The DOI matches its Crossref record; 25 of the 25 references it cites were found in a registry or an index.
Conceptualization and Multiobjective Optimization of the Electric System of an Airborne Wind Turbine
Abstract
Airborne wind turbines (AWTs) represent a radically new and fascinating concept for future harnessing of wind power. This concept consists of realizing only the blades of a conventional wind turbine (CWT) in the form of a power kite flying at high speed perpendicular to the wind. On the kite are mounted a turbine, an electrical generator, and a power electronics converter. The electric power generated is transmitted via a medium voltage cable to the ground. Because of the high flight speed of the power kite, several times the actual wind speed, only a very small swept area of the turbine is required according to Betz's Law and/or a turbine of low weight for the generation of a given electric power. Moreover, because of the high turbine rotational speed, no gear transmission is necessary and the size of the generator is also reduced. For takeoff and landing of the power kite, the turbines act as propellers and the generators as motors, i.e., electric power is supplied so that the system can be maneuvered like a helicopter. In the present work, the configuration of power electronics converters for the implementation of a 100 kW AWT is considered. The major aspect here is the trade-off between power-to-weight ratio (W/kg) and efficiency. The dependence of cable weight and cable losses on the voltage level of power transmission is investigated, and a comparison is made between low voltage (LV) and medium voltage (MV) versions of generators. Furthermore, the interdependence of the weight and efficiency of a bidirectional dual active bridge dc-dc converter for coupling the rectified output voltage of a LV generator to the MV cable is discussed. On the basis of this discussion, the concept offering the best possible compromise of weight and efficiency in the power electronics system is selected and a model of the control behavior is derived for both the power flow directions. A control structure is then proposed and dimensioned. Furthermore, questions of electromagnetic compatibility and electrical safety are treated. In conclusion, the essential results of this paper are summarized, and an outlook on future research is given. To enable the reader to make simplified calculations and a comparison of a CWT with an AWT, the aerodynamic fundamentals of both the systems are summarized in highly simplified form in an Appendix, and numerical values are given for the 100 kW system discussed in this paper.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Performance characterization of a high-power dual active bridge DC-to-DC converter
Kheraluwala, M. N., Gascoigne, R. W., Divan, D. M., & Baumann, E. D. (1992) · IEEE Transactions on Industry Applications · doi:10.1109/28.175280 · Cited by 1,496 · cited 2×
“Here, the conventional modulation scheme described in [27], often referred to as phase shift modulation, leads to the highest converter efficiency [28].”
Efficiency-Optimized High-Current Dual Active Bridge Converter for Automotive Applications
Krismer, F., & Kolar, J. W. (2012) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2011.2112312 · Cited by 747 · cited 2×
“Since IL causes copper losses in the transformer and inductor windings and conduction losses in all semiconductors [30], a maximum phase angle of π/4 is selected in order to achieve low losses.”
Self-citationSmall-Signal Methods for AC Distributed Power Systems–A Review
Sun, J. (2009) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2009.2029859 · Cited by 712 · cited 1×
“Furthermore, there exist close couplings of this subject to current questions in the area of More Electric Aircraft [12] and Smart Grids [13]—the power electronics system of the AWT can be regarded as a Smart Pico Grid— or in general to the multiobjective optimization of converter systems [14], [15].”
Synthesis of high performance PM motors with concentrated windings
Cros, J., & Viarouge, P. (2002) · IEEE Transactions on Energy Conversion · doi:10.1109/tec.2002.1009476 · Cited by 667 · cited 1×
“The investigated machines use concentrated windings, which, despite a lower winding factor due to shorter end windings, generally have lower copper losses compared to motors with distributed windings [22].”
Closed Form Solution for Minimum Conduction Loss Modulation of DAB Converters
Krismer, F., & Kolar, J. W. (2012) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2011.2157976 · Cited by 635 · cited 1×
“The phase shift φ between vac1 and vac2 controls the output power of the DAB [27], [29]”
Self-citationFuture electronic power distribution systems a contemplative view
Boroyevich, D., Cvetkovic, I., Dong, D., Burgos, R., Wang, F., & Lee, F. (2010) · 2010 12th International Conference on Optimization of Electrical and Electronic Equipment · doi:10.1109/optim.2010.5510477 · Cited by 585 · cited 1×
“Furthermore, there exist close couplings of this subject to current questions in the area of More Electric Aircraft [12] and Smart Grids [13]—the power electronics system of the AWT can be regarded as a Smart Pico Grid— or in general to the multiobjective optimization of converter systems [14], [15].”
Crosswind kite power (for large-scale wind power production)
Loyd, M. L. (1980) · Journal of Energy · doi:10.2514/3.48021 · Cited by 545
Krismer, F., & Kolar, J. W. (2010) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2009.2025284 · Cited by 470 · cited 3×
“b) Switching losses (from [32]): The switching losses of the full bridge and the NPC converter are calculated based on measurement values, according to [31].”
Self-citationModeling and optimization of bidirectional dual active bridge DC-DC converter topologies
Krismer, F. (2010) · Repository for Publications and Research Data (ETH Zurich) · doi:10.3929/ethz-a-006395373 · Cited by 230
Self-citationToward an improved understanding of thruster dynamics for underwater vehicles
Healey, A. J., Rock, S. M., Cody, S., Miles, D., & Brown, J. P. (1995) · IEEE Journal of Oceanic Engineering · doi:10.1109/48.468242 · Cited by 206
Research works printed but not linked: 12
- 2011, Response to the Federal Aviation Authority?Notification for Airborne Wind Energy Systems (AWES)
- 2013, Sky WindPower
- 2013, Makani Power
- 2013, Cortland Cable
- murtola, 2005, Hyperelastic high voltage conductor for electric drilling, Proc 4th Int Conf CMOO, 1
- 2011, Radox GKW Cables
- 2013, SwissKitePower
- 2013, Joby Energy
- 2013, Kite Gen
- betz, 1926, Windenergie und Ihre Ausnutzung in Windmu?hlen
- 2005, AWG Tabelle
- drofenik, 2005, Theoretical converter power density limits for forced convection cooling, Proc 26th Eur PCIM, 1
Cited by
Hannan, M. A., Ker, P. J., Lipu, M. S. H., Choi, Z. H., Rahman, M. S. A., Muttaqi, K. M., & Blaabjerg, F. (2020) · IEEE Access · doi:10.1109/access.2020.2967345 · Cited by 339
Metaheuristic Optimization Methods Applied to Power Converters: A Review
De León-Aldaco, S. E., Calleja, H., & Aguayo Alquicira, J. (2015) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2015.2397311 · Cited by 217
“With the purpose of solving the conflicts, these cases can be formulated as multiobjective optimization problems [6].”
BackgroundBurkart, R. M., & Kolar, J. W. (2016) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2016.2614139 · Cited by 154
Self-citationOn-Board Chargers for High-Voltage Electric Vehicle Powertrains: Future Trends and Challenges
Pradhan, R., Keshmiri, N., & Emadi, A. (2023) · IEEE Open Journal of Power Electronics · doi:10.1109/ojpel.2023.3251992 · Cited by 142
“The intended use of this converter is in weight-sensitive aircraft applications with an 8 kV bus created using 4 serialized converters [106].”
MethodGammeter, C., Krismer, F., & Kolar, J. W. (2016) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2015.2459378 · Cited by 105
“1) Semiconductors: Highly efficient power converters, and converters operated at high temperatures [1], [12]–[16].”
BackgroundMethodSelf-citation
Metadata
- Authors
- Kolar, J. W., Friedli, T., Krismer, F., Looser, A., Schweizer, M., Friedemann, R. A., Steimer, P. K., & Bevirt, J. B.
- Affiliations
- ETH Zurich (CH)
- ABB (Switzerland) (CH)
- Joby Energy, Santa Cruz, CA, USA
- Venue
- IEEE Journal of Emerging and Selected Topics in Power Electronics
- Published
- 2013-06
- Volume
- 1
- Issue
- 2
- Pages
- 73-103
- ISSN
- 2168-6777 (ISSN-L)
- 2168-6785
- OpenAlex
- W2149475628
- Cited by
- 74
- References
- 25
- Citations by year
- 2026: 2 · 2025: 2 · 2024: 9 · 2023: 4 · 2022: 2 · 2021: 3 · 2020: 4 · 2019: 3 · 2018: 4 · 2017: 10 · 2016: 16 · 2015: 8 · 2014: 5 · 2013: 1
- FWCI
- 16.09
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- Locations
- IEEE Journal of Emerging and Selected Topics in Power Electronics (publishedVersion)
- Topics
- Physical Sciences › Engineering › Aerospace Engineering › Aerospace Engineering and Energy Systems
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Wind Turbine Control Systems
- Keywords
- power converters, DC-DC converter, specific power, power flow control, electromagnetic compatibility, electrical safety, multi-objective optimization
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Conceptualization and Multiobjective Optimization of the Electric System of an Airborne Wind Turbine. https://app.cochat.ai/papers/10.1109/jestpe.2013.2269672
- The paper
- Kolar, J. W., Friedli, T., Krismer, F., Looser, A., Schweizer, M., Friedemann, R. A., Steimer, P. K., & Bevirt, J. B. (2013). Conceptualization and Multiobjective Optimization of the Electric System of an Airborne Wind Turbine. IEEE Journal of Emerging and Selected Topics in Power Electronics. https://doi.org/10.1109/jestpe.2013.2269672
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.