Modelling and detection of bearing faults in Permanent Magnet Synchronous Motors
The DOI matches its Crossref record; 10 of the 10 references it cites were found in a registry or an index.
Abstract
This paper describes an electromechanical model for bearing fault modeling and detection in Permanent Magnet Synchronous Motors. Bearing problems are one major cause for drive failure. Their detection is possible by vibration monitoring of characteristic bearing frequencies. In the new approaches proposed in this work, the vibrations of the rotor shaft due to bearing failure are calculated by solving Hertz's equation contact numerically. This vibrations leads to load torque variations. The spectral analysis of the Park's vector modulus shows the possibility of the model to detect bearing faults.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Furthermore, it was shown that the bearing damage is also visible in the electromagnetic torque.”
From Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges (2022) · cites this paper as [141]
Citations
Cites
Condition Monitoring and Fault Diagnosis of Electrical Motors—A Review
Nandi, S., Toliyat, H. A., & Li, X. (2005) · IEEE Transactions on Energy Conversion · doi:10.1109/tec.2005.847955 · Cited by 2,382
Current Signature Analysis to Detect Induction Motor Faults
Thomson, W. T., & Fenger, M. (2001) · IEEE Industry Applications Magazine · doi:10.1109/2943.930988 · Cited by 1,139 · cited 1×
“For example authors in [2,3] show that faults in the stator winding due to insulation degradation are one of the main causes of induction machine failures.”
BackgroundModel for the vibration produced by a single point defect in a rolling element bearing
McFadden, P. D., & Smith, J. D. (1984) · Journal of Sound and Vibration · doi:10.1016/0022-460x(84)90595-9 · Cited by 931
Models for Bearing Damage Detection in Induction Motors Using Stator Current Monitoring
Blodt, M., Granjon, P., Raison, B., & Rostaing, G. (2008) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2008.917108 · Cited by 568
Condition monitoring and fault diagnosis of electrical machines-a review
Nandi, S., & Toliyat, H. A. (2003) · Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370) · doi:10.1109/ias.1999.799956 · Cited by 531 · cited 1×
“Note that the frequency corresponding to defects in inner, outer race and balls are given respectively by [4,5] : 1 cos( ) 2 r b i f N d f D α ⎡ ⎤ = + ⎢ ⎥ ⎣ ⎦ (12)”
BackgroundElectrical machines and drives : a space-vector theory approach
Vas, P. (1992) · Medical Entomology and Zoology · Cited by 418
An advanced Park's vectors approach for bearing fault detection
Zarei, J., & Poshtan, J. (2008) · Tribology International · doi:10.1016/j.triboint.2008.06.002 · Cited by 102
Stone, G., & Kapler, J. (1998) · IEEE Industry Applications Magazine · doi:10.1109/2943.715501 · Cited by 99 · cited 1×
“For example authors in [2,3] show that faults in the stator winding due to insulation degradation are one of the main causes of induction machine failures.”
BackgroundFault Detection and Protection of Induction Motors Using Sensors
Bayındır, R., Sefa, İ., Colak, ¿., & Bektas, A. (2008) · IEEE Transactions on Energy Conversion · doi:10.1109/tec.2008.921558 · Cited by 69
A review on fault diagnosis of induction machines
Verucchi, C., Acosta, G. G., & Benger, F. A. (2008) · Latin American Applied Research - An international journal · Cited by 44
Research works printed but not linked: 2
- harris, 2001, Bearing Analysis
- pinard, 2004, Commande e?lectronique des moteurs e?lectrique, Dunod, 10, 53
Cited by
Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges
Orlowska-Kowalska, T., Wolkiewicz, M., Pietrzak, P., Skowron, M., Ewert, P., Tarchala, G., Krzysztofiak, M., & Kowalski, C. T. (2022) · IEEE Access · doi:10.1109/access.2022.3180153 · Cited by 328
An Assessment on the Non-Invasive Methods for Condition Monitoring of Induction Motors
Irfan, M., Saad, N. B., Ibrahim, R., Asirvadam, V. S., Alwadie, A. S., & Sheikh, M. A. (2017) · InTech eBooks · doi:10.5772/67917 · Cited by 29
Santer, P., Reinhard, J., Schindler, A., & Graichen, K. (2025) · Mechatronics · doi:10.1016/j.mechatronics.2025.103294 · Cited by 22
Navarro-Navarro, Á., Ruiz-Sarrio, J. E., Biot-Monterde, V., Daviu, J. A. A., Becker, V., & Urschel, S. (2023) · Machines · doi:10.3390/machines11020288 · Cited by 17
“In the case of transient analysis, the use of Order Analysis (OA) allows analysis during dynamic states [78,82].”
MethodImpact of the load in the detection of bearing faults by using the stator current in PMSM's
Mbo'o, C. P., Herold, T., & Hameyer, K. (2014) · International Conference on Electrical Machines (ICEM) · doi:10.1109/icelmach.2014.6960399 · Cited by 13
Bearing Fault Detection in Induction Motors Using Line Currents
Sunder, M., Abishek, R., Sabarivelan, S., Maiti, M., & Bingi, K. (2021) · ECTI Transactions on Electrical Engineering Electronics and Communications · doi:10.37936/ecti-eec.2021192.244163 · Cited by 11
“Similarly, the detection of dynamic, static, and mixed eccentricity faults has also been achieved using Park’s vector analysis in [23], [24], and [25].”
MethodBoucenna, N. (2014) · theses.fr (ABES) · doi:10.70675/b279230bz999dz4188za287z1742b20b5a93 · Cited by 7
Aubert, B. (2014) · theses.fr (ABES) · doi:10.70675/60607a8ez3440z47b2z8eadz6e6d37265478 · Cited by 6
Modeling of a permanent-magnet excited synchronous machine with bearing damage
Mbo'o, C. P., & Hameyer, K. (2014) · Annual Conference of the IEEE Industrial Electronics Society (IECON) · doi:10.1109/iecon.2014.7049075 · Cited by 5
“Bearing damage can be modeled considering the vibrations due to the faults ( [4], [14]) or the induced torque pulsations ( [12], [13]).”
BackgroundRunning State Monitoring of Induction Motors Based on KPCA_RBF and Stator Current Characteristics
Song, X., Hu, Y., Dai, B., & Zheng, X. (2023) · IEEE Access · doi:10.1109/access.2023.3290150 · Cited by 3
Jayasena, K. N. C., Batkhishig, B., Nahid‐Mobarakeh, B., & Emadi, A. (2025) · IEEE International Symposium on Industrial Electronics (ISIE) · doi:10.1109/isie62713.2025.11124780 · Cited by 2
“Many of these critical applications require effective condition monitoring and fault diagnosis techniques to ensure their reliability, safety, and productivity while preventing any economic losses from downtime [2].”
Kalman-Cyclisation Dominant Frequency Based PMSM Bearing Fault Detection
Kumar, K., Vaiyapuri, V., & Nadarajan, S. (2025) · International Conference on Machine Intelligence and Smart Innovation (ICMISI) · doi:10.1109/icmisi65108.2025.11115434
“This approach measures the rotor shaft vibration using the numerical solution of Hertz's contact equation for detecting the bearing fault [4].”
Faiz, J., Mazaheri‐Tehrani, E., & Ebrahimi, B.-M. (2026) · Wiley eBooks · doi:10.1002/9781394425006.ch07
Metadata
- Authors
- Rezig, A., N'Diaye, A., Mekideche, M. R., & Djerdir, A.
- Affiliations
- University of Jijel (DZ)
- Université de technologie de belfort-montbéliard (FR)
- ORCID
- Venue
- 2012 XXth International Conference on Electrical Machines
- Publisher
- IEEE
- Published
- 2012-09
- Pages
- 1778-1782
- OpenAlex
- W2019856205
- Cited by
- 10
- References
- 10
- Citations by year
- 2025: 3 · 2023: 2 · 2022: 1 · 2021: 1 · 2017: 1 · 2014: 2
- FWCI
- 1.03
- Type
- conference paper
- Language
- en
- Open access
- closed
- Locations
- International Conference on Electrical Machines (ICEM) (publishedVersion)
- Topics
- Physical Sciences › Engineering › Control and Systems Engineering › Machine Fault Diagnosis Techniques
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electric Motor Design and Analysis
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Sensorless Control of Electric Motors
- Keywords
- bearing fault detection, permanent magnet synchronous motor, electromechanical model, rotor vibration, bearing characteristic frequencies, Hertz contact model, load torque variation, spectral analysis
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.