tungsten
Manning, M. F., & Chodorow, M. I. (1939) · Physical Review · doi:10.1103/physrev.56.787 · Cited by 73
Cited by
The interaction of water with solid surfaces: fundamental aspects revisited
Henderson, M. (2002) · Surface Science Reports · doi:10.1016/s0167-5729(01)00020-6 · Cited by 2,299
Atomic View of Surface Self-Diffusion: Tungsten on Tungsten
Ehrlich, G., & Hudda, F. G. (1966) · The Journal of Chemical Physics · doi:10.1063/1.1726787 · Cited by 1,683
Theory of Metal Surfaces: Work Function
Lang, N. D., & Kohn, W. (1971) · Physical Review B · doi:10.1103/physrevb.3.1215 · Cited by 1,444
Surface-enhanced Raman scattering
Otto, A., Mrozek, I., Grabhorn, H., & Akemann, W. (1992) · Journal of Physics: Condensed Matter · doi:10.1088/0953-8984/4/5/001 · Cited by 1,428
Herring, C., & Nichols, M. H. (1949) · Reviews of Modern Physics · doi:10.1103/revmodphys.21.185 · Cited by 965
Transition Metal Oxide Work Functions: The Influence of Cation Oxidation State and Oxygen Vacancies
Greiner, M. T., Chai, L., Helander, M. G., Tang, W., & Lu, Z. (2012) · Advanced Functional Materials · doi:10.1002/adfm.201200615 · Cited by 924
Theory of Metal Surfaces: Induced Surface Charge and Image Potential
Lang, N. D., & Kohn, W. (1973) · Physical Review B · doi:10.1103/physrevb.7.3541 · Cited by 897
van der Waals forces in density functional theory: a review of the vdW-DF method
Berland, K., Cooper, V. R., Lee, K., Schröder, E., Thonhauser, T., Hyldgaard, P., & Lundqvist, B. I. (2015) · Reports on Progress in Physics · doi:10.1088/0034-4885/78/6/066501 · Cited by 847
Organic Electronic Devices and Their Functional Interfaces
Koch, N. (2007) · ChemPhysChem · doi:10.1002/cphc.200700177 · Cited by 801
Core-level binding-energy shifts at surfaces and in solids
Egelhoff, W. F. (1987) · Surface Science Reports · doi:10.1016/0167-5729(87)90007-0 · Cited by 768
Work function, electronegativity, and electrochemical behaviour of metals
Trasatti, S. (1971) · Journal of Electroanalytical Chemistry and Interfacial Electrochemistry · doi:10.1016/s0022-0728(71)80123-7 · Cited by 656
Molecular Structure of Water at Interfaces: Wetting at the Nanometer Scale
Verdaguer, A., Sacha, G. M., Bluhm, H., & Salmeron, M. (2006) · Chemical Reviews · doi:10.1021/cr040376l · Cited by 627
Orientation-dependent ionization energies and interface dipoles in ordered molecular assemblies
Duhm, S., Heimel, G., Salzmann, I., Glowatzki, H., Johnson, R. L., Vollmer, A., Rabe, J. P., & Koch, N. (2008) · Nature Materials · doi:10.1038/nmat2119 · Cited by 624
Trends of the surface relaxations, surface energies, and work functions of the 4 d transition metals
Methfessel, M., Hennig, D., & Scheffler, M. (1992) · Physical Review B · doi:10.1103/physrevb.46.4816 · Cited by 572
Visualizing vibrational normal modes of a single molecule with atomically confined light
Lee, J., Crampton, K. T., Tallarida, N., & Apkarian, V. A. (2019) · Nature · doi:10.1038/s41586-019-1059-9 · Cited by 567
Quantifying and understanding the triboelectric series of inorganic non-metallic materials
Zou, H., Guo, L., Xue, H., Zhang, Y., Shen, X., Liu, X., Wang, P., He, X., Dai, G., Jiang, P., et al. (2020) · Nature Communications · doi:10.1038/s41467-020-15926-1 · Cited by 545
Khazaei, M., Arai, M., Sasaki, T., Ranjbar, A., Liang, Y., & Yunoki, S. (2015) · Physical Review B · doi:10.1103/physrevb.92.075411 · Cited by 516
The optoelectronic role of chlorine in CH3NH3PbI3(Cl)-based perovskite solar cells
Chen, Q., Zhou, H., Fang, Y., Stieg, A. Z., Song, T.-B., Wang, H.-H., Xu, X., Liu, Y., Lu, S., You, J., et al. (2015) · Nature Communications · doi:10.1038/ncomms8269 · Cited by 485
Kellogg, G. L. (1994) · Surface Science Reports · doi:10.1016/0167-5729(94)90007-8 · Cited by 459
Smith, J. R. (1969) · Physical Review · doi:10.1103/physrev.181.522 · Cited by 455
Electron-stimulated desorption: Principles and applications
Ramsier, R. D., & Yates, J. T. (1991) · Surface Science Reports · doi:10.1016/0167-5729(91)90013-n · Cited by 450
Leung, T. C., Kao, C. L., Su, W. S., Feng, Y. J., & Chan, C. T. (2003) · Physical Review B · doi:10.1103/physrevb.68.195408 · Cited by 450
Greiner, M. T., & Lu, Z.-H. (2013) · NPG Asia Materials · doi:10.1038/am.2013.29 · Cited by 444
Theory of Work-Function Changes Induced by Alkali Adsorption
Lang, N. D. (1971) · Physical Review B · doi:10.1103/physrevb.4.4234 · Cited by 412
Lebedeva, N. P., Koper, M. T. M., Feliu, J. M., & van Santen, R. A. (2002) · The Journal of Physical Chemistry B · doi:10.1021/jp0204105 · Cited by 408
Oxygen reduction on stepped platinum surfaces in acidic media
Kuzume, A., Herrero, E., & Feliu, J. M. (2007) · Journal of Electroanalytical Chemistry · doi:10.1016/j.jelechem.2006.05.006 · Cited by 375
Coordination-dependent surface atomic contraction in nanocrystals revealed by coherent diffraction
Huang, W. J., Sun, R., Tao, J., Menard, L. D., Nuzzo, R. G., & Zuo, J. M. (2008) · Nature Materials · doi:10.1038/nmat2132 · Cited by 369
The Density-Functional Formalism and the Electronic Structure of Metal Surfaces
Lang, N. D. (1974) · Solid State Physics · doi:10.1016/s0081-1947(08)60204-0 · Cited by 358
Hölzl, J., & Schulte, F. K. (1979) · Springer Tracts in Modern Physics · doi:10.1007/bfb0048919 · Cited by 352
Binnig, G., & Rohrer, H. (2000) · IBM Journal of Research and Development · doi:10.1147/rd.441.0279 · Cited by 337
Nørskov, J. K., Holloway, S., & Lang, N. D. (1984) · Surface Science · doi:10.1016/0039-6028(84)90676-9 · Cited by 331
Theory of lattice contraction at aluminium surfaces
Finnis, M. W., & Heine, V (1974) · Journal of Physics F: Metal Physics · doi:10.1088/0305-4608/4/3/002 · Cited by 313
Work function measurements on (100) and (110) surfaces of silver
Dweydari, A. W., & Mee, C. H. B. (1975) · Physica Status Solidi (a) · doi:10.1002/pssa.2210270126 · Cited by 310
Concepts in Theoretical Heterogeneous Catalytic Reactivity
VAN SANTEN, R. A., & NEUROCK, M. (1995) · Catalysis Reviews · doi:10.1080/01614949508006451 · Cited by 289
Time-Dependent Single-Molecule Raman Scattering as a Probe of Surface Dynamics
Weiss, A., & Haran, G. (2001) · The Journal of Physical Chemistry B · doi:10.1021/jp0126863 · Cited by 282
Influence of the Electron Charge Distribution on Surface-Plasmon Dispersion
Bennett, A. J. (1970) · Physical Review B · doi:10.1103/physrevb.1.203 · Cited by 265
The importance of C7 sites and surface roughness in the ammonia synthesis reaction over iron
STRONGIN, D. (1987) · Journal of Catalysis · doi:10.1016/0021-9517(87)90109-6 · Cited by 256
Structural, electronic, and magnetic properties of bcc iron surfaces
Błoński, P., & Kiejna, A. (2007) · Surface Science · doi:10.1016/j.susc.2006.09.013 · Cited by 255
Simon, G. H., Kley, C. S., & Roldan Cuenya, B. (2021) · Angewandte Chemie International Edition · doi:10.1002/anie.202010449 · Cited by 255
Metadata
- Authors
- Smoluchowski, R.
- Venue
- Physical Review
- Publisher
- American Physical Society (APS)
- Published
- 1941-11-01
- Volume
- 60
- Issue
- 9
- Pages
- 661-674
- ISSN
- 0031-899X (ISSN-L)
- OpenAlex
- W2024499187
- Cited by
- 1,367
- References
- 2
- FWCI
- 0.00
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.