Compensation Topologies in IPT Systems: Standards, Requirements, Classification, Analysis, Comparison and Application
Open accessThe DOI matches its Crossref record; 85 of the 85 references it cites were found in a registry or an index.
Abstract
Wireless power transfer devices are becoming more relevant and widespread. Therefore, an article is devoted to a review, analysis and comparison of compensation topologies for an inductive power transfer. A new classification of topologies is developed. A lot of attention is paid to the problems of the physical fundamentals of compensation work, standards, safety, and five main topology requirements. It is determined, that topologies with the series primary compensating are the most effective in the IPT for charging devices among the four classical schemes. The series-parallel solution is recommended in case of the low output voltage, minimum size of a secondary side coil is achievable. The series-series solution does not depend on the magnetic coupling coefficient and the load on the resonance frequency. For the convenience of displaying and understanding the information, the comparison results are listed in the tables, graphs and dependencies. The main suitable topologies for a certain application are defined. The given conclusions provide a “one-stop” information source and a selection guide on the application of compensation topologies both in terms of devices and in terms of power level that is the main value of this paper. During literature analysis and recent trends in the market for wireless power transmission devices, the main possible further ways of developing topologies are underlined. First of all, it concerns increasing the frequency of resonance of compensation topologies, the use of multilevel / multi-pulse / multicoils structures, the study of existing high-frequency semiconductors and the development of the semiconductor and magnetic materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Greiner, W. (1998) · Theoretical Physics · doi:10.1007/978-1-4612-0587-6 · Cited by 6,657
Wireless Power Transfer via Strongly Coupled Magnetic Resonances
Kurs, A., Karalis, A., Moffatt, R., Joannopoulos, J. D., Fisher, P., & Soljačić, M. (2007) · Science · doi:10.1126/science.1143254 · Cited by 5,576 · cited 3×
“But a real impetus to the development of WPT with compensation was a well-known study in Massachusetts Institute Of Technology (MIT) in 2007 [37].”
BackgroundMethodGUIDELINES FOR LIMITING EXPOSURE TO TIME-VARYING ELECTRIC AND MAGNETIC FIELDS (1 Hz TO 100 kHz)
(2010) · Health Physics · doi:10.1097/hp.0b013e3181f06c86 · Cited by 2,164
Design Considerations for a Contactless Electric Vehicle Battery Charger
Wang, C.-S., Stielau, O. H., & Covic, G. A. (2005) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2005.855672 · Cited by 1,487 · cited 5×
“A smaller primary capacitance is always required for PS topology and the change becomes larger with better coupling or higher secondary quality factor [50].”
BackgroundInfluentialA Critical Review of Recent Progress in Mid-Range Wireless Power Transfer
Hui, S. Y. R., Zhong, W., & Lee, C. K. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2249670 · Cited by 1,465 · cited 1×
“It is logical to assume that the more coils will be, the more complex the system will be, because the number of mutual inductances and the influence will be proportional to each [123].”
BackgroundWang, C.-S., Covic, G. A., & Stielau, O. H. (2004) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2003.822038 · Cited by 1,213 · cited 9×
“This phenomenon is caused by the input impedance (Zi) that may vary roughly from capacitive to inductive depending on secondary quality factor (Qs) and this may cause unstable operating modes [28] (Fig.”
BackgroundInfluentialA Double-Sided LCC Compensation Network and Its Tuning Method for Wireless Power Transfer
Li, S., Li, W., Deng, J., Nguyen, T. D., & Mi, C. C. (2015) · IEEE Transactions on Vehicular Technology · doi:10.1109/tvt.2014.2347006 · Cited by 1,091 · cited 4×
“The high-order compensation topologies such as the LCC and LCL have become more and more popular due to the better comprehensive performance [100], [102], [108]–[110].”
BackgroundInfluentialCompensation Topologies of High-Power Wireless Power Transfer Systems
Zhang, W., & Mi, C. C. (2016) · IEEE Transactions on Vehicular Technology · doi:10.1109/tvt.2015.2454292 · Cited by 992 · cited 10×
“High efficiency can be achieved by soft switching of semiconductors [10].”
BackgroundInfluentialWireless Power Transfer for Vehicular Applications: Overview and Challenges
Patil, D., McDonough, M. K., Miller, J. M., Fahimi, B., & Balsara, P. T. (2018) · IEEE Transactions on Transportation Electrification · doi:10.1109/tte.2017.2780627 · Cited by 991 · cited 10×
“In order to protect the driver and passengers in electric vehicles, metal protective screens can be installed [7], [21].”
BackgroundInfluentialWireless Charging Technologies: Fundamentals, Standards, and Network Applications
Lu, X., Wang, P., Niyato, D., Kim, D. I., & Han, Z. (2016) · IEEE Communications Surveys & Tutorials · doi:10.1109/comst.2015.2499783 · Cited by 968 · cited 7×
“A very detailed study of this issue and the abovementioned applications has been conducted [4].”
BackgroundMethodInfluential
Cited by
Inductive Wireless Power Transfer Charging for Electric Vehicles—A Review
Mahesh, A., Chokkalingam, B., & Mihet-Popa, L. (2021) · IEEE Access · doi:10.1109/access.2021.3116678 · Cited by 513
“Comparison of modified compensation topologies [140].”
MethodInfluential
Metadata
- Authors
- Shevchenko, V., Husev, O., Strzelecki, R., Pakhaliuk, B., Poliakov, N., & Strzelecka, N.
- Venue
- IEEE Access
- Published
- 2019
- Volume
- 7
- Pages
- 120559-120580
- ISSN
- 2169-3536 (ISSN-L)
- OpenAlex
- W2970480986
- Cited by
- 242
- References
- 85
- FWCI
- 7.23
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.