Dynamic performances of GaN-HEMT on Si in cascode configuration
The DOI matches its Crossref record; 17 of the 17 references it cites were found in a registry or an index.
Abstract
This paper describes dynamic characteristics and power loss analysis of a high-voltage GaN-HEMT in cascode. The GaN-HEMT is "normally-on" and fabricated on 6-inch Si substrate using our Si mass-production line. A figure of merit (a product of RDSon (m Ω) and Qg (nC)) of the GaN-HEMT in cascode is as low as 1400. Simple switching characteristics with resistive load and power efficiency measurements with a power factor correction (PFC) circuit driven from 100 kHz to 1MHz were performed for the evaluation. The switching times (tr/tf) are about 4 times faster than those of conventional Si-MOSFET. An analytical method of power losses including temperature dependence of component parameters is also demonstrated. Analyzed results indicate a dominant factor of power losses at high frequency and high output power operation is turn-off switching loss, and the switching loss of our GaN-HEMT in cascode configuration is lower than that of Si-MOSFET.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“To achieve normally-OFF operation, two effective techniques are nowadays widely adopted: 1) the use of a p-GaN gatestack [8], as shown in Fig. 1(d) and 2) the use of a cascode configuration [9], depicted in Fig. 1(e).”
From Review and Outlook on GaN and SiC Power Devices: Industrial State-of-the-Art, Applications, and Perspectives (2024) · cites this paper as [9]
Citations
Cites
Fundamentals of Power Semiconductor Devices
Baliga, B. J. (2008) · Springer eBooks · doi:10.1007/978-0-387-47314-7 · Cited by 2,174 · cited 2×
“In general, the impedance matching for considerable frequency range without any power losses is necessary for unconditionally stable operation in RF literature[4].”
BackgroundAnalytical loss model of power MOSFET
Ren, Y., Xu, M., Zhou, J., & Lee, F. C. (2006) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2005.869743 · Cited by 535
Physical limitations on frequency and power parameters of transistors
Johnson, E. (2005) · IRE International Convention Record · doi:10.1109/irecon.1965.1147520 · Cited by 449 · cited 1×
“Especially, progress in improvement of device characteristics between on-resistance (RDSon) and breakdown voltage (BV) , so called “Johnson figure of merit (JFOM)” is not only improvement of electrical and thermal performances, but also expanding power application field [1].”
BackgroundA new generation of high voltage MOSFETs breaks the limit line of silicon
Deboy, G., Marz, N., Stengl, J.-P., Strack, H., Tihanyi, J., & Weber, H. (2002) · International Electron Devices Meeting 1998. Technical Digest (Cat. No.98CH36217) · doi:10.1109/iedm.1998.746448 · Cited by 405 · cited 1×
“Although, improvements and optimizations of device structure have been performed in order to extend limitation of Si material properties with applying such the super-junction structure so far, the electrical and thermal characteristics are closing in its limitation[2][3][4].”
BackgroundSiC power-switching devices-the second electronics revolution?
Cooper, J. A., & Agarwal, A. (2002) · Proceedings of the IEEE · doi:10.1109/jproc.2002.1021561 · Cited by 394
Analytical Loss Model of High Voltage GaN HEMT in Cascode Configuration
Huang, X., Li, Q., Liu, Z., & Lee, F. C. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2267804 · Cited by 292
SiC and GaN transistors - is there one winner for microwave power applications?
Trew, R. J. (2002) · Proceedings of the IEEE · doi:10.1109/jproc.2002.1021568 · Cited by 216 · cited 1×
“As seen in this figure, the limitation boundary of GaN is clearly higher performance than that of other materials [5][6].”
BackgroundNew Developments in Gallium Nitride and the Impact on Power Electronics
Khan, M. A., Simin, G., Pytel, S. G., Monti, A., Santi, E., & Hudgins, J. L. (2006) · IEEE 36th Conference on Power Electronics Specialists, 2005. · doi:10.1109/pesc.2005.1581596 · Cited by 118 · cited 1×
“As seen in this figure, the limitation boundary of GaN is clearly higher performance than that of other materials [5][6].”
BackgroundEvaluation and application of 600V GaN HEMT in cascode structure
Huang, X., Liu, Z., Li, Q., & Lee, F. C. (2013) · 2013 Twenty-Eighth Annual IEEE Applied Power Electronics Conference and Exposition (APEC) · doi:10.1109/apec.2013.6520464 · Cited by 99
An over 200-W output power GaN HEMT push-pull amplifier with high reliability
Kikkawa, T., Maniwa, T., Hayashi, H., Kanamura, M., Yokokawa, S., Nishi, M., Adachi, N., Yokoyama, M., Tateno, Y., & JOSHIN, K. (2004) · IEEE MTT-S International Microwave Symposium digest · doi:10.1109/mwsym.2004.1338818 · Cited by 84 · cited 1×
“Although, most of GaN-HEMT for high-frequency power applications uses Schottky gate[7][8][9][10][19], the gate voltage swing is restricted by forward on-voltage of the Schottky gate.”
BackgroundSelf-citation
Research works printed but not linked: 1
- hikida, 2009, GaN power devices, Panasonic Tech J, 55, 21
Cited by
Review of Commercial GaN Power Devices and GaN-Based Converter Design Challenges
Jones, E. A., Wang, F. F., & Costinett, D. (2016) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2016.2582685 · Cited by 1,259
Buffolo, M., Favero, D., Marcuzzi, A., De Santi, C., Meneghesso, G., Zanoni, E., & Meneghini, M. (2024) · IEEE Transactions on Electron Devices · doi:10.1109/ted.2023.3346369 · Cited by 476
“1(d) and 2) the use of a cascode configuration [9], depicted in Fig.”
MethodChoi, S., Haque, M. S., Tarek, M. T. B., Mulpuri, V., Duan, Y., Das, S., Garg, V., Ionel, D. M., Masrur, M. A., Mirafzal, B., et al. (2018) · IEEE Transactions on Transportation Electrification · doi:10.1109/tte.2018.2819627 · Cited by 192
“As these switches will be used for missioncritical application, their faults are tracked using fault precursors such as ON-state resistance, gate threshold voltage, and gate leakage current [142], [166]–[170].”
BackgroundHaziq, M., Falina, S., Manaf, A. A., Kawarada, H., & Syamsul, M. (2022) · Micromachines · doi:10.3390/mi13122133 · Cited by 179
“The drain terminal of a GaN HEMT is negatively biased when the Si MOSFET is switched off [61].”
BackgroundTechnology and Reliability of Normally-Off GaN HEMTs with p-Type Gate
Meneghini, M., Hilt, O., Wuerfl, J., & Meneghesso, G. (2017) · Energies · doi:10.3390/en10020153 · Cited by 172
“(iii) The integration, in a single package, of a cascoded pair constituted by a (normally-on) high voltage GaN-transistor and a low voltage silicon MOSFET [19].”
Background
Metadata
- Authors
- Hirose, T., Imai, M., Joshin, K., Watanabe, K., Ogino, T., Miyazaki, Y., Shono, K., Hosoda, T., & Asai, Y.
- Affiliations
- Fujitsu (Japan) (JP)
- Fujitsu Semiconductor (Japan) (JP)
- Venue
- 2014 IEEE Applied Power Electronics Conference and Exposition - APEC 2014
- Publisher
- IEEE
- Published
- 2014-03
- Pages
- 174-181
- ISSN
- 1048-2334 (ISSN-L)
- OpenAlex
- W2034002154
- Cited by
- 38
- References
- 17
- Citations by year
- 2025: 2 · 2024: 3 · 2023: 7 · 2022: 4 · 2021: 2 · 2019: 3 · 2018: 3 · 2017: 6 · 2016: 3 · 2015: 4 · 2014: 1
- FWCI
- 10.89
- Type
- conference paper
- Language
- en
- Open access
- closed
- Locations
- Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition (publishedVersion)
- Topics
- Physical Sciences › Physics and Astronomy › Condensed Matter Physics › GaN-based semiconductor devices and materials
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon Carbide Semiconductor Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced Power Amplifier Design
- Keywords
- GaN HEMT, cascode configuration, silicon substrate, high-voltage power devices, switching losses, power loss analysis, power factor correction, switching characteristics, on-resistance, gate charge, temperature dependence, power efficiency
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.