Review of solid state transformer in the distribution system: From components to field application
The DOI matches its Crossref record; 10 of the 10 references it cites were found in a registry or an index.
Abstract
The emergence of high power converters makes the modern power grid more active than it was before. One of the research directions in this area is the solid state transformer, which aims at replacing the traditional 50/60 Hz power transformer by means of high frequency isolated AC/AC solid state conversion techniques. This paper presents a systematical technology review essential for the development of solid state transformer in the distribution system, especially focusing on the following four areas: high voltage and high frequency power devices, high power and high frequency transformers, AC/AC converter topologies, and applications of solid state transformer in the distribution system. For each category, the state-of-art technologies are reviewed and possible research directions are presented. It is concluded that the solid state transformer is an emerging technology for the modernization of the future smart grid.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The Future Renewable Electric Energy Delivery and Management (FREEDM) System: The Energy Internet
Huang, A. Q., Crow, M. L., Heydt, G. T., Zheng, J. P., & Dale, S. J. (2011) · Proceedings of the IEEE · doi:10.1109/jproc.2010.2081330 · Cited by 1,463
Self-citationA New AC/AC Multilevel Converter Family
Glinka, M., & Marquardt, R. (2005) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2005.843973 · Cited by 772 · cited 1×
“DC (LVDC) following by a DC-AC conversion stage to provide the low voltage AC [46],[49], [53],[55],[56], [57] (the topology in [49] can be categorized in either type B or C due to two isolated transformer adopted).”
BackgroundTopology comparison for Solid State Transformer implementation
Falcones, S., Mao, X., & Ayyanar, R. (2010) · IEEE PES General Meeting · doi:10.1109/pes.2010.5590086 · Cited by 283
Wang, J., Huang, A., Sung, W., Liu, Y., & Baliga, B. (2009) · IEEE Industrial Electronics Magazine · doi:10.1109/mie.2009.932583 · Cited by 260 · cited 1×
“For high frequency applications such as for SST, N-channel SiC IGBT performs better due to its faster switching speed, a result of the low current gain of the PNP transistor [30]-[31].”
BackgroundSelf-citationMedium frequency topology in railway applications
Steiner, M., & Reinold, H. (2007) · 2007 European Conference on Power Electronics and Applications · doi:10.1109/epe.2007.4417570 · Cited by 249
10 kV/120 A SiC DMOSFET half H-bridge power modules for 1 MVA solid state power substation
Grider, D., Das, M., Agarwal, A., Palmour, J., Leslie, S., Ostop, J., Raju, R., Schutten, M., & Hefner, A. (2011) · 2011 IEEE Electric Ship Technologies Symposium · doi:10.1109/ests.2011.5770855 · Cited by 115
Multilevel Converter for Traction Applications: Small-Scale Prototype Tests Results
Carpita, M., Marchesoni, M., Pellerin, M., & Moser, D. (2008) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2008.918645 · Cited by 100 · cited 1×
“DC (LVDC) following by a DC-AC conversion stage to provide the low voltage AC [46],[49], [53],[55],[56], [57] (the topology in [49] can be categorized in either type B or C due to two isolated transformer adopted).”
BackgroundDesign and hardware implementation of Gen-1 silicon based solid state transformer
Wang, G., Baek, S., Elliott, J., Kadavelugu, A., Wang, F., She, X., Dutta, S., Liu, Y., Zhao, T., Yao, W., et al. (2011) · 2011 Twenty-Sixth Annual IEEE Applied Power Electronics Conference and Exposition (APEC) · doi:10.1109/apec.2011.5744766 · Cited by 99
Self-citationPower Electronic Transformer application to grid connected photovoltaic systems
Brando, G., Dannier, A., & Rizzo, R. (2009) · 2009 International Conference on Clean Electrical Power · doi:10.1109/iccep.2009.5211954 · Cited by 31
A new matrix type three-phase four-wire power electronic transformer
Ai-juan, J., Hang-tian, L., & Shao-long, L. (2006) · 2006 37th IEEE Power Electronics Specialists Conference · doi:10.1109/pesc.2006.1711919 · Cited by 16
Cited by
Zhao, B., Song, Q., Liu, W., & Sun, Y. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2289913 · Cited by 1,886
Partial discharge behavior and ground insulation life expectancy under different voltage frequencies
Liu, T., Li, Q., Huang, X., Lu, Y., Asif, M., & Wang, Z. (2018) · IEEE Transactions on Dielectrics and Electrical Insulation · doi:10.1109/tdei.2018.006810 · Cited by 83
Power Electronics for Grid-Scale Energy Storage
Grainger, B. M., Reed, G. F., Sparacino, A. R., & Lewis, P. T. (2014) · Proceedings of the IEEE · doi:10.1109/jproc.2014.2319819 · Cited by 64
“Diagram of example SST configuration [18].”
BackgroundNew Bidirectional Intelligent Semiconductor Transformer for Smart Grid Application
Han, B.-M., Choi, N.-S., & Lee, J.-Y. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2284009 · Cited by 37
Zhao, H., Zhu, T., Cheng, D., Li, B., Ding, J., & Li, Y. (2017) · The Journal of Engineering · doi:10.1049/joe.2017.0656 · Cited by 19
Metadata
- Authors
- She, X., Burgos, R., Wang, G., Wang, F., & Huang, A. Q.
- Venue
- 2012 IEEE Energy Conversion Congress and Exposition (ECCE)
- Publisher
- IEEE
- Published
- 2012-09
- Pages
- 4077-4084
- OpenAlex
- W2068334467
- Cited by
- 241
- References
- 10
- FWCI
- 32.34
- Type
- conference paper
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.